Zenith SL-4132-MW Support Question
Zenith SL-4132-MW Support Question
Find answers below for this question about Zenith SL-4132-MW - Heath - Bayside Mission Style 150-Degree Motion Sensing Decorative Security Light.Need a Zenith SL-4132-MW manual? We have 1 online manual for this item!
Question posted by wattstalir1212 on September 13th, 2011
If I Turn Off Power To Light Will It Effect Settings?
The person who posted this question about this Zenith product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Zenith SL-4132-MW Manual Pages
User Guide - Page 1
... turns light off. • Photocell keeps the light off for the circuitry to calibrate.
Features
• Light comes on the bottom of fixture below. MODE.
Tail Assembly (Lantern & Coach)*
Before installation, record the model number from back of the cover
plate to toggle 1 Second between AUTO and MANUAL OFF then...
Motion Sensing Coach Lights
Requirements
• The light...
User Guide - Page 2
...
For best performance, mount the fixture about 6 feet (1.8 m) above the ground. Tighten screws finger tight. This fixture comes with the junction box screw holes: 1.
WARNING: Turn power off at 1, 5,
or 10 minutes
AUTO
Flip light switch
MANUAL MODE
off for one second then back on*
* If you get confused while switching modes...
User Guide - Page 3
... not need the green "pigtail".
Twist the wires together and secure with wire connectors. Secure the other lights from the motion sensor.
Contact a qualified electrician if there is on the mounting plate must be run in the junction box.
Black
Green or Bare
White One Motion Light
Light Fixture
595-5530-13
Black to black White to pass...
User Guide - Page 4
... two motion lights so that only people with a sensor rated for 100 watts, then 400 watts of additional lighting load can be controlled.
Wiring Diagram 1 - Total fixture ratings must not exceed 500 Watts (4.1 A).
Look at the same time (dual master system). It is recommended that either fixture will turn on the lamp in both motion sensing fixtures...
User Guide - Page 5
... wattage.
❒ If so equipped, install the fixture top.Secure with silicone weather sealant.
❒ Install light bulb.
Bottom trim piece has drain hole
2.
Screw in extension bar. Junction Box
❒ Caulk fixture mounting surface with decorative screws.
❒ If you may install the decorative tail as shown below. Hex nut
1. COMPLETE THE INSTALLATION...
User Guide - Page 6
...-TIME to TEST position.
Any other lights at :
• Pools of TIME you are when the lights turn the entire sensor. Note: Sensor has a 1 1/2 minute warm up period before it past the stops.
150°
6 ft. (1.8 m)
30 ft. (9.1m)
Maximum Range
Maximum
Coverage Angle
240° Sensor Aiming Adjustment Angle
❒ Set the SENSITIVITY as needed.Too much...
User Guide - Page 7
... switch to cover
desired area. The sensor is normal under these conditions).
595-5530-13
Light control is in effect
(recheck after dark). 5. Light switch is turned off is set too high. (Reduce sensitivity.)
SYMPTOM Light stays on for maximum wattage Sensor Capacity . . . . Daylight turn-off . 2. Incorrect circuit wiring, if this
is turned off . Sensitivity is in the Test...
User Guide - Page 8
... BUSINESS OR PROFITS, WHETHER OR NOT FORESEEABLE. You may not apply to : HeathCo LLC P.O. Repair service, adjustment and calibration due to misuse, abuse or negligence, light bulbs, batteries, and other rights which gives you . This warranty covers only HeathCo LLC assembled products and is required for all warranty requests.
595-5530...
Similar Questions
150 Degree Motion Sensing Post Light Sensor - Black
If my information is correct, you no longer make this item. Who does?
If my information is correct, you no longer make this item. Who does?
(Posted by applegrove2035 2 years ago)
How To Deactivate The Motion Sensor On The Heath/zenith Sl-5610-wh-b?
How to deactivate the motion sensor on the Heath/Zenith SL-5610-WH-B?
How to deactivate the motion sensor on the Heath/Zenith SL-5610-WH-B?
(Posted by emvilla 4 years ago)
Heath Zenith Motion Sensor Light Wont Turn Off
(Posted by Tiighchairu 10 years ago)
