Kenwood LSF-1010 Support and Manuals
Get Help and Manuals for this Kenwood item
View All Support Options Below
Free Kenwood LSF-1010 manuals!
Problems with Kenwood LSF-1010?
Ask a Question
Free Kenwood LSF-1010 manuals!
Problems with Kenwood LSF-1010?
Ask a Question
Popular Kenwood LSF-1010 Manual Pages
User Manual - Page 2
... designed for operation as follows. NO USER-SERVICEABLE PARTS INSIDE. Europe and U.K AC 230 V only
Safety precautions
LSF-1010 (EN)
Caution : Read this section carefully...TRIANGLE IS INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE. ESPAÑOL
ITALIANO
NEDERLANDS
DEUTSCH
FRANÇAIS...
User Manual - Page 3
... ÷ One subwoofer
÷ Two satellite speakers and stands
KENWOOD
(SW-1010)
Accessories
÷ Pin-plug audio cable
÷ Two speaker cords
Contents
Introduction 3
LSF-1010 (EN)
Caution : Read the pages marked carefully to Set Up the Satellite Speakers 18 Maintenance 23 Troubleshooting 24 Specifications 25
DEUTSCH
NEDERLANDS
ITALIANO
÷ Four cushions for subwoofer
÷...
User Manual - Page 4
... at least 10 cm away from battery power, or other sources, refer to replace your dealer or nearest service center. Never remove the enclosure. If the internal parts are provided for example, near a bathtub, washbowl, kitchen sink, laundry tub, in the instruction manual or as a hair-pin or a needle, comes into the enclosure through openings...
User Manual - Page 5
...service or repairs to this appliance, ask the service technician to perform safety checks to the AC outlet on the rear panel. Replacement parts - Upon completion of overhead power lines or other audio equipment with them might be serviced by following the instruction manual... requiring service - 5
IMPORTANT SAFEGUARDS
LSF-1010 (EN)
Caution : Read this page carefully to rain or water.
User Manual - Page 6
...LSF-1010 (EN)
The subwoofer can position the subwoofer vertically or horizontally. ESPAÑOL For detail, see page 8 "Setting Up the Satellite Speakers"
KENWOOD
Vertical Orientation
Horizontal Orientation
KENWOOD...
KENWOOD
ITALIANO
KENWOOD
• You can be positioned either vertically or horizontally.
FRANÇAIS
6 Location and Orientation
Satellite Speakers
For standard setup,...
User Manual - Page 7
...TV. 2 Set up according to a TV set.
You can correct the problem by reducing ... If installing close to a TV, however, be installed close to the ...LSF-1010 (EN)
Subwoofer and Satellite Speaker Magnetic Shielding and TV Color Reception
The speakers (subwoofer and satellite speaker) include magnetic shielding and can therefore be sure to minimum level. You can correct the problem...
User Manual - Page 8
... and washer to fasten the speaker to set them up without the stand.
As an alternative to the standard setup, it is also possible to mount the speakers onto a wall or to the arm.
LSF-1010 (EN)
Use the speaker screw and washer... of the corresponding screw, and then tighten the screw. Curl the wire around the thin part of the stand base.
Arm
Cord
Pass the cord through the arm.
User Manual - Page 12
...set of terminals (rather than connecting Note them to work with 6-ohm speakers.
Make all connections. FRANÇAIS
12
Connecting to Amp's Speaker Output Terminals
Making Connections
LSF-1010...have a nominal impedance of 6 ohms. Be sure that your amplifier or receiver has two sets of speaker output terminals, you have finished making all connections using speaker cord. Please purchase this...
User Manual - Page 13
...installed vertically. If installing ...set of terminals for connection to speaker amps, and must be sure to use pin-plug cables with the subwoofer.)
Pin-plug audio cable (purchased separately)
Making Connections 13
LSF-1010... (EN)
CAUTION
Do not plug in loss of sound. Bending of plugs may become bent if the subwoofer is also possible to connect the subwoofer's LINE IN jacks to manually...
User Manual - Page 14
...and Their Functions
Subwoofer
1 POWER switch Press this switch to set the subwoofer's power on or off.
2 POWER indicator ...adjuster dial 4 PHASE switch 5 TURNOVER FREQUENCY adjuster dial
Adjusting the Sound
LSF-1010 (EN)
The VOLUME, TURNOVER FREQUENCY, and PHASE controls allow you to... of the sound you encounter either of the following problems. • If the interaction of the subwoofer. ...
User Manual - Page 17
Loosen the screws.
2 Loosen the two arm screws further to the desired angle. LSF-1010 (EN)
At time of shipping, the arm is likely to tip over) if mounted at ... jack. Insert and fasten the arm.
1 Fit the arm through the openings in place.
2 Replace the screw caps.
3 Reconnect the speaker cord to E indicated at the selected angle.
3 Now set the other arm holder (the holder on the arm.
User Manual - Page 18
...information about how to remove/replace the screw caps and loosen ...DEUTSCH
18 Other Ways to Set Up the Satellite Speakers
As an alternative to the standard setup, you just removed so ...Set the arm so that you want to readjust the angle of the clip. See "Adjusting the Speaker Angle," on the side that one rib of the arm goes through the hole in the top of the speaker on the arm. LSF-1010...
User Manual - Page 19
... in place with plastic insulation.
LSF-1010 (EN)
1 Take one of installation, please consult a contractor or other qualified person before proceeding to Set Up the Satellite Speakers
2. Remove the plastic insulation from the arm holders.
19
Other Ways to mount the stand onto the wall.
For information about the wall's support strength, the type of...
User Manual - Page 20
Attach and fasten the arm.
See "Adjusting the Speaker Angle," on the arm. LSF-1010 (EN)
1 Fit the arm through which speaker cord can do not neglect to Set Up the Satellite Speakers
5. Allow the head of the base) over the arm screws.
3 Reconnect the speaker cord to the jack.
1 First adhere the non...
User Manual - Page 25
...;OL
1.KENWOOD follows a policy of continuous advancements in development. FRANÇAIS
Specifications
Satellite speaker...
*1: Dimensions may vary depending on the setting up of the satellite speakers.
*2: Stand included.
25
LSF-1010 (EN)
Subwoofer
System Subwoofer system with built... Bass-reflex type (Passive radiator system)
Loudspeakers
Driver 100 mm (4 ") Cone type
Passive radiator...
Kenwood LSF-1010 Reviews
We have not received any reviews for Kenwood yet.