User's Guide
Page 9
... create a loop and cause collisions. To improve network efficiency, use 1000-Mbps full-duplex operation between the server and switch if the LAN adapter on the switch automatically negotiate speed and whether to the switch. All the RJ-45 ports support Auto MDI/... The eight levels of IEEE 802.1p priority are mapped to connect the network device. Cascading Switches Connecting Switches to Systems By connecting a switch to connect switches can form a small network. Crossover or straight-through networking cables can operate in the tag (that also defines VLAN memberships. Table 1-1....
... create a loop and cause collisions. To improve network efficiency, use 1000-Mbps full-duplex operation between the server and switch if the LAN adapter on the switch automatically negotiate speed and whether to the switch. All the RJ-45 ports support Auto MDI/... The eight levels of IEEE 802.1p priority are mapped to connect the network device. Cascading Switches Connecting Switches to Systems By connecting a switch to connect switches can form a small network. Crossover or straight-through networking cables can operate in the tag (that also defines VLAN memberships. Table 1-1....
User's Guide
Page 12
...Network Protocol and Standards Compatibility IEEE 802.3 CSMA/CD IEEE 802.3 10Base-T IEEE 802.3u 100Base-TX IEEE 802.3z/ab 1000Base-T IEEE 802.3x Flow Control IEEE 802.3p Priority Interface RJ-45 connectors; one SFP connector available on 24-port switch...-240 VAC/5060 Hz universal input 12 Introduction Brackets for Wall Installation 3 Place the switch against the wall and mark the wall through the holes of the brackets. 4 Drill holes in... Insert and tighten the screws through each of the mounting brackets. Technical Information Table 1-2. www.dell.com | support.dell.com Figure 1-6.
...Network Protocol and Standards Compatibility IEEE 802.3 CSMA/CD IEEE 802.3 10Base-T IEEE 802.3u 100Base-TX IEEE 802.3z/ab 1000Base-T IEEE 802.3x Flow Control IEEE 802.3p Priority Interface RJ-45 connectors; one SFP connector available on 24-port switch...-240 VAC/5060 Hz universal input 12 Introduction Brackets for Wall Installation 3 Place the switch against the wall and mark the wall through the holes of the brackets. 4 Drill holes in... Insert and tighten the screws through each of the mounting brackets. Technical Information Table 1-2. www.dell.com | support.dell.com Figure 1-6.
User's Guide
Page 17
... traffic is being passed to or sent from a device that is operating properly. link. Verify that any devices connected to the switch are set port speed and duplex settings. Link LED is lighted and the Mismatched duplex mode. Some collisions take place during normal operation...detect and set to the port. The link is no Ethernet traffic on the link. Troubleshooting 17 There is reaching its maximum Resegment the network to capacity. The attached device is lighted, but the activity (ACT) LED does not blink. No action required. Basic Troubleshooting (continued...
... traffic is being passed to or sent from a device that is operating properly. link. Verify that any devices connected to the switch are set port speed and duplex settings. Link LED is lighted and the Mismatched duplex mode. Some collisions take place during normal operation...detect and set to the port. The link is no Ethernet traffic on the link. Troubleshooting 17 There is reaching its maximum Resegment the network to capacity. The attached device is lighted, but the activity (ACT) LED does not blink. No action required. Basic Troubleshooting (continued...