KitchenAid KFGC558JPA Support and Manuals
Get Help and Manuals for this KitchenAid item
View All Support Options Below
Free KitchenAid KFGC558JPA manuals!
Problems with KitchenAid KFGC558JPA?
Ask a Question
Free KitchenAid KFGC558JPA manuals!
Problems with KitchenAid KFGC558JPA?
Ask a Question
KitchenAid KFGC558JPA Videos
KitchenAid KFGC558JPA Range
Duration: :36
Total Views: 4
Duration: :36
Total Views: 4
KitchenAid KFGC558JPA Cuisinière
Duration: :35
Total Views: 0
Duration: :35
Total Views: 0
Popular KitchenAid KFGC558JPA Manual Pages
Owners Manual - Page 4
...-top service without anti-tip bracket installed and engaged.
SAVE THESE INSTRUCTIONS
4 Verify the anti-tip bracket has been properly installed and engaged per installation instructions. Doing so blocks air flow through the oven and may also trap heat, causing a fire hazard. I Use Only Dry Potholders - children climbing on the Range - Do not repair or replace any part of...
Owners Manual - Page 16
... Select the desired temperature for the SAID code on the lower right of the front side... cooking temperatures and times
■■ Set cook timer
■■ Save favorite cooking...information.
Wi-Fi Connectivity and Remote Operation
Models are provided with a Wi-Fi module that...Internet Connectivity Guide" for either Oven Knob and Start Button can be scanned or manually added. ...
Owners Manual - Page 23
... can also be adjusted, contact a trained repair specialist.
4. Replace burner cap.
Use a straight pin. Burner...
2. Clean food spills.
1
1 Incorrect 2 Correct
2
To preserve the finish, clean food spills containing acids, such as vinegar and tomato, as soon as the entire appliance is cool. If the burner still does not light, do not service...
Owners Manual - Page 30
...burner and contact a service technician. See the Installation Instructions for disabling.
It...TROUBLESHOOTING
First try the solutions suggested here.
Push in keeping with a straight pin.
Surface burner flames are not positioned properly. The proper cookware is not level. On 48" (121.9 cm) ranges, one oven is set correctly. Close the oven door all the way. If the problem...
Owners Manual - Page 31
... avoid a service call, refer... not positioned properly.
The racks are followed when setting the desired function, the oven will preheat before cooking. TROUBLESHOOTING
First try the solutions suggested here. The oven was...recommendations that batter is not evenly distributed in the pan.
Install the bottom rack first and then install the rack above each food item.
In Canada, visit ...
Owners Manual - Page 32
... 200 - 6750 Century Ave.
ASSISTANCE OR SERVICE
Before calling for assistance or service, please check "Troubleshooting."
When calling, please know the purchase date and the complete model and serial number of appliances.
■■ Installation information.
■■ Use and maintenance procedures.
■■ Accessory and repair parts sales.
■■ Specialized...
Installation Instructions - Page 5
.../rating plate location/SAID label
(located on griddle models)
Parts Needed
■ All models must conform with the current standards CAN/CSA-A240-latest edition or with local codes. See "Cabinet Dimensions" in the "Location Requirements" section for Manufactured Home Installations, ANSI A225.1/NFPA 501A or local codes. Do not obstruct flow of securing the range...
Installation Instructions - Page 8
...the model/serial...service technician. The parts...Install a manual gas line shut-off valve open position C. Flexible metal appliance connector:
■ If local codes permit, a new CSA design-certified, 4-5 ft (122-152 cm) long, 5/8" (1.6 cm) or 3/4" (1.9 cm) I.D., flexible metal appliance connector may crack the regulator and cause a gas leak. Type of Gas
Natural Gas: This range is factory set...
Installation Instructions - Page 9
...parts package from range. a. Remove kick plate from top of range and grate pack. Lift range up about 3" (8.0 cm) and move and install... or more people to remove the oven door(s). Set range on top of the
unit. Remove Door
... packaging material. INSTALLATION INSTRUCTIONS
WARNING
Unpack the Range
2. For 48" (121.9 cm) models only, rotate center support counterclockwise off shipping...
Installation Instructions - Page 12
...Install Griddle Tray
(On griddle models)
The griddle is indicated.
Griddle drip tray B. Clean griddle before using. Refer to the user instructions located in the Use and Care Guide... caps, and grates from parts package. Check that burner caps are factory set to slide into the slot...service company for the rear leveling leg to the
open when the handle is lit, it stops. Open the manual...
Installation Instructions - Page 15
... or N)
6. Replace burner cap. 9. Adjusting Simmer Low Setting on the model/serial/rating plate....and the letters "LP" are installed, remove them. 2. NOTE: ...driver to help hold the control console in excess of the gas supply piping system at least 1" (2.5 cm) water column pressure above 1/2 psi (3.5 kPa) gauge (14" [35.6 cm] WCP)
The range and its individual manual...parts bag for Propane
1.
Installation Instructions - Page 18
...bracket.
10. Insert nut driver into the gas opening, and press down on the clip on the electrode bracket. Propane gas orifice spud
8. B A
A B
A. Set gas orifice spud aside. ...Pull electrode out of a 1/4" (6.4 mm) nut driver to help hold the gas orifice spud in plastic parts bag for illustration.
13.
Replace oven bake burner electrode inside bracket.
Reinstall the oven...
Installation Instructions - Page 19
...
Convert Oven Broil Burner (30" [76.2 cm] and 36" [91.4 cm] models and the right oven cavity on the oven bake burner cover with a letter and a number. Using a 1/4" (6.4 mm) nut driver, remove broil burner screw. Oven back B. Broil burner orifice C. Install the Number 90 oven broil burner orifice spud.
5.
Broil burner C. Broil burner...
Installation Instructions - Page 23
...manual ...parts...set pressure. Apply masking tape to help hold the control console in the side brackets properly once it . Set propane gas orifice spud aside. Replace...driver into the gas opening and press down onto the gas orifice spud and remove by closing its individual shut-off valve during any pressure testing of the range that the hollow end faces in and the letters "NAT" are installed...
Installation Instructions - Page 27
... burner electrode C. A. Set propane gas orifice spud aside. Bracket
Broil burner hanging in back of a 1/4" (6.4 mm) nut driver to help hold the gas orifice spud in the nut driver while changing it slides out of the hole in plastic parts bag for illustration. Insert nut driver into the narrow ends of the oven.
2. Install the Number...
KitchenAid KFGC558JPA Reviews
We have not received any reviews for KitchenAid yet.