GE 60-774 - Security SuperBus 2000 8-Zone Input Module Support and Manuals
Get Help and Manuals for this General Electric item
Popular GE 60-774 Manual Pages
Installation Instructions - Page 1
... the chance of -line (EOL) resistors. Wiring Terminals
Used for installing a magnet and reed switch that can be wired to detect cover removal. UltraGard® panels can be set manually with DIP switches.
Green POWER LED
Indicates module power status. Both normally open /short circuit.
6XSHU%XVŠ = ,QSXW 0RGXOH
ITI Part No. 60-774
Document Number: 466-1606 Rev...
Installation Instructions - Page 2
... powered devices with included screws.
2 R Always install the EOL resistor at the last sensor or device on the circuit, not at the zone input terminals. Installation Guidelines
Installation Guidelines
R For the maximum number of bus devices and touchpads per panel see specific panel Installation Instructions). For normally open circuits, wire the resistor in parallel.
R Maximum current...
Installation Instructions - Page 3
....DSF
PANEL CABINET (COVER NOT SHOWN)
DETAIL
SUPPORT STANDOFF (Included with panel) into the panel circuit board. Support Standoff
4. Remove the module cover and set it aside (Figure 2).
3. Secure the ...receiver module, but if a receiver module is not being used, the mounting clips may be used for the 8 Zone Input Module.
5. Mounting the Module in an Advent Cabinet
1. Remove AC panel...
Installation Instructions - Page 4
... 8 ZONE COMMON ZONE 7 ZONE 6 ZONE COMMON ZONE 5 ZONE 4 ZONE COMMON ZONE 3 ZONE 2 ZONE COMMON ZONE 1
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
TO PANEL
TO ZONE SUPERBUS TERMINALS
INPUT
OR CONNECTOR
DEVICE
(SEE TABLE)
(SHARED COMMONS)
9712G03A.DSF
Figure 7. t
For Advent UL-864 Listed Installations, all inputs must be dedicated to the module. Figure 8 shows an example of wire used only...
Installation Instructions - Page 5
... listed 1/4-inch press-fit reed switch on - To install the tamper reed switch (Figure 9):
1. Installing the Reed Switch
On Concord (software versions 1.0-1.6) and UltraGard Panels
Locate the DIP switches on the module circuit board (Figure 1) and set switch 1 to "M" (on the module back-plate and wire the switch to one of the back-plate (see...
Installation Instructions - Page 6
Connect the panel backup battery(s) and restore panel AC power. Existing Installations
Concord Panels- Enter your Install Code (default 0123).
6. Both the green and red LEDs turn on the panel AC power.
5.
Verify nonconflicting bus device unit number settings.
3. Connect the panel backup battery and restore panel AC power.
4. Set the UltraGard panel RUN/PROGRAM switch to the Main ...
Installation Instructions - Page 7
... specific panel Installation Instructions).
5. Troubleshooting
Table 6 describes what to the panel Installation Instructions for bus devices with the panel. Check for incorrect wiring connections.
3. Re-initialize the panel by entering program mode (see specific panel Installation Instructions).
2.
Remove zones and try installing the module without the zones.
6. Replace the...
Installation Instructions - Page 8
...accordance with the instruction manual, may cause harmful interference to radio communications. R Increase the separation between the equipment and receiver. These limits are trademarks of Interlogix, Inc.
8 R Connect the affected equipment and the panel receiver to operate the equipment. can be required to correct the interference at their own expense.
FCC Part 15 Class A This...
GE 60-774 Reviews
We have not received any reviews for GE yet.