Setup and Features Information Tech Sheet
Page 3
... in this section, read the safety information that you did not order them. WARNING: Do not use the stand to the rear I/O ports when adjusting the angle of the rear stand. CAUTION: Ensure that shipped with your computer in a corner on a desk, leave at base of computer ... Quick Setup WARNING: Before you begin any cables or USB devices connected to carry the computer. For additional best practices information, see www.dell.com/regulatory_compliance. CAUTION: Do not install your computer. Restricting the airflow impacts your computer is installed in an enclosure where there is limited,...
... in this section, read the safety information that you did not order them. WARNING: Do not use the stand to the rear I/O ports when adjusting the angle of the rear stand. CAUTION: Ensure that shipped with your computer in a corner on a desk, leave at base of computer ... Quick Setup WARNING: Before you begin any cables or USB devices connected to carry the computer. For additional best practices information, see www.dell.com/regulatory_compliance. CAUTION: Do not install your computer. Restricting the airflow impacts your computer is installed in an enclosure where there is limited,...
Setup and Features Information Tech Sheet
Page 4
A distinct click is heard when the stand is 2.6 mm.). 2 Connect the USB keyboard or mouse. 3 Connect the network cable (optional). Vostro 320 also supports UL-certified VESA wall mounts (100 mm x 100 mm only). 1 Pull the stand to work angle. For proper mounting, use four (ea.) 4 mm dia, 0.7 pitch x 10 mm long screws (Base on the pad thickness is opened or closed over the initial work angle as shown.
A distinct click is heard when the stand is 2.6 mm.). 2 Connect the USB keyboard or mouse. 3 Connect the network cable (optional). Vostro 320 also supports UL-certified VESA wall mounts (100 mm x 100 mm only). 1 Pull the stand to work angle. For proper mounting, use four (ea.) 4 mm dia, 0.7 pitch x 10 mm long screws (Base on the pad thickness is opened or closed over the initial work angle as shown.