Installation Instructions
Page 4
..., heat the connector to shrink it and provide a water resistant fit. Garmin provides a rubber cable grommet to the pedestal using . Slide the antenna onto the pedestal. The 8 mm bolts should be extended, follow the recommendations in the wire gauge table. 26 ft. 2 in (6 lbf-ft) (.81 kgf-m). Align the...power source. • For optimal performance, connect the voltage converter housing to drill a 1 1/4 in. (31.7 mm) hole for the GMR 1204 and GMR 1206). • You must connect the converter to the radar. Remove the protective cover from other cables, such as radio antenna lines or ...
..., heat the connector to shrink it and provide a water resistant fit. Garmin provides a rubber cable grommet to the pedestal using . Slide the antenna onto the pedestal. The 8 mm bolts should be extended, follow the recommendations in the wire gauge table. 26 ft. 2 in (6 lbf-ft) (.81 kgf-m). Align the...power source. • For optimal performance, connect the voltage converter housing to drill a 1 1/4 in. (31.7 mm) hole for the GMR 1204 and GMR 1206). • You must connect the converter to the radar. Remove the protective cover from other cables, such as radio antenna lines or ...
Installation Instructions
Page 8
...White/Blue Green Orange White/Brown White/Brown Brown Brown Position 8 Position 1 NOTE: The Garmin Marine Network requires cross-over the jacket and trim to approximately 9/16 in. (14 mm...5/8" back from the cable-connection housing and slide it to avoid damaging the copper tape. GMR 600/1200 Series Installation Instructions Wrap the supplied copper tape around cable as close to ensure a ... jacket edge. • Place the drain wire on the jacket. Be careful not to the table shown above. Remove the strain-relief nut from the trimmed end of the cable in proper order...
...White/Blue Green Orange White/Brown White/Brown Brown Brown Position 8 Position 1 NOTE: The Garmin Marine Network requires cross-over the jacket and trim to approximately 9/16 in. (14 mm...5/8" back from the cable-connection housing and slide it to avoid damaging the copper tape. GMR 600/1200 Series Installation Instructions Wrap the supplied copper tape around cable as close to ensure a ... jacket edge. • Place the drain wire on the jacket. Be careful not to the table shown above. Remove the strain-relief nut from the trimmed end of the cable in proper order...