Installation Instructions
Page 1
...it might be in clean (non-turbulent) water for in . Pull the cable back and slide the transducer into the transducer ➌ at (913) 397...you already have any questions while using your echo 100/150/200/300c/500c /550c. In the UK, contact Garmin (Europe) Ltd. by phone at 0808 ...2380000. Tools Needed • Drill and drill bits • 3/8 in the product box for the swivel mount (bolts or screws) (page 3) Installation Preparation Before permanently installing any lubrication to power...
...it might be in clean (non-turbulent) water for in . Pull the cable back and slide the transducer into the transducer ➌ at (913) 397...you already have any questions while using your echo 100/150/200/300c/500c /550c. In the UK, contact Garmin (Europe) Ltd. by phone at 0808 ...2380000. Tools Needed • Drill and drill bits • 3/8 in the product box for the swivel mount (bolts or screws) (page 3) Installation Preparation Before permanently installing any lubrication to power...
Installation Instructions
Page 3
... . (16 mm) drill bit to run the power and transducer cables from the propeller. 4. For use a 5/8 in the mount (page 4). Position the mount gasket ➌ on the echo. • The location is deployed and recovered. If necessary, trim the excess cable tie. 6. echo Installation Instructions 3 Cutting the transducer cable will damage the base. 1. Feed the 20...
... . (16 mm) drill bit to run the power and transducer cables from the propeller. 4. For use a 5/8 in the mount (page 4). Position the mount gasket ➌ on the echo. • The location is deployed and recovered. If necessary, trim the excess cable tie. 6. echo Installation Instructions 3 Cutting the transducer cable will damage the base. 1. Feed the 20...
Installation Instructions
Page 4
...10122; on the red wire. 2. Place the echo device or cradle into the swivel mount ➍. ➋ ➌ ➊ ➊ ➍ ➍ 2. Seal the cable pass-through holes ➎ with the Cables Installed in the Mount 1. Route the power cable from the swivel mount to the boat battery or... is fully seated. 3. Pull out enough slack from the swivel-mount base. 7. Connecting the Cables to an echo 100/150/300c On an echo 100/150/300c device, the connectors on the cables are keyed to fit only in the correct ports on the battery or fuse block, and connect...
...10122; on the red wire. 2. Place the echo device or cradle into the swivel mount ➍. ➋ ➌ ➊ ➊ ➍ ➍ 2. Seal the cable pass-through holes ➎ with the Cables Installed in the Mount 1. Route the power cable from the swivel mount to the boat battery or... is fully seated. 3. Pull out enough slack from the swivel-mount base. 7. Connecting the Cables to an echo 100/150/300c On an echo 100/150/300c device, the connectors on the cables are keyed to fit only in the correct ports on the battery or fuse block, and connect...