LiftMaster 3265 Support Question
LiftMaster 3265 Support Question
Find answers below for this question about LiftMaster 3265.Need a LiftMaster 3265 manual? We have 1 online manual for this item!
Question posted by peteraldersey on December 24th, 2013
What Frequency Does 3265 Use
The person who posted this question about this LiftMaster product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related LiftMaster 3265 Manual Pages
3265M Manual - Page 1
... Avenue
Elmhurst, Illinois 60126-1196 www.liftmaster.com
®
GARAGE DOOR OPENER Models 3265M 1/2 HP
3265M-267 1/2 HP
For Residential Use Only
Owner's Manual
■ Please read this manual and the enclosed safety materials carefully! ■ Fasten the manual near the garage door after installation. ■ The door WILL NOT CLOSE unless the Protector System® is...
3265M Manual - Page 2
... Signal Words on the following pages, they will alert you to your garage door and/or the garage door opener if you do not comply with the cautionary statements that accompany it will... System 25
Operation
26-30
Operation safety instructions 26 Using your garage door opener 26 Using the wall-mounted door control 27 To open the door manually 27 Care of serious injury or death if ...
3265M Manual - Page 3
... prevent damage to garage door and opener:
• ALWAYS disable locks BEFORE installing and operating the opener.
• ONLY operate garage door opener at 120V, 60 Hz to see if there is any ropes connected to garage door.
• Complete the following test to make sure your door binds, sticks, or is out of the opener, instructions will call for hand...
3265M Manual - Page 5
...Carton Inventory
Your garage door opener is also listed below . Hardware for installation is packaged in the foam. LOCK LIGHT
Multi-Function Door Control Panel
...) Ring Fastener (3) Drywall Anchors (2) Carriage Bolt 1/4"-20x1/2" (2) Wing Nut 1/4"-20 (2) Rope Handle
Straight Door Arm Section
5 Parts may be stuck in two cartons which contain the motor unit and all parts illustrated below...
3265M Manual - Page 6
... Tab Slot Mounting Plate
6 Squeeze the cover slightly and insert the front tab in the slot on the trolley to garage door opener, use ONLY those bolts/fasteners mounted in the top of the opener. Use only these bolts!
ASSEMBLY STEP 1
Attach the Rail to the Motor Unit
To avoid installation difficulties, do not...
3265M Manual - Page 7
... loose. If the chain
returns to secure the adjustment.
NEVER connect garage door opener to power source until instructed to garage door control.
11. Install wall-mounted garage door control:
• within sight of the garage door.
• out of reach of children at ) on inside of the door.
10.
Sprocket noise can result if chain is normal. WARNING NOTE...
3265M Manual - Page 10
... point if the ladder is not tall enough. • Open the door all the way and place a 2x4 on the garage floor below the header bracket. NOTE: If the door spring is used to determine the correct mounting
height from ceiling. SECTIONAL DOOR OR ONE-PIECE DOOR WITH TRACK
A 2x4 laid flat this point if...
3265M Manual - Page 11
... hanging brackets with 5/16"-18x7/8" hex bolts, lock washers and nuts.
6. Measure the distance from a falling garage door opener, fasten it securely to structural supports of each side of the hanging bracket to the structural support.
2.
Operate the door manually. Figure 1
Structural Supports
Measure Distance
Bolt 5/16"-18x7/8" Lock Washer 5/16"
Nut 5/16"-18...
3265M Manual - Page 13
...; Adjust rope length so the handle is CLOSED. Ensure that the rope and handle clear the tops of lens. The use halogen bulbs. Secure with a Garage Door Opener bulb.
• Use A19, standard neck garage door opener bulbs for approximately 4-1/2 minutes when power is clear of short neck or speciality light bulbs may overheat the endpanel or light...
3265M Manual - Page 14
... MUST be grounded.
• Reinstall the cover. RIGHT
WRONG
PERMANENT WIRING CONNECTION
If permanent wiring is required by your garage door opener has a grounding type plug with ALL local electrical and building codes.
• NEVER use an extension cord, 2-wire adapter, or change plug in
Green
the top of electric shock, your local code...
3265M Manual - Page 15
... Reversing Sensor 6" (15 cm) max. If it is NOT connected to full open position, and the opener lights will stop and reverse to the garage door opener BEFORE installing the safety reversing sensor.
The units must be connected and aligned correctly before the garage door opener will detect an obstacle in masonry if repositioning is NO HIGHER than...
3265M Manual - Page 17
Be sure the lens is enough wire to the garage door opener. Option A - Installation Without Pre-Wiring:
• Run the bell wire from each end. Choose two of the pre-...)
Figure 9
Safety Reversing Sensor Wires
White
7/16" (11mm) Pre-Installed Wires Not Provided
Pre-installed wires
White/Black 17
Use wing nuts to fasten sensors to the wall and ceiling with lenses pointing toward each end.
3265M Manual - Page 18
... together. These can occur at staples, or at the receiving eye. NOTE: When the invisible beam path is obstructed or misaligned while the door is already open wire to garage door opener:
• Strip 7/16" (11 mm) of insulation from each set of alignment or obstruction. To insert or release wire, push in tab with...
3265M Manual - Page 26
... are under the following : • The hand-held remote. Using Your Garage Door Opener
6. They will turn on contact with garage door control push buttons or remote controls.
10.
Multi-Function Door Control, this feature, start with each use handle to deactivate any of the following conditions: when the opener is adjusted, the other hardware, ALL of persons and...
3265M Manual - Page 28
... changes in door operation requiring some re-adjustments, particularly during the first year of operation. Follow the instructions carefully. Adjust if necessary (see page 7). Every Three to Four Years • Use a rag to the rail. Reapply a small layer of white lithium grease to wipe away the existing grease from the garage door opener rail.
3265M Manual - Page 29
... need for occasional adjustment for Using the Wall Mounted Door Control.
• Reprogram remotes following page. Using the Wall Mounted Door Control, Light Feature.
6. This is normal.)
• If the trolley does not move in the down limit adjustment screw clockwise.
5. My door will not turn off when door is open:
• The garage door opener is normal. If it...
3265M Manual - Page 30
...overheated or possible RPM sensor failure.
Try to motor unit using shortened wires. Wait 30 minutes and retry. Consult Diagnostic Chart below. Symptom: LED is not lit on door control.
• Inspect door control/wires for a short (staple in wire), correct...LED or Diagnostic LED
"Learn" Button
Installed Safety Reversing
Sensor
Your garage door opener is programmed with jumper wire.
3265M Manual - Page 31
... ). Press and release the "learn" button on motor unit until the learn indicator light will open and close when you wish to operate your garage door.
3.
All previous codes are held Remote Control
USING THE "LEARN" BUTTON
USING THE MULTI-FUNCTION DOOR CONTROL
9
1
7
3
5
KG
9
1
7
3
5
KG
LOCK
LIGHT
1.
Additional buttons on any unwanted remote, first erase...
3265M Manual - Page 32
... indicator light will glow steadily for your garage door opener.
Enter a four digit personal identification number (PIN) of openings, remember that the test has used to close is already mounted outside the garage.
1. It has learned the code. To change an existing, known PIN
3. Release the # button. 2. The door should move .
To set to a certain...
3265M Manual - Page 35
... to ten fingerprints. Finger Print Control: The system uses biometric technology that enables an authorized user to a programmable number of garage door opener from outside by scanning their home with NO access door.
CLOSED OPEN
379LM-10
916LM
Garage Door Monitor Sensor:
Additional accessory sensor for the largest door of the fingerprint that user. SEND PASS READY...
Similar Questions
I Have Installed A Chamberlan Garage Door Opener And The Remote I Was Using Is
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
(Posted by donweera42 8 months ago)
Garage Door Opens After Shutting.
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
(Posted by BONNIECA92 2 years ago)
Remote Control For Liftmaster /chamberlain 3850 Garage Door Opener
what is the correct remote control for the chamberlain/liftmaster 3850 garage door opener
what is the correct remote control for the chamberlain/liftmaster 3850 garage door opener
(Posted by sendtoalice 9 years ago)
Noise From Garage Door Opener
I have a liftmaster garage door opener. It makes a loud screeching noise when the door is lowered....
I have a liftmaster garage door opener. It makes a loud screeching noise when the door is lowered....
(Posted by tom19097 11 years ago)
Chamberlin Liftmaster Garage Door Opener Model # 3265-267
Where do I put the trolley before I attach the chain to the sprocket?
Where do I put the trolley before I attach the chain to the sprocket?
(Posted by garretmegan 11 years ago)