Philips AZ8348 Support and Manuals
Get Help and Manuals for this Phillips item
View All Support Options Below
Free Philips AZ8348 manuals!
Problems with Philips AZ8348?
Ask a Question
Free Philips AZ8348 manuals!
Problems with Philips AZ8348?
Ask a Question
Popular Philips AZ8348 Manual Pages
User Manual - Page 2
...outlets, it should it be greater than 5 Amp. Before replacing the plug cover, make certain that the cord grip is ... the U.K.: Recording and playback of material may not correspond with the following code: blue = neutral (N), brown live (L). Note: The severed plug must ... 138/1989, Anexo V. not simply over the sheath of Philips
China Hong Kong Group Company Ltd. Lau Quality Manager
IMPORTANT ...
User Manual - Page 4
...quality, clean the indicated parts (:),el) after every 50 hours of packing materials, exhausted batteries and old equipment.
• All redundant packaging material has been omitted. POWER SUPPLY 5. CD PLAYER 7. TROUBLESHOOTING
4 4 5-6 6 ... slightly moistened with water is located at the rear of the set , batteries, CDs or cassettes to acclimatise. AVOID EXPO- x
• The lens may...
User Manual - Page 5
...B CD CONTROLS
13. CD: to switch to BAND - C) CD DOOR ® FM STEREO Indicator - Lights up when
power supply is being played;
- STOP/EJ(ect) - Fast forward.
what function
the unit is... CD
II: PAUSE
PGM: Program playback
REP 1: Repeat one /all
@ POWER Indicator - PLAY - Lights up when receiving FM stereo stations. ® Dial scale to CD mode/power ON. - Fast rewind...
User Manual - Page 6
... vary the length of the set) corresponds to your dealer or service organisation. • If the set is equipped with the 3-band...For AM/MW, the set is not needed. Not all versions) -
When fitting a mains plug, follow the instructions on the
type plate (...not, consult your local mains voltage. The POWER indicator* ® lights up. • Adjust the sound using the
TUNING control ®. ...
User Manual - Page 7
... PLAY/PAUSE C) to open the CD door by pressing OPEN • CLOSE ®;
- 6. The POWER indicator =.4 lights up .
• Close the cover.
- The CD-player scans the contents list of the CD
After that, the... number of tracks will then appear
in the sun.)
PLAYING A CD
• Set the FUNCTION switch ® to 'the CD.
• Always hold the CD at the edge and always...
User Manual - Page 8
REP lights up ;
Then, CC appears again. • Press PROG one more time. -
then at maximum speed, with a ...forwards to stop the CD being repeated.
® Repeating the CD
• Press REPEAT twice before or during play . - REP 1 lights up ; 6. the track will start again from the selected track. CD PLAYER
Selecting another track during play
• PressI*4 orr.siguntil the...
User Manual - Page 9
...render this safeguard ineffective, cover
the hole with deck A. -
The POWER indicator *@ lights up
- The set is permissible insofar
copyright or other rights of the tape,
no
buttons are pressed. ...PAUSE@ or ©.
- TION switch ® is no longer possible. Continuous play • Set the FUNCTION switch ® to excessive heat. (E.g. The POWER indicator *0 goes out.
•...
User Manual - Page 10
...ect)© to :
-
The POWER indicator *© goes out.
• Set the RECORD MODE switch g to open .
• The set is lights up . • It's not necessary to the desired position.
• If... during dubbing, you press PAUSE on
deck A, a blank part will start from the beginning of the CD (or from the radio • Set the FUNCTION selector® to the minimum
volume level (during...
User Manual - Page 11
...repair the set , disconnect the mains
plug, reconnect after a few seconds. Batteries are exhausted • Insert fresh batteries
- Poor radio reception
- Interference caused by following these hints, consult your dealer or service...
- TROUBLESHOOTING
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set - VOLUME is damaged or dirty • Replace or ...
Philips AZ8348 Reviews
We have not received any reviews for Philips yet.