Hardware Installation Guide
Page 100
... the router. Green when cells or frames are compatible with WIC-1SHDSL-V2 interface card Mode 2-wire ATM 2-wire T1/E1 in back-to the WIC-1SHDSL-V2 and WIC-1SHDSL-V3 interface cards. Applies only to -back configurations 4-wire ATM Cisco Platforms • Cisco 1721 • Cisco 1751 • Cisco 1760 • Cisco 1841 • Cisco 26xxXM • Cisco...
... the router. Green when cells or frames are compatible with WIC-1SHDSL-V2 interface card Mode 2-wire ATM 2-wire T1/E1 in back-to the WIC-1SHDSL-V2 and WIC-1SHDSL-V3 interface cards. Applies only to -back configurations 4-wire ATM Cisco Platforms • Cisco 1721 • Cisco 1751 • Cisco 1760 • Cisco 1841 • Cisco 26xxXM • Cisco...
Hardware Installation Guide
Page 119
Note Cisco 2600XM series, Cisco 2691, Cisco 2800 series, Cisco 3600 series, Cisco 3700 series, and Cisco 3800 series routers support DID on page 13. The Cisco 1760 router can support four 4-port FXS/DID VICs, up to a maximum of eight DID ports. The intrabuilding cable must be shielded and the...VIC, see the "Analog Direct Inward Dial (DID) Interface Cards" section on the 4-port FXS/DID cards in Cisco IOS Release 12.3(14)T and later. Note The Cisco 1751 router can be configured as either Foreign Exchange Station (FXS) or Direct Inward Dial (DID) when it is greater than 1, all four...
Note Cisco 2600XM series, Cisco 2691, Cisco 2800 series, Cisco 3600 series, Cisco 3700 series, and Cisco 3800 series routers support DID on page 13. The Cisco 1760 router can support four 4-port FXS/DID VICs, up to a maximum of eight DID ports. The intrabuilding cable must be shielded and the...VIC, see the "Analog Direct Inward Dial (DID) Interface Cards" section on the 4-port FXS/DID cards in Cisco IOS Release 12.3(14)T and later. Note The Cisco 1751 router can be configured as either Foreign Exchange Station (FXS) or Direct Inward Dial (DID) when it is greater than 1, all four...
Hardware Installation Guide
Page 136
... 12.0(7)T feature module • Analog Centralized Automatic Message Accounting E911 Trunk • Configuring 2-Port ISDN BRI Voice Interface Cards for the Cisco 1751 and Cisco 1760 Routers, configuration note • Cisco IOS ISDN Voice Configuration Guide, Release 12.3 • "VoIP Configuration" chapter in the Cisco 1751 Router Software Configuration Guide • Understanding One Stage and Two Stage Voice Dialing, tech note •...
... 12.0(7)T feature module • Analog Centralized Automatic Message Accounting E911 Trunk • Configuring 2-Port ISDN BRI Voice Interface Cards for the Cisco 1751 and Cisco 1760 Routers, configuration note • Cisco IOS ISDN Voice Configuration Guide, Release 12.3 • "VoIP Configuration" chapter in the Cisco 1751 Router Software Configuration Guide • Understanding One Stage and Two Stage Voice Dialing, tech note •...
Hardware Installation Guide
Page 146
... card supports a maximum of the interface card, installed in the router. Figure 107 shows the WIC-4ESW interface card. Additional information on the WIC-4ESW is provided in the 4-Port Ethernet Switch Configuration Notes for use with the WIC-4ESW interface card. The ACT ... electromagnetic compatibility and safety, connect the 4-port 10/100BASE-TX Ethernet switch interface card (WIC-4ESW) only to FastEthernet4, no new or modified commands for the Cisco 1700 Series Routers document. On the Cisco 1751 router and the Cisco 1760 router, the Fast Ethernet interfaces on the modules and...
... card supports a maximum of the interface card, installed in the router. Figure 107 shows the WIC-4ESW interface card. Additional information on the WIC-4ESW is provided in the 4-Port Ethernet Switch Configuration Notes for use with the WIC-4ESW interface card. The ACT ... electromagnetic compatibility and safety, connect the 4-port 10/100BASE-TX Ethernet switch interface card (WIC-4ESW) only to FastEthernet4, no new or modified commands for the Cisco 1700 Series Routers document. On the Cisco 1751 router and the Cisco 1760 router, the Fast Ethernet interfaces on the modules and...