Sony FH300L - VPL - LCD Projector Support and Manuals
Get Help and Manuals for this Sony item
Popular Sony FH300L Manual Pages
Operating Instructions - Page 1
3-270-754-11 (1)
Data Projector
Operating Instructions
VPL-FH300L VPL-FW300L
© 2007 Sony Corporation
Operating Instructions - Page 2
...digital device pursuant to Subpart B of Part 15 of this apparatus to qualified personnel only.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed...Appliance Connector / Plug with the instruction manual, may require the use of the above Power Cord / Appliance Connector / Plug, please consult a qualified service personnel.
Operation of FCC Rules...
Operating Instructions - Page 4
... 31
Adjustments and Settings Using a Menu
Using a MENU 32 The Picture Menu 34 The Screen Menu 36
About the Preset Memory No. ....37 The Setup Menu 38 The Function Menu 40 The Installation Menu 42 The Information Menu 44
Maintenance
Replacing the Lamp (s 46 Replacing the Air Filters 48
Others
Troubleshooting 50 Messages List 53
Specifications 55 Dimensions...
Operating Instructions - Page 5
...and wall paper be exposed to grasp both air filters whenever you set the angle of the screen should be near the unit and ...replace the lamp. If customers perform the installation described in this manual, an accident may be sure to more than ±20°, read the Installation Manual for Dealers throughly for dealers. If voltage adaptation is required, consult with qualified Sony...
Operating Instructions - Page 10
... air filters or the lens easily because the replacement lamp is supplied with smooth picture movement. 12-bit 3D Digital Gamma Correction or 3D Digital Comb Filter for the installation condition from the projector. Direct Power On/Off function The AC power for rear projection. High resolution VPL-FH300L: Three 2K × 1K panels with the center of...
Operating Instructions - Page 11
... signals The projector accepts video signals of the projector lamp, error occurrences, etc., to mail addresses that can be projected by connecting a network cable to digital RGB equipment equipped...of Sony corporation. • "BrightEra" is a trademark of Sony corporation. • All other trademarks and registered trademarks are not specified. For details, see the "Operating Instructions for...
Operating Instructions - Page 17
... the image manually. g KEYSTONE (Vertical trapezoidal distortion correction) key Adjusts the vertical trapezoidal distortion of an item to its factory preset value. For details, see "APA" in "The Screen Menu" on the screen.
When you press this key, the V Keystone menu is displayed on page 37.
This key functions when a setting item...
Operating Instructions - Page 20
... table above. Correcting angle VPL-FH300L: ±5° (±15° when using the video signal only) VPL-FW300L: ±30° (±10° at 1080/24p and 1080/30p)
20 Installing the Projector See the "The Installation Menu" on installation, consult with qualified Sony personnel.
For details on page 42 for details of setting.
VPL-FW300L (When "Aspect...
Operating Instructions - Page 23
...2 Route the cable with DSD (Direct Stream Digital) Signal or CEC (Consumer Electronics control) Signal. In this projector is supplied with qualified Sony personnel.
1 Connect the HDMI cable securely. ...VPL-FH300L) or WXGA (VPL-FW300L) mode for the external monitor. • If you set your computer, such as in the illustration.
Regarding the verified HDMI cable, consult with the projector...
Operating Instructions - Page 39
... a Menu
The Setup Menu 39
Auto
Notes
• If you to set to the selected system manually.
To use it, turn on the power
again.
Setting items
Functions
Initial setting
Power Saving Mode
Selects the Power Saving mode. The lamp lights again when a
signal is input or any key is pressed.
• Standby: The projector goes into...
Operating Instructions - Page 46
... not tilt the lamp. Thus replace the exhausted lamp (Lamp 1 or 2) with a Phillips screwdriver.
46 Replacing the Lamp (s)
3 Put your finger. Use an LMP-F271 Projector Lamp as a light source are a consumable product. If you touch the lamp, you may cause damage to fix the cover.
4 Release the three silver plus screws 1
of lamp 1 or lamp 2 with qualified
Sony personnel. • Pull...
Operating Instructions - Page 50
....
• Input selection is muted.
in the Setup menu is compatible with qualified Sony personnel. c Set the computer signal to output only to an external monitor (see page 22).
• Noise may appear on the background depending on according to the following instructions. B Others
Troubleshooting
If the projector appears to be operating erratically, try to reduce...
Operating Instructions - Page 52
... Sony personnel.
• The lamp must be replaced lights.
• The lamp temperature has been high.
Unplug the AC power cord from the wall outlet after the ON/ STANDBY indicator goes out, plug the power cord to cool the lamp and then turn on the Remote
commander.
52 Troubleshooting
To maintain the product reliability of the projector...
Operating Instructions - Page 55
... the projector.
2) When a 2K × 1K (2048 × 1080) signal is input, information of a vertical one line at both ends is
Specifications 55
Others Z4045 is set to
"High" and Lamp Light Mode
to 1303 3/8 feet) There may be a slight difference between the actual value and the design value shown above. Z4019 is attached.)
VPL-FH300L...
Operating Instructions - Page 57
...accessories
Projector Lamp LMP-F271 (for replacement, included two air-filters)
Projector Suspension Support PSS-630
Projector Suspension Support Joint...VPL-FH300L (VPL-FW300L) 100 inches: 5,450 to 10,110 mm (5,310 to 9,850 mm) 200 inches: 11,060 to 20,370 mm (10,780 to 19,850 mm) 300 inches: 16,680 to 30,620 mm (16,250 to change without notice.
CD-ROM (Operating Instructions, Installation Manual...
Sony FH300L Reviews
We have not received any reviews for Sony yet.