Whirlpool YGY397LXUS Support Question
Whirlpool YGY397LXUS Support Question
Find answers below for this question about Whirlpool YGY397LXUS.Need a Whirlpool YGY397LXUS manual? We have 1 online manual for this item!
Question posted by 3z on October 27th, 2014
Why Accubake Membrane Switch / Touch Pad Brakes Down Everly 3 Years On Model.
whirrpool accubake at Sears.Model. YGY397LXUS. Serial FMW0601213. Part W10207928 -$174.99 Model. YGY397LXUS. Serial FMW0601213. Part W10207928 -$174.99.At Sears Is there any recall on it ? Bough 2008, broke 2011,2014. can I report somewhere to get my money back. BBB ? j
Current Answers
Answer #1: Posted by Odin on October 27th, 2014 4:18 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,770
Member since:
April 10th, 2010 Points: 41,236,770
1. No recall for YGY397LXUS. Sorry.
2. For the return policies, see http://www.sears.com/csreturns/nb-100000000020507.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool YGY397LXUS Manual Pages
Installation Instructions - Page 2
... alerts you to potential hazards that can tip the range and be killed or seriously injured if you don't immediately follow instructions.
RANGE SAFETY
Your safety and the safety of injury, and...or adult can kill or hurt you what the potential hazard is, tell you how to rear range foot.
These words mean:
DANGER
You can happen if the instructions are very important. Connect anti...
Installation Instructions - Page 3
... space located above . ■ Four-wire power supply cord or cable must end in a 24" (61 cm) base cabinet with ranges. Model/serial number plate (located behind the storage drawer panel.
■ The range should be used will need to be provided, the risk can be used in a mobile home installation. Tools needed If...
Installation Instructions - Page 4
...the appliance is properly grounded. Nothing located in shaded area can be moved if servicing is ever necessary.
■ A UL listed conduit connector must be used , a matching UL listed... the cabinet. Electrical Connection
To properly install your range, you will be connected directly to the top of electric shock. The model/serial number rating plate is protected by a qualified electrician...
Installation Instructions - Page 5
...This uses a 3-wire receptacle of your countertop. A copy of the above code standards can result in range fit over the cutout edge of NEMA Type 10-50R.
3-wire receptacle (10-50R)
Electrical Requirements -...10-50P plug on the model/serial rating plate.
**If connecting to be plugged into a standard 14-50R wall receptacle. Be sure the wall receptacle is not level, range will not be level. ...
Installation Instructions - Page 6
...tape and protective film from inside oven. 3. Storage drawer B. Using 2 or
more people, stand range back up onto cardboard or hardboard. WARNING
Tip Over Hazard A child or adult can use : floor... the correct height, check that the antitip bracket will slide under the range for the anti-tip bracket. Before sliding range into a standing position, put a sheet of cardboard or hardboard in...
Installation Instructions - Page 7
.... Power Supply Cord
Electrical Connection - Use a new 40 amp power supply cord. Electrically ground range.
Use 8 gauge copper or 6 gauge aluminum wire. Use Phillips screwdriver to remove cover.
...cover down and toward you to remove the terminal block cover screw located on the back of the range. 4. Drill two ¹⁄₈" (3 mm) holes that correspond to the wall or floor ...
Installation Instructions - Page 8
...screwdriver to remove screws and slide cord/conduit plate down and out.
A
■ Lift range back panel up and off. Allow enough slack to easily attach the wiring to the ...against the power supply cord.
■ Use Phillips screwdriver to remove screws from panel on bottom of range.
■ Position cord/conduit plate as shown in the following illustration. Style 1: Power supply cord...
Installation Instructions - Page 9
...4-wire receptacle (NEMA type 14-50R)
A UL listed, 250-volt minimum, 40-amp, range power supply cord
4-wire connection: Power supply cord
4-wire direct
5" (12.7 cm)
...4-wire connection: Direct wire
3-wire receptacle (NEMA type 10-50R)
A UL listed, 250-volt minimum, 40-amp, range power supply cord
3-wire connection: Power supply cord
3-wire direct
1" (2.5 cm)
3" (7.6 cm)
A fused disconnect or...
Installation Instructions - Page 10
...supply cord.
1. Line 1 (black) C. Direct Wire Installation: Copper or Aluminum Wire
This range may be connected directly to expose wires. 5. Securely tighten hex nuts. Replace terminal block access .... Connect line 1 (black) and line 2 (red) wires to the center terminal block post with ranges.
5. Line 2 (red)
3. Securely tighten hex nuts. Allow enough slack in the cord/conduit plate...
Installation Instructions - Page 11
...
8 gauge copper
25 lbs-in. (2.8 N-m)
6 gauge aluminum
35 lbs-in following Bare Wire Torque Specifications chart. Metal ground strap B. Use Phillips screwdriver to the range with one of range. A
B
C
G
D
FE
A. Neutral (white) wire F. Set screw C. Line 1 (black) wire
D. Bare (green) ground wire D. Line 2 (red) G. 1. Ground-link screw
2.
Line 1 (black) wire G. Use Phillips...
Installation Instructions - Page 12
.... Line 2 (red) F. Making sure the anti-tip bracket is engaged with one of range.
Line 1 (black) wire
2. Line 2 (red) wire
Bare Wire Torque Specifications Attaching ...leg is removed from the anti-tip bracket.
3. F A
E B
B
C
D FE
A. A. NOTE: Range must be level for the anti-tip bracket securely attached to torque shown in following Bare Wire Torque Specifications chart. ...
Installation Instructions - Page 13
... into an outlet. ■ Electrical supply is level. Unplug the power supply cord. 3. Check that range is moved. If removing the range is an extra part, go back through the steps to rear range foot. Check that the range is under anti-tip bracket.
6. Use a mild solution of the Use and Care Guide. 6. Failure...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Connecting refrigerator to a power source
... have the proper electrical connection. Check your model number into its final location, it by entering your owner's manual for recommended settings; find it is important to the word Off, or press the Freezer down arrow touch pad until a dash (-) appears in both the... a power source What do I need to know about connecting my refrigerator to the desired setting. Side by a switch. -
The Humidity Control
...the main menu. Bottom freezer/French door refrigerators Moisture between On and Off. Press the touch pad next to "Done" to lock in the refrigerator compartment Moisture on the display screen, ...menu, press any of the four touch pads located on the door hinged seal. The refrigerator uses more energy when Humidity Control is On" to switch between French Doors Moisture in the desired... -
Why is my cooktop not working
...-698-2538. please call the Whirlpool Consumer eXperience Center. Why is my cooktop not working Why is my electric cooktop not working . For electronic touch pad models, have you need further assistance, My electric range is the element inserted properly?
Similar Questions
Where Can I Find A Switch For My Stove Just Like This One
Where can I get a switch for my stove just like this one
Where can I get a switch for my stove just like this one
(Posted by christinalain1979 8 years ago)
Touch Pad Part #
what is part number for touch pad for a Whilrpool range model GY399LXUQ4?
what is part number for touch pad for a Whilrpool range model GY399LXUQ4?
(Posted by Anonymous-121747 10 years ago)
Replacing Infinite Switch
How to remove top whirlpool rs696pxg to replace infinity switch on large burner. Tried removing scre...
How to remove top whirlpool rs696pxg to replace infinity switch on large burner. Tried removing scre...
(Posted by normang 11 years ago)
Does The Stove Top Just Lift Off To Get At The Igniter Switches?
One igniter only works some of the time. I want to lift off the stove top to look at the switch. Doe...
One igniter only works some of the time. I want to lift off the stove top to look at the switch. Doe...
(Posted by larrybetty67 11 years ago)
Rocker Switch
what does the rocker switch on top of the consol at the left do?
what does the rocker switch on top of the consol at the left do?
(Posted by tomlovern 11 years ago)