GE 60-770 - Security SuperBus 2000 4-Zone Output Module Support and Manuals
Get Help and Manuals for this General Electric item
Popular GE 60-770 Manual Pages
Installation Instructions - Page 1
... include:
u Turning on exit lights during a burglary alarm.
When the panel is provided by the panel. SuperBus® 2000 4-Relay Output Module
ITI Part No. 60-770
Document Number: 466-1608 Rev. Examples of 32 output points.
UltraGard® and Concord™ panels can be expanded to the module. For additional security, the plastic case accommodates a magnetic reed switch to...
Installation Instructions - Page 2
...the maximum wire length from the panel to the module (see specific panel Installation Instructions). UltraGard
22 ga. 500 ft./18 ga. 1000 ft.
Tools and Supplies Needed
The relay output module can be mounted ...reed switch and magnet (not included) for cover tamper
u 1/4-inch #6-32 self tapping screws (not included) for Advent cabinet mounting
u Support standoff (included with an Advent panel,...
Installation Instructions - Page 3
... SELF TAPPING
SCREWS
MOUNTED MODULE
ROOM FOR 3RD
9712G11A.DSF
MODULE
Figure 4.
SUPPORT STANDOFF
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
MAGNET CLIP
REED SWITCH HOLDER
9710G02B.DSF
Figure 3. Remove panel AC power and disconnect the backup battery(s).
2. Turn the module upside down and line up and onto the cabinet side tab...
Installation Instructions - Page 4
... 7 and 8. TO ZONE 1 INPUT DEVICE(S) TO PANEL SUPERBUS TERMINALS OR CONNECTOR (SEE TABLE)
TO OUTPUT 4 DEVICE
TO OUTPUT 3 DEVICE
TO OUTPUT 2 DEVICE
TO OUTPUT 1 DEVICE
1. SUPPLY GND (COMMON)
9710G03A.DSF
Figure 7.
Turn off (or disconnect) the panel power and disconnect the panel backup battery(s).
2. For specific wiring details, see the panel Installation Instructions.
3. Wire the module...
Installation Instructions - Page 5
... 5. Zone Input Wire Runs
Gauge
Max. INPUT)
**
2K OHM 1/2 W
(TYPICAL)
LED
Installing a Cover Tamper Switch
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
NORMALLY CLOSED (N/C)
CONTACTS IN SERIES
< OR >
NORMALLY OPEN (N/O)
CONTACTS IN PARALLEL
* DO NOT EXCEED RELAY CONTACT VOLTAGE AND CURRENT RATINGS
** DO NOT EXCEED PANEL +12V POWER CONSUMPTION LIMITS (SEE PANEL INSTALLATION INSTRUCTIONS...
Installation Instructions - Page 6
... Panels
Note Concord panels with unit numbers set from 0 to the module ZONE 1 (17) and ZONE COMMON (18) terminals (Figure 9).
Connect the panel battery(s) and restore panel AC power. Both the green and red LEDs will only recognize 4-Relay Output modules with software versions 1.0-1.6 will turn on the module back-plate.
2. Existing Installations
Concord Panels- Insert the reed switch...
Installation Instructions - Page 7
... nonconflicting bus unit number settings.
3.
LED stays off , replace the module.
Press 0 for incorrect wiring con-
Set the UltraGard panel RUN/PROGRAM switch to module problems.
Table 6: Troubleshooting
Problem
Solution
The green POWER 1.
Re-initialize the panel by entering program mode (see specific panel Installation Instructions).
4. Replace the module.
Press...
Installation Instructions - Page 8
... the interference by turning the equipment off and on different branch circuits. Specifications
Specifications
Notices
Compatibility:
Advent, Concord, and UltraGard
Power Requirements: 12V nominal, 12 mA typical (idle), 180 mA maximum (all relays energized)
Inputs:
One supervised, fire-rated, hardwire zone
Outputs:
Four, panel programmable outputs with the instructions, may cause...
GE 60-770 Reviews
We have not received any reviews for GE yet.