User Guide
Page 3
... be provided. If a Registration Card for the product in question has not been returned to levy a reasonable handling charge in addition mailing or shipping costs. DSL-200 ADSL USB Modem User's Guide Limited Warranty Hardware: D-Link warrants its software products will perform in substantial conformance with the applicable product documentation provided by...
... be provided. If a Registration Card for the product in question has not been returned to levy a reasonable handling charge in addition mailing or shipping costs. DSL-200 ADSL USB Modem User's Guide Limited Warranty Hardware: D-Link warrants its software products will perform in substantial conformance with the applicable product documentation provided by...
User Guide
Page 4
...uninterrupted or absolutely error-free, and no warranty that all defects in combination with product which D-Link provides its Authorized Reseller. DSL-200 ADSL USB Modem User's Guide purchase from D-Link or its software product, against failure during the same warranty period. LIMITATION OF LIABILITY IN ...NO EVENT WILL D-LINK BE LIABLE FOR ANY DAMAGES, INCLUDING LOSS OF DATA, LOSS OF PROFITS, COST OF ...
...uninterrupted or absolutely error-free, and no warranty that all defects in combination with product which D-Link provides its Authorized Reseller. DSL-200 ADSL USB Modem User's Guide purchase from D-Link or its software product, against failure during the same warranty period. LIMITATION OF LIABILITY IN ...NO EVENT WILL D-LINK BE LIABLE FOR ANY DAMAGES, INCLUDING LOSS OF DATA, LOSS OF PROFITS, COST OF ...
User Guide
Page 5
... cause harmful interference, and (2) this device must accept any derivative such as stipulated by any means or used in a particular installation. Trademarks DSL-200 ADSL USB Modem User's Guide Copyright ©2003 D-Link Corporation. These limits are designed to provide reasonable protection against harmful interference in which can radiate radio frequency energy and, if not installed...
... cause harmful interference, and (2) this device must accept any derivative such as stipulated by any means or used in a particular installation. Trademarks DSL-200 ADSL USB Modem User's Guide Copyright ©2003 D-Link Corporation. These limits are designed to provide reasonable protection against harmful interference in which can radiate radio frequency energy and, if not installed...
User Guide
Page 6
Table of Contents OVERVIEW OF THE USER'S GUIDE ...6 OPERATING SYSTEMS ...7 ü USB Port...7 MICROFILTERS AND SPLITTERS...7 Microfilters ...8 Line Splitter ...8 ADSL Service...8 ADSL Service...9 Network Protocol and the Software Driver ...9 Encapsulation Method...9 Modulation Technique...9 2 INTRODUCTION ...11 WHAT IS ADSL? ...11 MODEM DESCRIPTION AND OPERATION ...11 PRODUCT FEATURES ...12 Rear Panel ...12 Front Panel...13 LED Indicators ...13...
Table of Contents OVERVIEW OF THE USER'S GUIDE ...6 OPERATING SYSTEMS ...7 ü USB Port...7 MICROFILTERS AND SPLITTERS...7 Microfilters ...8 Line Splitter ...8 ADSL Service...8 ADSL Service...9 Network Protocol and the Software Driver ...9 Encapsulation Method...9 Modulation Technique...9 2 INTRODUCTION ...11 WHAT IS ADSL? ...11 MODEM DESCRIPTION AND OPERATION ...11 PRODUCT FEATURES ...12 Rear Panel ...12 Front Panel...13 LED Indicators ...13...
User Guide
Page 7
... provider may be your DSL-200 ADSL USB Modem and use it to connect to uninstall the Modem and its features. ♦ Chapter 2 - This guide uses the generic terms DSL service provider and network service provider, to refer to any business or agent that specializes in providing network services or a combination of any of these. ...
... provider may be your DSL-200 ADSL USB Modem and use it to connect to uninstall the Modem and its features. ♦ Chapter 2 - This guide uses the generic terms DSL service provider and network service provider, to refer to any business or agent that specializes in providing network services or a combination of any of these. ...
User Guide
Page 8
... install and use standard telephone connectors and cable. Before You Start In addition to the Modem hardware and software drivers, you will to gather information before you do not need a USB (Universal Serial Bus) type B port on newer computers, however older PCs may require ...technician to the Windows OS, you information required for proper installation of filter device. Operating Systems The D-Link DSL-200 can be required to install a simple device that prevents the ADSL line from interfering with PCs running Microsoft® Windows 98, Windows 98 Second Edition, Windows 2000, ...
... install and use standard telephone connectors and cable. Before You Start In addition to the Modem hardware and software drivers, you will to gather information before you do not need a USB (Universal Serial Bus) type B port on newer computers, however older PCs may require ...technician to the Windows OS, you information required for proper installation of filter device. Operating Systems The D-Link DSL-200 can be required to install a simple device that prevents the ADSL line from interfering with PCs running Microsoft® Windows 98, Windows 98 Second Edition, Windows 2000, ...
User Guide
Page 12
... it possible to enjoy benefits such as they are ideal for business and residential customers. Modem Description and Operation The DSL-200 ADSL USB Modem is ADSL? Software drivers for D-Link ADSL USB Modems can be found at speeds of up to 8 Mbps downstream (to the user) and up time and simplifying connectivity issues. What is easy to install and use digital...
... it possible to enjoy benefits such as they are ideal for business and residential customers. Modem Description and Operation The DSL-200 ADSL USB Modem is ADSL? Software drivers for D-Link ADSL USB Modems can be found at speeds of up to 8 Mbps downstream (to the user) and up time and simplifying connectivity issues. What is easy to install and use digital...
User Guide
Page 13
Product Features The D-Link DSL-200 Modem provides the following features: Ø G.hs compliant (Auto-handshake) Ø G.dmt full rate compliant Ø G.lite compliant Ø RFC 2684 (Bridged Ethernet) compliant Ø RFC ... PPP over Ethernet compliant Ø Compatible with all T1.413 issue 2 (full rate DMT over analog POTS), and CO DSLAM equipment Ø Compliant with USB Specification Revision 1.1 Ø USB interface to PC host Ø Plug and Play installation Ø Easy to upgrade software Ø GUI based configuration and diagnostic tool Ø Supports...
Product Features The D-Link DSL-200 Modem provides the following features: Ø G.hs compliant (Auto-handshake) Ø G.dmt full rate compliant Ø G.lite compliant Ø RFC 2684 (Bridged Ethernet) compliant Ø RFC ... PPP over Ethernet compliant Ø Compatible with all T1.413 issue 2 (full rate DMT over analog POTS), and CO DSLAM equipment Ø Compliant with USB Specification Revision 1.1 Ø USB interface to PC host Ø Plug and Play installation Ø Easy to upgrade software Ø GUI based configuration and diagnostic tool Ø Supports...
User Guide
Page 15
...able to view the LEDs. Insert the other end of the ADSL cable (26 AWG twisted-pair telephone cable) into the ADSL port (RJ-11 port) on the Modem. 4. You will initiate the Found New Hardware process. Connecting the USB cable at this point will be placed in a location so ... port). 3. Follow the software installation instructions in Chapter 3. Insert the Installation CD into the CD-ROM drive. 2. Make certain it is the ADSL cable. 2 3 MODEM INSTALLATION Before you connect the USB cable, you must install the software driver before you connect the device to your computer via the...
...able to view the LEDs. Insert the other end of the ADSL cable (26 AWG twisted-pair telephone cable) into the ADSL port (RJ-11 port) on the Modem. 4. You will initiate the Found New Hardware process. Connecting the USB cable at this point will be placed in a location so ... port). 3. Follow the software installation instructions in Chapter 3. Insert the Installation CD into the CD-ROM drive. 2. Make certain it is the ADSL cable. 2 3 MODEM INSTALLATION Before you connect the USB cable, you must install the software driver before you connect the device to your computer via the...
User Guide
Page 22
11. The USB Modem will be detected and messages will appear notifying you to plug your computer. The Found New Hardware screen will be displayed as the modem software is currently installing it. After the files are downloaded, another Installing screen will prompt you that your computer has detected the modem and is installed. 12. Plug the rectangular end of the USB cable into the USB port of your PC, and then plug the square end of the USB cable into your modem into the USB port of the ADSL Modem.
11. The USB Modem will be detected and messages will appear notifying you to plug your computer. The Found New Hardware screen will be displayed as the modem software is currently installing it. After the files are downloaded, another Installing screen will prompt you that your computer has detected the modem and is installed. 12. Plug the rectangular end of the USB cable into the USB port of your PC, and then plug the square end of the USB cable into your modem into the USB port of the ADSL Modem.
User Guide
Page 24
... your desktop. LED Indicators The other LED indicator on the Modem. The table below . This LED will light up when the ADSL connection has been established. Desktop Monitoring A new icon will ... will light up when the USB cable is inserted. The connection may have been lost. The other way to interpret the icon indicator. System Tray Icon ADSL Status Training Both arrows will... The Down arrow appears light green when data is to view the ADSL Link indicator on the front of your ADSL connection. These colored arrows will alternate yellow and brown in either direction...
... your desktop. LED Indicators The other LED indicator on the Modem. The table below . This LED will light up when the ADSL connection has been established. Desktop Monitoring A new icon will ... will light up when the USB cable is inserted. The connection may have been lost. The other way to interpret the icon indicator. System Tray Icon ADSL Status Training Both arrows will... The Down arrow appears light green when data is to view the ADSL Link indicator on the front of your ADSL connection. These colored arrows will alternate yellow and brown in either direction...
User Guide
Page 27
... option. Type in your domain name in the Host: field. You need to restart your ADSL connection uses either the RFC 2684 or the RFC 1577 protocol, you have up to you by your DSL service provider: ü IP Address ü Subnet Mask ü Gateway ü DNS ...Click Yes. Click the Properties button. 4. From the Start menu, select Settings, Control Panel, and then double-click on TCP/IPà D-Link DSL-200 USB ADSL Modem 3. Select the Configuration tab, scroll down the installed network components list and click on the Network icon. 2. Enter the IP Address and Subnet ...
... option. Type in your domain name in the Host: field. You need to restart your ADSL connection uses either the RFC 2684 or the RFC 1577 protocol, you have up to you by your DSL service provider: ü IP Address ü Subnet Mask ü Gateway ü DNS ...Click Yes. Click the Properties button. 4. From the Start menu, select Settings, Control Panel, and then double-click on TCP/IPà D-Link DSL-200 USB ADSL Modem 3. Select the Configuration tab, scroll down the installed network components list and click on the Network icon. 2. Enter the IP Address and Subnet ...
User Guide
Page 28
Windows 2000 or Windows XP (LAN Driver) 1. Double-click on the Local Area Connection for the D-Link DSL-200 USB ADSL Modem. 3. The Network and Dial-up Connection window appears. The Local Area Connection window appears. The General tab will again appear. Click OK. 6. Right click on ...), then click on Properties. 4. Click OK. 5. Under the General tab, select Use the following IP address. Close this window to you by your ISP or ADSL service provider. The Network and Dial-up Connections window appears.
Windows 2000 or Windows XP (LAN Driver) 1. Double-click on the Local Area Connection for the D-Link DSL-200 USB ADSL Modem. 3. The Network and Dial-up Connection window appears. The Local Area Connection window appears. The General tab will again appear. Click OK. 6. Right click on ...), then click on Properties. 4. Click OK. 5. Under the General tab, select Use the following IP address. Close this window to you by your ISP or ADSL service provider. The Network and Dial-up Connections window appears.