Manual/User Guide
Page 3
...frame to touch parts (cover and base) other than parts to Signal Ground (SG). The mounting frame is connected to which the HDD is zero. Use M3 screw for the mounting screw and the screw length should satisfy the specification in any direction. (2) Frame ...The MR head bias of the HDD disk enclosure (DE) is attached. C141-E262 3-3 3.2 Mounting 3.2 Mounting For information on mounting, see the "FUJITSU 2.5-INCH HDD INTEGRATION GUIDANCE (C141-E144)." (1) Orientation The disk drives can be 0.49N•m (5kgf•cm). The tightening torque...
...frame to touch parts (cover and base) other than parts to Signal Ground (SG). The mounting frame is connected to which the HDD is zero. Use M3 screw for the mounting screw and the screw length should satisfy the specification in any direction. (2) Frame ...The MR head bias of the HDD disk enclosure (DE) is attached. C141-E262 3-3 3.2 Mounting 3.2 Mounting For information on mounting, see the "FUJITSU 2.5-INCH HDD INTEGRATION GUIDANCE (C141-E144)." (1) Orientation The disk drives can be 0.49N•m (5kgf•cm). The tightening torque...
Manual/User Guide
Page 5
Figure 3.3 Location of breather hole is shown as Figure 3.3. Locating of breather C141-E262 3-5 3.2 Mounting Because of breather hole mounted to the HDD, do not allow this to block. For breather hole of Figure 3.3, at least, do not allow its around φ 3 to close during mounting.
Figure 3.3 Location of breather hole is shown as Figure 3.3. Locating of breather C141-E262 3-5 3.2 Mounting Because of breather hole mounted to the HDD, do not allow this to block. For breather hole of Figure 3.3, at least, do not allow its around φ 3 to close during mounting.
Manual/User Guide
Page 7
... cautions, and handle the HDD under the safety environment. Static: When handling the device, disconnect the body ground (500 kΩ or greater). Do not touch the printed circuit board, but hold it too hard, the cover and the spindle motor contact, which may cause damage to the disk drive. Pressing it by external...
... cautions, and handle the HDD under the safety environment. Static: When handling the device, disconnect the body ground (500 kΩ or greater). Do not touch the printed circuit board, but hold it too hard, the cover and the spindle motor contact, which may cause damage to the disk drive. Pressing it by external...
Manual/User Guide
Page 8
...; cm). - Do not stack when carrying. Figure 3.6 Handling cautions - General notes Wrist strap Use the Wrist strap. Do not hit HDD each other. Do not place HDD vertically to avoid falling down. HDD is occasionally damaged by the impact of the driver. (2) Please observe the tightening torque of a low impact when you use...
...; cm). - Do not stack when carrying. Figure 3.6 Handling cautions - General notes Wrist strap Use the Wrist strap. Do not hit HDD each other. Do not place HDD vertically to avoid falling down. HDD is occasionally damaged by the impact of the driver. (2) Please observe the tightening torque of a low impact when you use...