Pioneer PWM-F110 - Bracket For Plasma Panel Support and Manuals
Get Help and Manuals for this Pioneer item
View All Support Options Below
Free Pioneer PWM-F110 manuals!
Problems with Pioneer PWM-F110?
Ask a Question
Free Pioneer PWM-F110 manuals!
Problems with Pioneer PWM-F110?
Ask a Question
Popular Pioneer PWM-F110 Manual Pages
Owner's Manual - Page 3
Installation Manual
Page - 3 -
PWM-F110
Table of Contents
Warning Statements ...- 4 Parts List ...- 6 Installation Tools ...- 6 Mounting Bracket Installation ...- 7 Wall Stud Location ...- 10 Installing the Flat Panel Display ...- 14 Technical Specifications ...- 16 Warranty ...- 17 Contact Premier Mounts ...- 17 Notes ...- 18 -
Owner's Manual - Page 4
... 450mm wall studs. All four (4) Lag bolts must always support the weight or load of supporting at the screen. Keep these installation instructions in fire or damage to do so may result in locations where temperatures and humidity are not properly installed, do so may result in an easily accessible location for the installation of the mounting bracket. Injury...
Owner's Manual - Page 5
...Attach the bracket, with the appropriate plasma television. Read the installation instructions completely in conjunction with Griplates, to the rear of the plasma television, and then to ensure a complete understanding of a system or as part of the entire installation procedures before beginning the installation process.
PWM-F110
Mount Overview
This PWM-F110 Plasma Wall Mount may be...
Owner's Manual - Page 6
.../ Blanket Drill Gun
Tape Measure
1/2" Socket and Wrench
Installation Manual
If there are missing and/or damaged before beginning installation. PWM-F110
Parts List
NOTE: This wall mount is shipped with all proper installation hardware and components. Wall Plate (Qty 1)
5/16" Flat Washers (Qty 4)
GriPlates™ (Qty 8)
Mounting Brackets (Qty 2)
5/16" x 3" Lag Bolts (wooden studs only...
Owner's Manual - Page 7
... is inverted, use a measuring tape to find the center of the flat panel
Figure 1
Figure 2
Installation Manual
Page - 7 -
PWM-F110
Mounting Bracket Installation
NOTE: Proper installation procedure by qualified personnel as outlined in serious personal injury and possible damage to the flat panel. Failure to do so could result in the installation instructions must be adhered to.
Owner's Manual - Page 8
Installation Manual Match the center of viewing guide with the centerline you marked in step 1 (Figure 4). 5 The mounting brackets are designed with a center of viewing guide on the back of the display (stamped arrows facing out) - (Figure 3).
Page - 8 -
Mounting Brackets
Figure 3
Bottom of them (Figure 5). Lay the mounting brackets on the side of Flat Panel
4. PWM-F110
3.
Owner's Manual - Page 9
... fit the hardware that your flat panel uses M8 x 20 Phillip screws, use the M8 mounting points (Figure 6).
7. PWM-F110
Mounting Bracket
CL
Bottom of Flat Panel
Center of Viewing Guide
Align the Mounting Brackets
Figure 4
Bottom of the Flat Panel
Figure 5
Center of Flat Panel
M4
M5
M6
M8
DIMPLES FACING DOWN
3/4"
Figure 6
Figure 7
Installation Manual
Page - 9 - The Griplates™...
Owner's Manual - Page 10
... have (3) 16" and (1) 24" mounting slot positions (see Technical Specifications on the wall
(Figure 9). NOTE: This marking will reference the center of your flat panel display once mounted on
Page 16)
2. Measure from the floor to the desired viewing height and mark the wall.
Installation Manual Using a (commercially available) wood stud finder, locate two 16" or 24" stud...
Owner's Manual - Page 11
... wall plate with the reference arrow pointing up to the marked wall. Mounting Surfaces Wood studs: Drill four (4) ¼" pilot holes to the reference line and mark the four (4) lag bolt mounting points through the wall plate slots on center - PWM-F110
3.
Drill Gun
Pilot Holes
16" 16"
Wall Plate Mounting Slots
Level
Figure 10
Wood Studs
Figure 11
Installation Manual...
Owner's Manual - Page 12
...
Page - 12 -
NOTE: Use a minimum diameter of 5/16" x 3" long wood screws.
Figure 12
Installation Manual Secure the plate using the four (4) 5/16" lag bolts and flat washers (supplied) -Figure 12. Level and secure the plate to the wall with the reference arrow facing up to the ceiling. 6. CAUTION: Do not over tighten the lag...
Owner's Manual - Page 13
...
Figure 13
5/16" x 2 ¼" wedge anchors (commercially available)
Installation Manual
Page - 13 - Level and secure the plate to the wall with the reference arrow facing up to the ceiling. 8. CAUTION: Do not over tighten the wedge anchors bolts. NOTE: Use a minimum diameter of 5/16" x 2 ¼" large concrete wedge anchors (commercially available) -
(Figure 13). PWM-F110
7.
Owner's Manual - Page 14
Installation Manual Raise the flat panel with the mounting brackets secured to the flat panel and insert the top hooks from each bracket to the rod from the wall plates (Figure 14).
FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE TO THE FLAT PANEL.
1. PWM-F110
Installing the Flat Panel Display
WARNING: AT LEAST (2) QUALIFIED PERSONNEL ARE STRONGLY RECOMMENDED FOR...
Owner's Manual - Page 15
PWM-F110
2.
NOTE: To remove the flat panel from the wall, simply back off the ¼"-20 screws using a Phillips
screwdriver and lift the unit of the mounting brackets. CAUTION: Do not over tighten the ¼"-20 screws to adjust your flat panel. Wall Plate
Wall Bumper
Figure 15
Installation Manual
Page - 15 - Use the wall bumper to the rods (Figure 15). Make...
Owner's Manual - Page 16
Leveling feet
(88.9)
(31.75)
(606.92) (49.53)
(127)
Page 16
(36.91)
Figure 16
Installation Manual Wall plate B. Mounting brackets C. ¼" x 20 Safety
screws D. PWM-F110
Technical Specifications
(406.4)
(406.4)
(711.2) (406.4)
A.
Owner's Manual - Page 17
...Manual
Page 17
Premier Mounts is not liable for improper installation that results in the completion of the installation.
Customer Service - (800) 368-9700 Ext. 224 Technical Support - Contact Premier Mounts
In the event of missing and/or damaged equipment, or technical questions, the following information can help in damage to mounts, adapters, display equipment or personal injury. PWM...
Pioneer PWM-F110 Reviews
We have not received any reviews for Pioneer yet.