Brother International SQ-9000 Support and Manuals
Get Help and Manuals for this Brother International item
View All Support Options Below
Free Brother International SQ-9000 manuals!
Problems with Brother International SQ-9000?
Ask a Question
Free Brother International SQ-9000 manuals!
Problems with Brother International SQ-9000?
Ask a Question
Most Recent Brother International SQ-9000 Questions
Pattern:100 Stitches Model
In "pattern" category what does 100 stitch model vs 90 stitch model refer to?
In "pattern" category what does 100 stitch model vs 90 stitch model refer to?
(Posted by mowens2008 8 years ago)
Video On How To Attach The Buttonhole Foot On A Brother Sq-9000 Machine
(Posted by ralpmgro 9 years ago)
Where Can I Find A Manual And Foot A For My Brother Sq-9000
(Posted by aseazhar 9 years ago)
Brothers Sewing Machine Sq-9000 How To Install The Bobbin Case
(Posted by MethMer 9 years ago)
How To Thread A Brother Sewing Machine Sq9000
(Posted by titaspau 9 years ago)
Brother International SQ-9000 Videos
Máquina de Costura SQ9000 - Brother
Duration: 19:46
Total Views: 86,068
Duration: 19:46
Total Views: 86,068
Máquina de Costura SQ9000 Brother YouTube
Duration: 19:46
Total Views: 1,120
Duration: 19:46
Total Views: 1,120
Aprenda a usar as fontes alfa-numéricas da SQ9000 - Brother
Duration: 2:33
Total Views: 226
Duration: 2:33
Total Views: 226
Popular Brother International SQ-9000 Manual Pages
Users Manual - English - Page 2
..., after using this machine, carefully read these safety instructions before attempting to the nearest authorized dealer or service center for examination, repair, electrical or mechanical adjustment. Lifting the sewing machine by its handle.
To reduce the risk of the electrical outlet.
Do not pull on the unit. INTRODUCTION
Thank you have finished reading this manual, store it...
Users Manual - English - Page 3
...damage the case and machine, and should be used.
• Always consult the operation manual when replacing or installing any opening. • Do not operate where aerosol (spray) products are being used by or near a space heater, iron, halogen lamp, or other parts to assure correct installation.
1 Special care is required around the machine needle. • Switch the sewing machine to...
Users Manual - English - Page 5
...
ACCESSORIES ...8
Optional accessories ...8
USING YOUR SEWING MACHINE 9
Power supply precautions ...9 Turning on the machine ...9 Foot controller ...10 Sewing speed controller (for models equipped with the sewing speed controller 10 Changing the needle stop position ...10 Changing the initial needle position ...11 Cancelling the operation beep ...11
THREADING THE MACHINE 12
Winding the bobbin...
Users Manual - English - Page 7
...stitch and specify the various settings. m Jack/socket connector (page 9) Insert the plug on the sewing machine model.
l Main power and sewing light switch (page 9) You can use as the lower thread. p Presser foot lever (page 17) Used to manually raise and lower the needle.
r Handle Carry the sewing machine by its handle when transporting the machine.
5 d Upper tension-control...
Users Manual - English - Page 8
... cover Open the bobbin cover to hold the presser foot holder in place. k Needle clamp screw Use the needle clamp screw to set bobbin (for models equipped with the quickset bobbin) You can start sewing without pulling up the bobbin thread.
KNOWING YOUR SEWING MACHINE
Needle and presser foot section
a Buttonhole lever Lower the buttonhole lever when sewing buttonholes and bar tacks...
Users Manual - English - Page 10
...
No.
KNOWING YOUR SEWING MACHINE
ACCESSORIES
The following machine models: HS-3000, SQ-9000.
● The screw of the presser foot holder is available through your authorized dealer. (Part code: 132730-122)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
75/11 1 needle 90/14 1 needle 100/16 1 needle
90/14 1 needle
No.
No.
Part Code U.S.A. / Canada Others
SA156 XA5539...
Users Manual - English - Page 12
...to leave the needle raised when sewing is stopped.
Instead, the machine can be set using the sewing speed controller is not in , the start /stop position to sew at a low speed.
KNOWING YOUR SEWING MACHINE
Foot controller
Insert the foot controller plug into its jack/socket on the foot controller. When you press the foot controller down the "-" side of (stitch selection b key...
Users Manual - English - Page 15
... right. Trim the excess thread above the bobbin.
Slide the sewing speed controller to the right
h (to set the speed to start sewing (only for models equipped with the start/stop button). Then stop the machine.
1
Note
● If the sewing machine is to be used to fast) (for models equipped with the sewing speed controller). If you follow the instructions carefully. CAUTION
●...
Users Manual - English - Page 16
... using the foot controller, connect the foot controller before turning on the sewing machine. a Notch b Bobbin winder shaft spring
Slide the bobbin winder shaft to run out. Note
● If the sewing machine is to be used to start sewing (only for models equipped with
the sewing speed controller).
Slide the sewing speed controller back to pass the thread
around the d pre-tension disk...
Users Manual - English - Page 17
... button) (for this sewing machine. Install the bobbin wound with your finger, and then pass the
thread through
the tension-adjusting spring of the bobbin case, it may cause the thread tension to loosen, breaking the needle and resulting in c the direction shown by turning a the handwheel toward you set bobbin, see page 16. Hold the end of the same type (part code: SA156, SFB...
Users Manual - English - Page 18
... position button) (for models equipped with this machine. If the thread unrolls in the wrong direction, it .
1
a Tension-adjusting spring
Memo
● The order that were designed to its highest position by marks around the bobbin case.
CAUTION
● Make sure you set bobbin
Raise the needle to be incorrect or break the needle.
1
a Cutter
16
Replace the bobbin cover. Slide the...
Users Manual - English - Page 20
... 21 for models equipped with the needle threader)
CAUTION
● The needle threader can only use needles in the range of the procedure in a "Upper threading" to thread the machine to left hand, then feeding the thread with home sewing machine needles size 75/11100/16.
a Needle bar thread guide
Thread the needle from right to
the needle bar thread guide. Lower the presser foot lever...
Users Manual - English - Page 37
...stitches
model 40 stitches
model Twin Needle Walking Foot Reverse (Rev.)/ Reinforcement (Rfc.)
Stitching
Stitch Name
Pattern No.
J
05
05
05
05
05
05
Overcasting on stretch fabrics
5.0 (3/16)
0.0-7.0 (0-1/4)
2.5 (3/32)
0.5-4.0 (1/32-3/16)
Y*e*s ( J )
No
Rfc.
Center
Triple stretch stitch
Stretch stitch
J
01
01
01
01
01
01
Attaching zippers, basic 01 stitching, and sewing...
Users Manual - English - Page 74
...
the right.
sew. You are knots or tangles in the presser foot is scratched. Replace the needle plate. Replace the presser foot. Contact your retailer or the nearest authorized service center. Replace the bobbin case.
Incorrect bobbins will not work . Only use a bobbin that has been designed for the type of fabric, thread and needle.
Loosen the upper thread tension. Remove the...
Users Manual - English - Page 77
..., because the thread is tangled The sewing machine beeps for the cause of the error, and correct it before continuing the operation.
Be sure to the right.
Contact your nearest authorized service center.
ERROR MESSAGES
If an operation is performed incorrectly before continuing the operation.
4
The reverse/reinforcement stitch button or needle Move the bobbin winder
position...
Brother International SQ-9000 Reviews
We have not received any reviews for Brother International yet.