HP Xw4200 Support Question
HP Xw4200 Support Question
Find answers below for this question about HP Xw4200 - Workstation - 1 GB RAM.Need a HP Xw4200 manual? We have 15 online manuals for this item!
Question posted by richollifield1 on September 24th, 2011
Will Not Power On. Makes 5 Beeps And The Power On Botton Flashed Red. Help.
The person who posted this question about this HP product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related HP Xw4200 Manual Pages
Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200 - Page 38
... Service and Technical Reference Guide web link located on the Documentation Library CD and at least four seconds, then press the power button again to start the workstation.
■ Reconfigure your workstation after installing a non-plug and play expansion board or other option. See "Solving Hardware Installation Problems" for more detailed information. There...
Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200 - Page 41
... spinning, make sure the fan's cable is not properly attached to the processor.
Solution
1. OR The heatsink is plugged onto the system board header. Troubleshooting
Problem
Workstation powered off automatically and the Power LED blinks Red two times, once every second, followed by a two second pause. (On the xw4200, xw6200, and 8200, two audible beeps will also...
Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200 - Page 44
... one at a time to determine possible causes.
3.
Replace third-party memory with the system to verify the proper installation.
2. Power LED blinks Red five times, once every second, followed by a two second pause, and the workstation beeps five times. Reseat DIMMs. Power on the front of the workstation.
Review the documentation that came with HP memory.
4.
Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200 - Page 45
... Power on the front panel of the workstation and... refer to determine the front panel LED codes. Reseat the graphics card. Recommended actions in the following table to the following table are listed in the order in which they should be performed. Troubleshooting
Problem
Power LED blinks Red six times, once every second, followed by a two second pause, and the workstation beeps...
Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200 - Page 46
.... None
Green Power LED blinks four times, once per second.**
None
Workstation in Suspend to Disk or "Hibernate" mode.
None
*NOTE: When the Unique Sleep State Blink Rates is off.*
Workstation in Suspend to RAM mode (select models only) or normal Suspend mode.
None
Workstation on the green power LED. Troubleshooting
Activity
Possible Beeps Cause
Recommended Action...
Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200 - Page 47
...power button, and see that the processor is present.
2.
Getting Started Guide
www.hp.com
4-13 Reseat the processor. Reseat processor heatsink and verify that the workstation ... properly attached to see if the processor fan spins.
Troubleshooting
Activity
Possible Beeps Cause
Recommended Action
Red Power LED blinks two times, once every second, followed by a two-second...
Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200 - Page 48
... appropriate voltage. Troubleshooting
Activity
Red Power LED blinks once every two seconds. Proper voltage setting depends on the system board.
3. Replace the power supply.
5. If the system enters the POST, then power off and replace one at a time and repeat this procedure, until failure occurs.
Beeps None
Possible Cause
Power failure (power supply is set to ensure...
Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200 - Page 49
...
Reseat the graphics card. Troubleshooting
Activity Red Power LED blinks five times, once every second, followed by a two second pause. System board failure (ROM detected failure prior to isolate faulty module.
3. Replace third-party memory with a graphics card:
1.
Replace the graphics card.
3.
Replace the system board. Beeps 5
6
7
Possible Cause Pre-video memory error...
Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200 - Page 50
Beeps 8
Possible Cause
Invalid ROM based on the Documentation Library CD www.hp.com/ support/ workstation_manuals
2. Troubleshooting
Activity
Red Power LED blinks eight times, once every second, followed by a two-second pause.
Replace the system board.
4-16
www.hp.com
Getting Started Guide Recommended Action
1. See the "ROM Flash" section of the Service and Technical...
Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200 - Page 52
... occur before or during the Power-On Self-Test (POST). Green Power LED blinks three times, once per second.**
None
Workstation in Suspend to Disk or "Hibernate" mode. Activity
Possible Beeps Cause
Recommended Action
Green Power LED On. None
Workstation on the green power LED. None
Green Power LED is disabled in Suspend to RAM mode (select models only...
Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200 - Page 53
... to the processor.
1.
Red Power LED
2
blinks two times,
once every second,
followed by a two- Ensure the fan is not spinning, then replace processor fan.
4. Processor not installed (not an indicator of bad processor).
1. Troubleshooting
Activity
Possible Beeps Cause
Recommended Action
Green Power LED blinks four times, once per second.**
None
Workstation in and seated...
Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200 - Page 54
... if a device is causing the failure. If the system enters the POST, then power off and replace one at a time and repeat this procedure, until failure occurs. Blinks and beeps will continue to ensure all devices are functioning properly.
3. Red Power LED
4
blinks four times
once every second,
followed by removing ALL attached devices...
Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200 - Page 55
....hp.com
4-21 Replace the graphics card.
3.
Power on the system.
2. Red Power LED blinks six times, once every second, followed by a two-second pause. Recommended Action
1. For systems with HP memory.
4.
Troubleshooting
Activity Red Power LED blinks five times, once every second, followed by a two-second pause. Beeps 5
6
Possible Cause Pre-video memory error
Pre...
Getting Started Guide HP Workstations xw4100, xw4200, xw6200, and xw8200 - Page 56
Blinks and beeps will continue to video). second pause. See the "ROM Flash" section of the Service and Technical Reference Guide web link located on but does not boot.
4-22
www.hp.com
Getting Started Guide
Reflash the ROM using a ROMPaq diskette. Replace the system board. Red Power LED
9
blinks nine times,
once every second...
HP Workstations xw Series - Setup and Troubleshooting Guide - Page 33
...; Turn up the brightness and contrast controls of the workstation.
If the system beeps, then your keyboard is dim. • If your workstation has multiple video sources installed and a single monitor, the... that the workstation is turned on and the green power light is supported on how to register to the following list of this chapter for instructions. If it will help you diagnose...
HP Workstations xw Series - Setup and Troubleshooting Guide - Page 36
..., followed by a two second pause. (On the xw4200 and
OR
xw9300, two audible beeps will also The heatsink is properly connected to the processor.
2. Open hood, press power button, and see if the processor fan spins. Open hood and check that the workstation air
automatically and the Power LED
activated:
vents are properly connected to...
HP Workstations xw Series - Setup and Troubleshooting Guide - Page 37
... documentation that the device is not seated properly For systems with a graphics card:
once every second, followed by a two second pause, and the workstation beeps five times.
Power LED blinks Red six times, Video card is properly and securely
as an additional diskette drive. Replace the graphics card.
3. Replace the system board. Troubleshooting
Basic...
HP Workstations xw Series - Setup and Troubleshooting Guide - Page 38
... protection
1. Green Power LED is off.** None
Workstation in Suspend to RAM None mode (select models only) or normal Suspend mode. Red Power LED blinks two times, once every second, followed by a two- Reseat processor heatsink and verify that the workstation air
xw4200 activated:
vents are observed on . Reseat the processor.
30 Troubleshooting
Blinks and beeps will be...
HP Workstations xw Series - Setup and Troubleshooting Guide - Page 39
... second, followed by a two-second pause.(only on xw4200 and xw9300)
Red Power LED blinks five
5
times, once every second,
followed by a two-second
pause.
Table 4-13 Diagnostic Lights and Audible Codes
Activity
Beeps
Possible Cause
Recommended Action
NOTE: For the following LED activity and beeps, the beeps will be heard through the on the system...
HP Workstations xw Series - Setup and Troubleshooting Guide - Page 40
... based on the Documentation and Diagnostics CD www.hp.com/support/ workstation_manuals
2. Red Power LED blinks eight 8 times, once every second, followed by a two-second pause.
See the "ROM Flash" section of the chassis).
5. Blinks and beeps will be heard through the on .
Red Power LED blinks nine times, once every second, followed by a two-second...
Similar Questions
Flashing Red Light
What is wrong with my computer? How can I fix it? The computer gave a series of beeps and then shut ...
What is wrong with my computer? How can I fix it? The computer gave a series of beeps and then shut ...
(Posted by lthomasjacobs 2 years ago)
Who Makes The Motherboard For Hp Xw4200
(Posted by ishan231 9 years ago)
Hp Dx5150 Mt Won't Power On Flashes Red Light
(Posted by jokso 9 years ago)
Hp Dc7800 Does Not Power On Flashes Red Light 4 Times
(Posted by krishpd 10 years ago)
6 Beep Error In Hp Workstation Xw4200
what is the solution for the 6 beep error in hp workstation xw4200 ?
what is the solution for the 6 beep error in hp workstation xw4200 ?
(Posted by sisplworkshopinchargehz 12 years ago)