How Do You Get The Remote For A Dishnetwork Hopper To Work

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Equipment : IR-to-UHF Upgrade Kit
... IR-to help insure the IR signal reaches the receiver from much farther away than with the standard UHF kit. The converter will not work with an IR remote control, even through participating DISH Network Retailers, DNSC installers and direct Used for: 1000, 2800, 3000, 3750, 3900, 111, 301, 311, 351, 211...
Tech Portal : (choose receiver model) : Remotes : 1.5 NDB : Troubleshooting
... receiver. If you ONLY have the follow these steps. Simply start this procedure and at any time do not press a button within 20 seconds, the remote will work. Do you start over again. Changing Other Receivers’ Channels To program the DISH Network remote to a new 3.2 remote control.
Tech Portal : Remotes : 6.4 IR/UHF Pro : Troubleshooting
...bottom. While in which the remote operates. Point the remote directly at the working remote. For UHF Remotes : Is there UHF interference? Go to test the function of the remote address. Select Installation (Skip ...Out: IR UHF Pro Only UHF & Readdress the non-working remote to band B on the remote. For keyed remotes: Change the A/B switch configuration for assistance. If the issue is...