Optoma EH515 Support and Manuals
Get Help and Manuals for this Optoma item
View All Support Options Below
Free Optoma EH515 manuals!
Problems with Optoma EH515?
Ask a Question
Free Optoma EH515 manuals!
Problems with Optoma EH515?
Ask a Question
Popular Optoma EH515 Manual Pages
User manual - Page 1
DLP® Projector
User manual
User manual - Page 2
... 4
Important Safety Instruction...4 3D Safety Information...5 Copyright...6 Disclaimer...6 Trademark Recognition...6 FCC...7 Declaration of Conformity for EU countries 7 WEEE...7
INTRODUCTION 8
Package Overview...8 Standard accessories...8 Optional accessories...8 Product Overview...9 Connections...10 Keypad...11 Remote...12
SETUP AND INSTALLATION 13
Installing the projector...13 Connecting...
User manual - Page 3
... settings menu 62 3D Setup...63
maintenance 64
Replacing the lamp...64 Replacing the lamp (continued 65 Installing and cleaning the dust filter 66
additional information 67
Compatible resolutions...67 Image size and projection distance 70 Determining the lens shift center position 73 Projector dimensions and ceiling mount installation 76 RS232 protocol function list...77 IR remote codes...
User manual - Page 5
Follow instructions as described on -screen display "Options|Lamp Settings" menu after
replacing the lamp module (refer to page 58). ‡‡ When switching the projector off and unplug the power... are sleep deprived or under "Replacing the Lamp" section on pages 64-65.
‡‡ Do not setup the projector in 3D and should be repaired by appropriate service personnel. ‡‡ Only ...
User manual - Page 8
...only supplied in some specific regions. Some accessories may not be available depending on model, specification and region. Standard accessories
Projector
On
Off
Test ...Manual Warranty Card EMEA Warranty Card Basic User Manual
Documentation
Optional accessories
Carry bag
Lens cap
VGA cable
Note: Optional accessories vary depending on the model, specification...
User manual - Page 33
... appears to exit the menu.
Use this function to manually tune and saved in the settings after that for next time projector turns off and on again. Position
to match the frequency..."Signal" is only supported in Analog VGA (RGB) signal.
‡‡ If "Signal" is automatic, the phase, frequency items are saved in settings after that for the next time projector is not automatic, the...
User manual - Page 39
...settings for VESA 3D Glasses.
‡‡ 3D: Display 3D signal. ‡‡ L (Left): Display the left and right frame contents.
‡‡ Exit
Press the "Off" for default frame contents. DLP-Link: Select "DLP... Sequential" format.
‡‡ "3D Format" is only supported on 3D Timing on page 69.
‡‡ "3D Format" is only supported on non-HDMI 1.4a 3D timing. 3D Sync. Choose "...
User manual - Page 43
...
confirm. 3. Use number button or on the remote, then press "Enter" to set the number of the password, then press enter to be requested to enter your local office for support. USING THE PROJECTOR
Setup Security menu
Security
SETUP Security
Security Timer
Change Password
Off Exit
Security
‡‡ On: Choose "On" to use the up/down...
User manual - Page 45
...apply the entered values. English 45 USING THE PROJECTOR
Setup network LAN settings menu
SETUP Network : LAN Settings Network Status
Connected
MAC Address
DHCP
Off
IP ... your network. ‡‡ Off: To assign IP, Subnet Mask, Gateway and DNS configuration manually.
Gateway Display the default gateway of the network connected to exit the menu.
Subnet Mask Display subnet ...
User manual - Page 48
... the Support-Service directly.
48 English http://www.crestron.com/ This projector is supported by JBMIA. Source, Sound-Mute, etc. Projector
(Ethernet)
Wired LAN terminal functionalities This projector can be controlled by using a PC (laptop) or other
countries by the specified commands of Crestron Electronics, Inc. USING THE PROJECTOR
Setup network control settings menu
LAN_RJ45...
User manual - Page 58
... the projector lamp which will lower power consumption and extend the lamp life.
‡ ‡ Note:
Power: Choose this function to show or to Eco automatically.
‡‡ Power
"Lamp Mode" can be independently set the projector power setting manually.
‡‡ When ambient temperature is over 40°C in operating, the projector will appear 30 hours before suggested replacement...
User manual - Page 63
... "3D format" and switch to adjust the settings in the menu. For example, 3D Blu ray, Games console, PC, Set top box, etc. 3. Your projector will either be displayed side by side images ...displayed. USING THE PROJECTOR
3D Setup
1.
Turn this on page 69. Depending on your projector. 2. Turn on the 3D content the image will automatically be connected to select DLP Link or VESA in...
User manual - Page 89
... if the projection lamp has been securely installed. Please refer to the "Replacing the Lamp" section. ‡‡ Make sure you have removed the lens cap and the projector is switched on. ‡‡ Ensure that it is still stretched, you experience a problem with your projector, please refer to the following : ‡‡ Please setup the display format...
Data Sheet - Page 1
... a short or long distance Vertical/ Horizontal keystone and lens shift for various applications Bright Projection at 5500 ANSI lumens for large installations Full Control over LAN and RS-232 using Crestron, IP Link, Extron PJ-Link, and Telnet Two 10-Watt speakers for excellent sound
The Optoma EH515 is a Full HD professional Installation projector, ideal for...
Data Sheet - Page 2
...
13.5" 6.3"
OPTICAL/TECHNICAL SPECIFICATIONS
Display Technology Single 0.65" 1080p chip, DLP® Technology by Texas ...USB (service) 5. Display Port 8. Power 3. S-Video 11. HDMI1-In (MHL) 6. manual focus
Optical Zoom
1.8x Manual zoom
... EH515 - 1080p: Perfect for details)
Aspect Ratio
16:9 (Native), 4:3, Auto
Throw Ratio
1.2:1~2.16:1
Projection Distance
4....
Optoma EH515 Reviews
We have not received any reviews for Optoma yet.