Cisco CISCO7301 Support and Manuals
Get Help and Manuals for this Cisco item
View All Support Options Below
Free Cisco CISCO7301 manuals!
Problems with Cisco CISCO7301?
Ask a Question
Free Cisco CISCO7301 manuals!
Problems with Cisco CISCO7301?
Ask a Question
Popular Cisco CISCO7301 Manual Pages
Configuration Guide - Page 6
...cisco.com
Routed Interfaces 4-2 Subinterfaces 4-2 VLAN Interfaces 4-3 Loopback Interfaces 4-4 Tunnel Interfaces 4-4 High Availability 4-4 Virtualization Support 4-5 Licensing Requirements for Layer 3 Interfaces 4-5 Prerequisites for Layer 3 Interfaces 4-5 Guidelines and Limitations 4-5 Default Settings... Support 5-4
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
vi...
Configuration Guide - Page 16
... Layer 2 protocol tunneling.
A nonquoted set of code
indicates a comment line.
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
xvi
OL-23435-03 Do not use these conventions:
screen font
Terminal sessions and information that you supply values are in italic screen font.
< >
Nonprinting characters, such as passwords, are in angle brackets.
[ ]
Default...
Configuration Guide - Page 17
... Series NX-OS Interfaces Configuration Guide, Release 5.x
xvii
The RSS feeds are a free service. In this situation, you might do something that could result in Cisco Product Documentation as an RSS feed and set content to be delivered directly to nexus7k-docfeedback@cisco.com
Caution Means reader be careful. Cisco currently supports RSS Version 2.0. Preface
Document Conventions...
Configuration Guide - Page 37
...set the local port send parameter to desired.
- To send pause frames when you do not know that can change a Layer 3 interface into a Layer 3 interface by using Cisco-supported transceivers, use Cisco-supported..., or 1000 Mb/s), you set the local port send parameter to enabled.
- OL-23435-03
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
2-13
You ...
Configuration Guide - Page 52
...supports your changes for Ethernet and management interfaces, see which speeds and duplex modes you should configure both of 1000 Mb/s (1 Gb/s) or faster, full duplex is automatically set the local port to use a specific speed, you must set the remote port for the same speed or set to nexus7k-docfeedback@cisco... {10000 | auto}} 4. If you set the speed for autonegotiation, the duplex mode ...
Configuration Guide - Page 112
...between two routers. Loopback interfaces emulate a physical interface. Loopback interfaces can configure VLAN interface for inband management in the chassis.
IP tunnels can configure up to 1024 loopback interfaces per VDC, numbered 0 to stay up . High Availability
Layer 3 interfaces support stateful and stateless restarts.
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide...
Configuration Guide - Page 114
... aware that you are familiar with the Cisco IOS CLI, be configured on an Interface, page 4-9 • Configuring a VLAN interface, page 4-10 • Configuring Inband Management in the Nexus Chassis, page 4-12 • Configuring a Loopback Interface, page 4-14 • Assigning an Interface to both of the supported connectivity cases:
- Fabric Extender port or...
Configuration Guide - Page 132
...Guide, Release 5.x.
Prerequisites for BFD
BFD has the following table shows the licensing requirements for this feature:
Product Cisco NX-OS
License Requirement
BFD requires no extra charge to you.
High Availability
BFD supports stateless restarts and in the default VDC and default VRF unless you specifically... sets the TTL value to 254. Virtualization Support
BFD supports virtual...
Configuration Guide - Page 223
...settings. With F-Series line-cards, vPC peer link and downstream vPC channels support...See the Cisco Nexus 7000 Series NX-OS Layer 2 Switching Configuration Guide, Release... 5.x, for information on vPC peer links.
We recommend that you can have different system priority values, vPC will not cause any problems... using LACP. Note When manually configuring the system priority, ...
Configuration Guide - Page 225
...supported. The Cisco NX-OS software fully supports PIM ASM on networks that feature is no impact on the downstream devices as STP edge ports. (See the Cisco Nexus 7000 Series NX-OS Layer 2 Switching Configuration Guide...the Cisco Fabric Service over...cisco.com
• VLANs (PVRST+)
Note Display the configuration on STP enhancement features and Rapid PVST+. Note We recommend that the settings...
Configuration Guide - Page 228
...error message.
7-26
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide..., Release 5.x
OL-23435-03
This feature avoids packet drops when the routing tables may not be converged before the vPC is not supported...
CFSoE
The Cisco Fabric Services over to the...manually configuring virtual MAC addresses for the vPC peer link.
Configuration Guide - Page 230
... bypassed for the local vPC ports.
High Availability
During an In-Service Software Upgrade (ISSU), the software reload process on high-availability features.
7-28
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03 The second device then performs the upgrade process, locking the first device as it unlocks its peer device...
Configuration Guide - Page 267
... Services license.
Beginning with Cisco NX-OS Release 4.2, you specifically configure another VDC. Your tunnel source IP address and destination IP address should match the VRF of the tunnel source IP address. OL-23435-03
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
8-3 This message indicates that traverse the tunnel. Virtualization Support
You...
Configuration Guide - Page 268
...supported tunnel interfaces was changed to 4095.
• Cisco NX-OS does not support WCCP on to the switch. • You have installed the Enterprise Services license for Cisco NX-OS. • You must be familiar with Cisco...; Assigning VRF Membership to a Tunnel Interface, page 8-8
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
8-4
OL-23435-03 Table 8-1
Default IP...
Configuration Guide - Page 283
For a complete explanation of the Cisco NX-OS licensing scheme, see the Cisco NX-OS Licensing Guide. You must be identified in tunnel traffic (for tunnel traffic (VLAN IDs and src/dest MAC addresses).
• You should use MAC address-based frame distribution.
• Asymmetrical links do not support the Dynamic Trunking Protocol (DTP) because...
Cisco CISCO7301 Reviews
We have not received any reviews for Cisco yet.