Garmin GMR 604 Open Array Antenna xHD Support and Manuals
Get Help and Manuals for this Garmin item
View All Support Options Below
Free Garmin GMR 604 Open Array Antenna xHD manuals!
Problems with Garmin GMR 604 Open Array Antenna xHD?
Ask a Question
Free Garmin GMR 604 Open Array Antenna xHD manuals!
Problems with Garmin GMR 604 Open Array Antenna xHD?
Ask a Question
Popular Garmin GMR 604 Open Array Antenna xHD Manual Pages
Installation Instructions - Page 1
... part of the radar and withstand any questions while installing your GMR 400/600/1200 xHD radar according to http://my.garmin.com. Product Registration
Help us better support you experience difficulty installing the chartplotter, seek the assistance of the drilling or cutting surface. GMR™ 400/600/1200 xHD Radar Installation Instructions
Properly install your GMR 400/600/1200 xHD...
Installation Instructions - Page 2
...increased to 7 ft. (2 m).
2
GMR 400/600/1200 xHD Installation Instructions GPS antennas should be located above the keel line of the ship with a minimal part of the structure or rigging blocking the radar... any inertial forces, as flat as possible, and parallel with the water line. • Garmin recommends mounting the radar out of range of personnel (vertical beam width above and below the...
Installation Instructions - Page 3
...7. Ensure that was selected. The M10 nuts should be set to 180° (Figure 4). Apply the included anti-...Garmin compatible Furuno® or Raymarine® mount.) Determine a suitable mounting location
and tape the Mounting Template in Figure 5. Waveguide protective cover
Bearing Offset = 0°
Bow Stern
Bearing Offset = 180° Figure 4
GMR 400/600/1200 xHD Installation Instructions...
Installation Instructions - Page 4
... are extended, use the appropriate tie-wraps, fasteners, and sealant to secure the cable along a route and through a 15 A slow-blow fuse. • Garmin recommends that the antenna wave guide is needed (see page 8).
4
GMR 400/600/1200 xHD Installation Instructions Secure the antenna to cover the cable installation hole. ◦◦ The grommet does NOT provide a waterproof seal.
Installation Instructions - Page 5
... power connector. and 1206)
To RF ground
Power Wiring Diagram
GMR 400/600/1200 xHD Installation Instructions
5 To install the cable assembly: 1.
Press the 2-pin
power cable to ...Install the hatch on the power cable to shrink the housing for the GMR 1204
- After crimping the connections, heat the connectors to the power connector.
GMR 400/600/1200 xHD radar
To water ground
Garmin...
Installation Instructions - Page 6
..., radar, a GMS 10, etc.), attach the RJ-45 marine network cable to an open RJ-45
socket on the back of the expanded network must be installed according to the appropriate installation instructions.
6
GMR 400/600/1200 xHD Installation Instructions These diagrams only show how a GMR 404/406 radar interacts with a network and do not show the network connections...
Installation Instructions - Page 7
... stern
GMR 400/600/1200 xHD Installation Instructions
7 Highlight the Front of Boat Offset. After an offset is more than +/- 1°, further correct the Front of Boat Offset slider, and press ENTER. 4.
If the bearing deviation is determined, press ENTER to save, and press QUIT to return to open the setup page. 2.
Entering the Radar Antenna Size...
Installation Instructions - Page 8
...
Green
Orange
White/Brown
White/Brown
Brown
Brown
Position 8 Position 1
NOTE: The Garmin Marine Network requires cross-over the jacket and trim to approximately 9/16 in. (14... connection.
• Trim the wire ends to avoid damaging the copper tape.
8
GMR 400/600/1200 xHD Installation Instructions When constructing a custom cable from the ends to the table shown above. Be careful...
Installation Instructions - Page 9
...Be careful not to verify proper order before continuing. Install the O-ring onto the housing.
Using an AMP Modular Plug Hand Tool and Die Set (or compatible equivalent), crimp the plug onto the ...the plug and rearrange the wires.
2. Installing the Network Connector
1. O-Ring
GMR 400/600/1200 xHD Installation Instructions
9 If any wires are not in the cable-connection housing.
Installation Instructions - Page 11
...: Anti-jamming algorithm Clutter suppression: Sea clutter and rain clutter
4 ft Open-Array Antenna
Type: End-fed slotted waveguide Horizontal Beamwidth: 1.8 degrees Horizontal Sidelobes:
-...Antenna Gain: 30 dB
Polarization: Horizontal
Input Return Loss: Better than -20 dB Weight: 12.2 lb. (5.53 kg)
6 ft. Radar/Chart Overlay: Overlay mode is required)
GMR 400/600/1200 xHD Installation Instructions...
Installation Instructions - Page 12
...facilitate, not to replace, the use the GMR 400/600/1200 xHD radar on inland...Compliance
The GMR 400/600/1200 xHD radar complies with Part 80 of Conformity, see the Garmin Web site...instructions, may damage your Garmin product: www.garmin.com.
12
GMR 400/600/1200 xHD Installation Instructions Warnings
Failure to avoid the following measures:
• Reorient or relocate the receiving antenna...
Installation Instructions - Page 13
... distributor provides local service for your local Garmin authorized dealer or call Garmin Product Support for units purchased outside the UK) 0808.2380000 (within the UK) Fax +44 (0) 870.8501251
Garmin Corporation No. 68, Jangshu 2nd Road, Sijhih, Taipei County, Taiwan Tel. 886/2.2642.9199 Fax 886/2.2642.9099
GMR 400/600/1200 xHD Installation Instructions
13 To obtain...
Installation Instructions - Page 14
... strictly prohibited. Liberty House, Hounsdown Business Park, Southampton, Hampshire, SO40 9LR UK
Garmin Corporation No. 68, Jangshu 2nd Road, Sijhih, Taipei County, Taiwan
www.garmin.com
Part Number 190-01266-02 Rev. Garmin hereby grants permission to download a single copy of this manual onto a hard drive or other electronic storage medium to be viewed and...
Garmin GMR 604 Open Array Antenna xHD Reviews
We have not received any reviews for Garmin yet.