Poulan PO10530LT Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan PO10530LT manuals!
Problems with Poulan PO10530LT?
Ask a Question
Free Poulan PO10530LT manuals!
Problems with Poulan PO10530LT?
Ask a Question
Most Recent Poulan PO10530LT Questions
No Gears
My PO10530LT riding mower suddenly lost all gears? Any thoughts on what is wrong?
My PO10530LT riding mower suddenly lost all gears? Any thoughts on what is wrong?
(Posted by plmckenzie4 2 years ago)
Popular Poulan PO10530LT Manual Pages
User Manual - Page 1
... the U.S.A. IMPORTANT MANUAL
DO NOT THROW AWAY
5000
OPERATOR'S MANUAL
MODEL:
PO10530LT
LAWN TRACTOR
WARNING:
Read this machine.
Failure to 10% ethanol (E10) is acceptable for use of any gasoline exceeding 10% ethanol (E10) will void the product warranty.
580 65 85-24
03.13.12 JM Printed in this Manual and follow all Warnings and Safety Instructions.
User Manual - Page 2
...setting up, transporting, adjusting or making repairs, always disconnect spark plug wire and place wire where it .
• Mow up and thrown by putting your tractor. Tall grass can hide obstacles. • Choose a low ground speed so that are familiar with the instructions... slowly straight down a hill in a large percentage of riding mower-related injuries. Do no use on steep slopes. •...
User Manual - Page 3
...Repair... parts, when necessary.
• Mower blades...riding lawn mower. Do not attach towed equipment except at all nuts and bolts tight to stop or shift while on the slope. SERVICE...replace with safety devices. Never carry passengers.
Never assume that has a hitch designed for Ride-On Mowers
III. GENERAL SERVICE...service as required.
• Maintain or replace safety and instruction...
User Manual - Page 6
... CARTON
• Remove all four panels of carton. ASSEMBLY
Your new tractor has been assembled at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instructions).
• For battery and battery cable installation see "REPLACING BATTERY" in the "Service and Adjustments" section in this manual, it means when you assemble must be tightened securely.
User Manual - Page 7
... drive belts.
CHECK TIRE PRESSURE
The tires on your tractor were overinflated at the factory for replacing motion and mower blade drive belts in a well-ventilated area. Be sure the area in front of tractor is in the Service and Adjustments section of this manual. Correct tire pressure is important for best cutting performance. • Reduce...
User Manual - Page 12
... fuel. OPERATION
TO STOP MOWER BLADES
• Disengage attachment clutch control.
If necessary, add oil until the fuel lines and carburetor are recommended by and comply with attachment lift control.
• When pushing or towing your tractor.
Tires can attract moisture which leads to highest position with specifications of the manufacturer of your...
User Manual - Page 13
.../brake pedal and set parking brake.
• Place gear shift lever in a more even distribution of this manual.
• The...• If grass is extremely tall, it is attached to tractor.
• Mower should be used during the engine warm-up for more uniform ... altitude (above 3000 feet) or in the Service and Adjustments section of this manual. NOTE: Before starting, read the warm and...
User Manual - Page 14
... and Terminals
Clean Debris Off Steering Plate Check Transaxle Cooling
Check Mower Levelness
Check V-Belts
Check Engine Oil Level
Change Engine Oil (with maintenance-free battery.
5 - GENERAL RECOMMENDATIONS
LUBRICATION CHART
The warranty on this manual. Replace blades more often when operating in this tractor does not cover items that have been subjected to operator...
User Manual - Page 15
... blade with heavy cloth.
• Remove blade bolt by turning counterclockwise. • Install new or resharpened blade with the ignition switch in the seat.
NOTE: Protect your tractor does not function as described, repair the problem immediately.
Fig. 14
BATTERY
Your tractor has a battery charging system which is sufficient for proper PSI).
• Keep tires...
User Manual - Page 17
...; Clean debris from tractor and mower. CLEAN AIR SCREEN
Air screen must be replaced once each mowing season or after every 100 hours of drive. Debris can restrict clutch/brake pedal shaft movement, causing belt slip and loss of operation, whichever occurs first. See engine manual.
Spark plug type and gap setting are shown in...
User Manual - Page 18
... link (E) from rear mower bracket (D) - TO INSTALL MOWER (See Fig. 20-25)
Be sure tractor is centered under right side of mower and disconnect mower
suspension arm (A) from chassis pin (B) and rear lift link (C) from mower -
SERVICE AND ADJUSTMENTS
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
• Depress brake pedal fully and set parking brake. •...
User Manual - Page 20
... your lawn appears
unevenly cut, determine which side of mower. The distance should be adjusted so the front tip is 1/8" to raise LH side of mower is ...mower, position blade at front and rear tip of blade is sharp.
SERVICE AND ADJUSTMENTS
TO LEVEL MOWER
Make sure tires are satisfied with the results. A
• If adjustment is necessary, see step in Visual Adjustment instructions...
User Manual - Page 22
... key. • Replace washers and snap retaining ring securely in rear wheel hub and axle. RETAINING WASHERS RING
AXLE COVER
TO ADJUST STEERING WHEEL ALIGNMENT
If steering wheel crossbars are positioned straight forward, remove steering wheel and reassemble per instructions in the Assembly section of this manual).
DO NOT USE YOUR TRACTOR BATTERY TO...
User Manual - Page 24
... manual). • Inspect and replace belts, if necessary (See belt re- ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE. • Empty the fuel tank by starting the engine and let it thoroughly, remove all rusted or chipped paint surfaces; placement instructions in the Service and Adjustments section of this manual...
User Manual - Page 26
...loose blade. 2. Worn/damaged mower drive belt. 3. Turn switch "ON". 2. Replace fuse. Replace alternator. Turn ignition key to slower speed.
3. TROUBLESHOOTING POINTS
PROBLEM
Excessive vibration
CAUSE 1. Worn, bent or loose blade. 2. Loose/damaged part(s). Replace blade. Replace blade mandrel. 3. Tighten loose part(s). Replace damaged parts. Faulty operator-safety presence control...
Poulan PO10530LT Reviews
We have not received any reviews for Poulan yet.