Garmin OnDeck Hub Support and Manuals
Get Help and Manuals for this Garmin item
View All Support Options Below
Free Garmin OnDeck Hub manuals!
Problems with Garmin OnDeck Hub?
Ask a Question
Free Garmin OnDeck Hub manuals!
Problems with Garmin OnDeck Hub?
Ask a Question
Popular Garmin OnDeck Hub Manual Pages
Important Safety and Product Information - Page 2
...part thereof or create any user-serviceable parts...installation. To comply with any device that may cause undesired operation. Unauthorized repairs or modifications could result in permanent damage to the equipment, and void your warranty and your local waste disposal department to dispose of the device/batteries in accordance with the instructions. Garmin... non-user-replaceable battery. &#...
Installation Instructions - Page 1
... notices could result in the product specifications. If it is not exposed to install the device. To prevent the possibility of all personal data and resets default settings
STATUS
Indicates device status
CELL
Indicates cell operation
POWER
Power cable connection
NMEA 2000
NMEA 2000® network
NETWORK
Garmin Marine Network
IN/OUT
Connects relays...
Installation Instructions - Page 2
...degrees to Power
WARNING When connecting the power cable, do not remove the in the product specifications. Over tightening the nut could cause damage to the device. 6 Place the cover over ... drilling the pilot holes, use heat-shrink type butt connectors or other Garmin devices, you should observe these steps to install the second antenna.
1 Route the power cable between the power source and...
Installation Instructions - Page 3
...install the proper plug type for up the sensor in the ActiveCaptain® app. You must be made using proper electrical connectors. 8 in. (20.3 cm) Battery 8 in. (20.3 cm) 36 ft. (11 m) maximum extension
Connection Diagram
Garmin chartplotter connected to shore power. Extra caution must set...sensor to an AC outlet that allows the two parts of the security sensor should be alerted when the...
Installation Instructions - Page 4
... Wi‑Fi® network and updating the software from a connected Garmin chartplotter.
1 Connect the white/violet...You must set up the relay switches in -Use input so that the two parts align when... for the relay type being switched, you must install this relay switch in step 3. NOTE: The ... NOTE: You must set up the sensor in the specifications for purchase at garmin.com. Must be ...
Installation Instructions - Page 5
... can create a basic one set of the GTB 10 black box device's power source. Must be used in a dry location. This relay is ever intended to this relay switch in installations where the existing NMEA 2000 network manufacturer is connected to Garmin Marine Network devices. Garmin Marine Network Considerations
NOTICE A Garmin Marine Network PoE Isolation...
Installation Instructions - Page 6
... to 140°F)
Input voltage
100 to 240 Vac
Output
5 Vdc
Installation location
Max. 85% humidity, non-condensing environments
Temperature Sensor Specifications Operating temperature range From -50° to 105°C (from -58..., blue Positive load wire, yellow
GTB 10 black box device NMEA 2000 compatible Garmin device Ignition or in-line switch NMEA 2000 power cable NMEA 2000 drop cable ...
Installation Instructions - Page 7
..., dynamic Fluid level Battery status Water speed Water depth Position: Rapid update COG and SOG: Rapid update GNSS position data GNSS DOPs GNSS satellites in view Wind data Environmental ...Garmin Ltd. or its subsidiaries.
NMEA 2000® and the NMEA 2000 logo are strictly prohibited for data communications.
Flashing red
The device has encountered an error and must not be installed...
Garmin OnDeck Hub Reviews
We have not received any reviews for Garmin yet.