Operating Instructions
Page 11
...channel minimum continuous average power into 4 Ohms) CD Player section Signal-to-noise ratio: 95 dB Frequency response: 10 - 20,000 Hz Wow and flutter: Below measurable limit Tuner section FM Tuning range: 87.5 - 107.9 MHz Antenna (aerial) terminal: External antenna (aerial) connector Intermediate frequency: 10.7 MHz/450 kHz Usable...unseat the unit. 3 Slide the unit out of the front panel Notes • For safety, turn off the ignition before cleaning the connectors, and remove the key from 20 Hz to 20 kHz with any metal device. 2 Pull the release keys to remove the protection collar.
...channel minimum continuous average power into 4 Ohms) CD Player section Signal-to-noise ratio: 95 dB Frequency response: 10 - 20,000 Hz Wow and flutter: Below measurable limit Tuner section FM Tuning range: 87.5 - 107.9 MHz Antenna (aerial) terminal: External antenna (aerial) connector Intermediate frequency: 10.7 MHz/450 kHz Usable...unseat the unit. 3 Slide the unit out of the front panel Notes • For safety, turn off the ignition before cleaning the connectors, and remove the key from 20 Hz to 20 kHz with any metal device. 2 Pull the release keys to remove the protection collar.
Operating Instructions
Page 12
...Defective or dirty disc. The leads are not for a 2-speaker system. The disc does not playback. • Defective or dirty disc. • The CD-Rs/CD-RWs are not matched correctly with your unit. t Install the unit at 10 kHz Power requirements: 12 V DC car battery (negative ground (earth)) ...disc is not connected properly. Makes noise when the position of the ignition is turned on the unit until the display appears. • The connectors are erased. The unit is switched. The beep sound is being supplied to the unit. General No power is canceled (page 8). No beep...
...Defective or dirty disc. The leads are not for a 2-speaker system. The disc does not playback. • Defective or dirty disc. • The CD-Rs/CD-RWs are not matched correctly with your unit. t Install the unit at 10 kHz Power requirements: 12 V DC car battery (negative ground (earth)) ...disc is not connected properly. Makes noise when the position of the ignition is turned on the unit until the display appears. • The connectors are erased. The unit is switched. The beep sound is being supplied to the unit. General No power is canceled (page 8). No beep...