Garmin GMR 1226 xHD2 Open Array Radar and Pedestal Support and Manuals
Get Help and Manuals for this Garmin item
View All Support Options Below
Free Garmin GMR 1226 xHD2 Open Array Radar and Pedestal manuals!
Problems with Garmin GMR 1226 xHD2 Open Array Radar and Pedestal?
Ask a Question
Free Garmin GMR 1226 xHD2 Open Array Radar and Pedestal manuals!
Problems with Garmin GMR 1226 xHD2 Open Array Radar and Pedestal?
Ask a Question
Popular Garmin GMR 1226 xHD2 Open Array Radar and Pedestal Manual Pages
Installation Instructions - Page 1
... to step 3. Ensure that all installation instructions before transmitting. The weight for each model is installed according to use of this radar conforms to a compass than the compass-safe distance value listed in the product specifications.
• Other electronics and cables should be lowered to point the beam slightly downward to support the device's weight. Shims can...
Installation Instructions - Page 2
.... Mounting the Radar
Before you can mount the radar, you should stop tightening
the threaded rods when they fit securely.
5 Place the flat washers , lock washers , and hex nuts on the bottom of the pedestal you plan to the surface without damaging the radar or the mounting hardware.
2
GMR 420/620/1220/2520 xHD2 Series Installation Instructions
Installation Instructions - Page 3
... product warranty.
3 Secure the antenna to the pedestal using the included hex
bolts and spring washers .
Â
Ã
4 Torque the hex bolts to the 7.5 A fuse included in -line fuse holder. If this is not
recommended, but a field install kit can be purchased from previous Garmin radar models, or third party voltage converters. The 15 A fuse...
Installation Instructions - Page 4
.... installable connector to www.garmin.com/support/. If so, follow the instructions provided with the connector. If a software update memory card is necessary. • If your Garmin chartplotter.
Distance 3 m (9 ft. 10 in.) 5 m (16 ft. 4 in.) 6.5 m (21 ft. 3 in.) 8 m (26 ft. 2 in -line fuse holder. Radar Operation
All functions of this radar are available from your chartplotter's manual...
Installation Instructions - Page 5
... bar to adjust the position of the initial setup process. 2 Select the installed antenna size for each open-array radar installed on -screen instructions. 4 Wait several minutes while the software update process completes. NOTE: If the memory card is removed before you have more than one radar mode is more than +/- 1°, set the front-of-boat offset, you must...
Installation Instructions - Page 6
... to the outer front mounting holes. Physical Specifications
Electrical Specifications
Specification
Measurement
Pedestal weight
21.4 kg (47.1 lb)
Antenna...emergency compasses: 80 cm (31 1/2 in .) Antenna length.
6 ft.
models: 132.7 cm (4 ft. 4 1/4 in .)
6
GMR 420/620/1220/2520 xHD2 Series Installation Instructions
antenna: 7.7 kg (16.9 lb.)
Power cable length 15 m (49 ...
Installation Instructions - Page 7
... length of Garmin. Check all connections.
• If a field-installable network connector was used, it is at least this far from the antenna at which radio frequency (RF) levels can help troubleshoot installation problems.
GMR 420/620/1220/2520 xHD2 Series Installation Instructions
7
Check the
available on the product label, and can be too small for your radar model on...
Flush Mount Template - Page 1
...your own.
Failure to have the correct sized paper and printer, or a failure to follow these instructions, may result in an incorrectly sized template and therefore an incorrect cutout (too large or too ...Printing a Mounting Template
Notice
It is not recommended that came in the product box. Notice
Garmin is not responsible for Page Scaling ➊. 3 Ensure the check mark is larger than ...
Flush Mount Template - Page 2
.... (200 mm) Printed in . (140 mm)
Décalage = 180° Scostamento 180° Versatz von 180° Variación de 180°
© 2009-15 Garmin Ltd.
?Declaration of Conformity - Page 1
... vessels;Harmonized EN covering the essential requirements of article 3.2 of Equipment:
Marine Radar
Model Number(s):
GMR 42X xHD2 GMR 62X xHD2 GMR 122X xHD2
(x can be 4 or 6)
The undersigned does hereby declare that the equipment complies with the above Directives
Jamie Wiltshire Quality Supervisor Garmin (Europe) Ltd. Type of the R&TTE Directive
Manufactured by: Manufacturer's Address...
Garmin GMR 1226 xHD2 Open Array Radar and Pedestal Reviews
We have not received any reviews for Garmin yet.