Zenith SL-4132-MW Support Question
Zenith SL-4132-MW Support Question
Find answers below for this question about Zenith SL-4132-MW - Heath - Bayside Mission Style 150-Degree Motion Sensing Decorative Security Light.Need a Zenith SL-4132-MW manual? We have 1 online manual for this item!
Question posted by jarudderham on February 9th, 2013
How Do You Use The Manual Over Ride Or Keep It On Without It Turning Off?
The person who posted this question about this Zenith product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Zenith SL-4132-MW Manual Pages
User Guide - Page 1
... works only with the ON-TIME switch in case of fixture below.
MODE. Flip the light switch off during daylight
hours. Motion Sensing Coach Lights
Requirements
• The light control requires 120 volts AC. • If you want to use Manual Mode, the control
must be wired through a switch. • Some electrical codes require installa- ON-TIME...
User Guide - Page 2
...Recommended Grounding Method for one minute, then back on *
* If you get confused while switching modes, turn the power off for additional information). 3. Remove Mounting Plate.
3. This fixture comes with the junction box... will be in the AUTO mode. WARNING: Turn power off at 1, 5,
or 10 minutes
AUTO
Flip light switch
MANUAL MODE
off for one second then back on . Remove two nuts.
2....
User Guide - Page 3
...Secure with wire connectors.
Secure the other lights from the motion sensor. Wire Path
Ground Screw
Wire Path
Fixture Screws
As Shipped
Flipped and Rotated
White
Black Green or Bare
Light Fixture
Light Fixture
Two Motion Lights...qualified electrician if there is on the mounting plate. Recommended Grounding Method Use a green ground "pigtail" (not provided) and twist one end...
User Guide - Page 4
... Diagram 2
It is also possible to wire two motion lights so that only people with a sensor rated for 500 Watts.
For instance, if you have 3 fixtures rated 100 Watts, 150 Watts, and 75 Watts respectively, you have a total load of the controlling (master) fixture to control another motion sensing light fixture (Master / Slave): Strip the red wire...
User Guide - Page 5
...If so equipped, you will not be installing the optional tail assembly, install the decorative nut onto the bottom of the fixture now. Add tail piece and trim.
3....2. Install decorative nut.
595-5530-13
Hex nut
1. See fixture markings for proper bulb type and wattage.
❒ If so equipped, install the fixture top.Secure with silicone weather sealant.
❒ Install light bulb....
User Guide - Page 6
... :
• Pools of TIME you are when the lights turn the entire sensor.
These heat sources could cause false triggering.
• Areas where pets or traffic may trigger the control.
• Nearby large, light-colored objects reflecting daylight may damage the sensor. Motion
Motion
Sensor
Least Sensitive
Most Sensitive
TEST 1 5 10 MIN ON-TIME
LO - Do not point...
User Guide - Page 7
... for maximum wattage Sensor Capacity . . . . Light control may be affecting the sensor. (Re-aim sensor.)
2. Re-aim the sensor to 150° Electrical Load. . . . . . Light flashes on .
1. Light control is in effect
(recheck after dark). 5. Upto500Watts(4.1A.)
Maximum Tungsten Incandescent Power Requirements 120 VAC, 60 Hz Operating Modes. . . . Daylight turn-off is turned off...
User Guide - Page 8
.... Repair service, adjustment and calibration due to misuse, abuse or negligence, light bulbs, batteries, and other expendable items are not covered by factory defective...: Technical Service * If contacting Technical Service, please have other equipment and components that a customer uses in its entirety.
No Service Parts Available for inconvenience, installation, setup time, loss of purchase...
Similar Questions
How To Deactivate The Motion Sensor On The Heath/zenith Sl-5610-wh-b?
How to deactivate the motion sensor on the Heath/Zenith SL-5610-WH-B?
How to deactivate the motion sensor on the Heath/Zenith SL-5610-WH-B?
(Posted by emvilla 4 years ago)
Motion Sensor Light Won't Turn Off
(Posted by ungm3lm4 9 years ago)
Zenith Motion Sensor Light Won't Turn Off
(Posted by matrijone 9 years ago)
Heath Zenith Motion Sensor Light Wont Turn Off
(Posted by Tiighchairu 10 years ago)
If I Turn Off Power To Light Will It Effect Settings?
(Posted by wattstalir1212 12 years ago)