GE Goog 411 - Dect 6.0 Digital Dual Keypad Support and Manuals
Get Help and Manuals for this General Electric item
Most Recent GE Goog 411 Questions
Como Programarlo Por Primera Vez
(Posted by nahomy123sanchez 2 years ago)
Cannot Get It To Stop Blinking. (for Over A Year)
our cordless (2) phones blink constantly for over a year. I have tried to change batteries etc. It s...
our cordless (2) phones blink constantly for over a year. I have tried to change batteries etc. It s...
(Posted by nonarick 10 years ago)
Answering Machine Time Limit
How to set a time limit for a caller leaving a message.
How to set a time limit for a caller leaving a message.
(Posted by hope4themissing 11 years ago)
I Cannot Get My Phone To Ring.
I cannot get my phone to ring. I can call out but cannot hear incoming calls. I put in new batteries...
I cannot get my phone to ring. I can call out but cannot hear incoming calls. I put in new batteries...
(Posted by rcbill320 11 years ago)
I Have Ge Model 27881g2a How Do I Turn The Ringer On?
(Posted by valerie1955 12 years ago)
Popular GE Goog 411 Manual Pages
User Guide - Page 3
... company must: (1) promptly notify you of such temporary discontinuance; (2) afford you the opportunity to Part 15 of the FCC Rules. Interference Information
This device complies with the instructions, may cause harmful interference to procedures set forth in a particular installation. This equipment has been tested and found to comply with FCC Rules and Regulations.
If...
User Guide - Page 7
... in your package, it replaces one phone in your home goes out. For Model 28213xx2 there will be ONE additional handset, charge cradle, belt clip, battery pack and cover than shown above.
Before You Begin
Parts Checklist (for future reference. IMPORTANT: Because cordless phones operate on electricity, you should always be followed. For Model 28213xx3 there will be...
User Guide - Page 8
... communication, and, if not properly set channels to avoid interference.
Telephone Jack Requirements
To use this phone, you need an RJ11C type modular
Wall plate
telephone jack, which might look like the one installed. Typical devices that may use the 1.9GHz DECT frequency for these appliances. INSTALLATION NOTE: Some cordless telephones operate at frequencies that...
User Guide - Page 15
...to 6 handsets by purchase of optional Model 28203 handset with recharge cradle), handsets... from the receiving handset. Make sure your phone is selected, then the screen displays SET ALARM TIME. The screen displays ON > ...OFF. 5. The receiving handset will turn on the microphone and the originating handset will turn on the cradle. NOTE: Press the END...
User Guide - Page 16
... Code, Tone/Pulse, Language, Auto Talk, Registration, Deregistration. Press mute/menu OK button to INITIAL SETUP....From the Initial Setup Menu:
1.
For example, to save your phone is stored in ...END button at a time.
4. Press the caller ID-volume (5 or 6) button to scroll to the HANDSET NAME sub-menu.
2. Use the touch-tone pad to enter a name (up to confirm your selection and advance SET...
User Guide - Page 17
... display. Press mute/menu OK button to confirm. Language
From the Initial Setup Menu:
1. Area Code
From the Initial Setup Menu:
1. Use the touch-tone pad to enter the menu. You will hear a confirmation tone and your selection. The screen displays SET AREA CODE - - - .
3.
Press mute/menu OK button to enter your selection. The default...
User Guide - Page 18
... the
default setting. 4. If you must go to use indicator flashes. From the Initial Setup Menu: 1. The handset screen displays REGISTERED. Press the caller ID-volume (5 or 6) button to scroll to the REGISTRATION
sub-menu. 2. Press the caller ID-volume (5 or 6) button to scroll to the AUTO TALK sub-menu. 2. To end a call...
User Guide - Page 21
... save your phone is OFF (not in the display. Press the mute/menu OK button to enter the menu.
Press caller ID-volume (5 or 6) button to scroll to the KEY TONE sub-menu. 2. The screen displays 4 RING
VOLUME 5. 3. LEVEL 5 is the default
setting. 4. You will hear a
confirmation tone and the new volume setting shows...
User Guide - Page 24
...phone is the traditional way as described in the cradle while the handset is automatically disconnected. Press #pause/ringer button again to set the ringer volume.
Ringer Volume (Shortcut)
There are two ways to save and display the new selection for a few
seconds.
24 When finished, press END... Volume menus.
Sound Setup; The other one is
the default setting. 4. LEVEL 5 is this...
User Guide - Page 25
...subscribe to the combined Call Waiting Caller ID service from the last three numbers that were dialed. 4.
Press the redial/format button.
-OR-
3. Press the caller ID-volume (5) to review the oldest call and scroll to the waiting... the caller ID-volume (5 or 6) button to 20 digits long. During a phone call, you dialed:
1.
Press the TALK/SPEAKER button. The number dials automatically.
User Guide - Page 30
... . To know who is calling while you are using the GE multi handset system, a beep indicates the presence of all handsets in the system. • When you subscribe to Call Waiting Caller ID Service. This unit receives and displays information transmitted by your phone company; Call Waiting Caller ID
Provided you hear the...
User Guide - Page 37
DELETE CALL ID? END OF LIST
Indicates that there is excessively noisy.
HANDSET NEEDS REGISTRATION
Indicates you must register a non-registered handset prior to CID service, or CID service is from a long distance call . INCOMPLETE DATA
LINE IN USE LONG DISTANCE
Caller information is interrupted during transmission or the phone line is no CID information...
User Guide - Page 38
... replacing the battery. • Make sure that an invalid message has been sent from service provider.
NEW VOICE MAIL
Indicates voice mail has not been retrieved from the telephone company.
38 ROOM MONITORING.... SPKR
Indicates the handset is established.
Caller ID Error Message • This message indicates either the presence of new CID records not reviewed. NEW...
User Guide - Page 42
... Inc. This information will be valuable if service should be required during the warranty period. Warranty Assistance
If trouble is resolved. Manager, Consumer Relations P O Box 1976 Indianapolis, IN 46206 Attach your sales receipt to the warranty included in this product. For instructions on how to obtain a replacement unit, refer to this product was purchased...
User Guide - Page 43
... warranty does not cover:
• Customer instruction. (Your Owner's Manual provides information regarding operating instructions and user controls. For rental firms, proof...provided with a new unit.
accepts no liability in materials or workmanship. Any additional information, should be obtained from your dealer.)
• Installation and setup service adjustments. •...
GE Goog 411 Reviews
We have not received any reviews for GE yet.