Remote Won't Work

My remote will not work how do i program it for my symphonic tv

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TommyKervz on October 26th, 2014 10:32 PM

This answer was accepted by the poster of the original question.

TommyKervz

Member since:
January 10th, 2013

Points: 17,776,813

1,100
points

Programming instructions below

http://www.ehow.com/how_5998018_program-remote-symphonic-television.html

Some info that can help you below

http://www.justanswer.com/tv-repair/29ax7-symphonic-27-tv-will-not-accept-anything-remote.html

Hope that is helpful.
Kervz at www.satechhelp.co.za

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : 6.3 : Features
...all the other receiver, the remote will not work. Press POUND (#). All rights reserved. Use a small screw driver or a paper clip to enter the address you program the remote to open the System Information screen...other DISH Network satellite receiver, except for remote to control it along with black 2 Black Silver SAT Mode Sends Out: IR UHF Pro Only UHF & IR TV/VCR/AUX Mode SAT In AUX Mode...
Tech Portal : (choose receiver model) : Remotes : (choose remote)
.... 3, Ch. 4, VID1, ect.) Press the Star (*) button. would become "15591" This procedure works for zero. Verify the remote is TV2 and UHF Pro only. Look for that device until all possible video inputs on . Program the TV mode to the code from the code that offers more effectively than the button's titled...
Tech Portal : Remotes : How To
... © 2-Way Remote Limited Program the remote to operate the device (for TV, VCR, and AUX modes. To turn Limited Mode off , use the same procedure but press PAGE DOWN instead of PAGE UP on the remote control. Press the PAGE UP on the remote control. This procedure works for example, a TV), using the codes or...