Whirlpool RF111PXSQ Support Question
Whirlpool RF111PXSQ Support Question
Find answers below for this question about Whirlpool RF111PXSQ.Need a Whirlpool RF111PXSQ manual? We have 4 online manuals for this item!
Question posted by wjdev on November 28th, 2011
Power Supply Cord
circuit breaker trips when stove is plugged in to good receptacle?
Current Answers
Related Whirlpool RF111PXSQ Manual Pages
Dimension Guide - Page 1
... policy includes a continuous commitment to improve our products, we reserve the right to the circuit breaker box (or fused disconnect) through the neutral, use a 4-wire power supply cord rated at 250 volts, 40 or 50 amps and investigated for use with ranges. Dimensions are for planning purposes only. Ref. The model/serial number rating plate is...
Installation Instructions - Page 1
INSTALLATION INSTRUCTIONS 30" (76 CM) FREESTANDING ELECTRIC RANGES
Table of Contents
RANGE SAFETY 2 INSTALLATION REQUIREMENTS 3
Tools and Parts 3 Location Requirements 3 Electrical Requirements - U.S.A. Only 7 Verify Anti-Tip Bracket Location 12 Level Range 12 Storage Drawer 12 Complete Installation 13 Moving the Range 14 ANTI-TIP BRACKET TEMPLATE 15
IMPORTANT:
Save for local ...
Installation Instructions - Page 2
..."DANGER" or "WARNING." We have provided many important safety messages in death or serious burns to rear range foot. RANGE SAFETY
Your safety and the safety of injury, and tell you what the potential hazard is the safety ...This is , tell you how to potential hazards that can tip the range and be killed.
All safety messages will follow instructions. Reconnect the anti-tip bracket, if the...
Installation Instructions - Page 3
... with the requirements of burns or fire by reaching over heated surface units, cabinet storage space located above .
■ Four-wire power supply cord or cable must be avoided. Mobile home installations require:
■ When this range must be revised.
Check local codes.
Given dimensions are shown must be securely mounted to comply with...
Installation Instructions - Page 4
... and the bottom of cooktop, see NOTE*. A freestanding range may be installed next to whether the appliance is used,...Range can be obtained from floor F 2.2 cm) min. D. 30¹⁄₈" (76.5 cm) min. opening width C. If it is covered by not less than ¹⁄₄" (0.64 cm) flame retardant millboard covered with local codes. Do not modify the power supply cord plug...
Installation Instructions - Page 5
... spade terminals with kit. or 50-amp range power supply cord (pigtail). The model/serial number rating plate is connected to the circuit breaker box (or fused disconnect) through the neutral conductor.
Grounding through the neutral, use a 50-amp rated cord with upturned ends, terminating in a NEMA Type 14-50P plug on the appliance end must be revised...
Installation Instructions - Page 6
... floor in back or other injury.
1. If countertop is not flush with cabinet opening so that specified in the "Location Requirements" section, adjust template so range will be centered in death or serious burns to lower the front and rear leveling legs one-half turn . Rear leveling leg B. Wrench or pliers...
Installation Instructions - Page 7
... the subfloor. Electrically ground range. Use 8 gauge copper or 6 gauge aluminum wire. Remove plastic tag holding three 10-32 hex nuts from floor. Hex-head screws
7 Fasten anti-tip bracket with a hammer. Only
Power Supply Cord
Direct Wire
WARNING
WARNING
Electrical Shock Hazard Disconnect power before servicing. Use a new 40 amp power supply cord.
Plug into holes with...
Installation Instructions - Page 8
...
■ Tighten strain relief screw against the power supply cord.
4-wire direct
³⁄₈" (1.0 cm)
A circuit breaker 4-wire connection:
box or fused
Direct wire
disconnect
5" (12.7 cm)
3-wire receptacle (NEMA type 10-50R)
A UL listed, 250-volt minimum, 40-amp, range power supply cord
3-wire connection: Power supply cord
Style 2: Direct wire strain relief ■ Remove...
Installation Instructions - Page 9
...-32 hex nuts. Neutral (white) wire E. Securely tighten hex nuts. Replace terminal block access cover.
9 Power supply cord wires
4. Use a Phillips screwdriver to connect the green ground wire from the power supply cord to neutral wire of range. Terminal block B. A
F
A
E
B
C
E
A. 10-32 hex nut B. Line 1 (black)
6. D B
C
A. 10-32 hex nut B. Line 1 (black)
3. Terminal...
Installation Instructions - Page 10
...Strip outer covering back 3" (7.6 cm) to the range with the ground-link screw and ground-link section. C
G D
EF
A. Cord/conduit plate D. Bare (green) ground wire
E.... to your electrical supply, make the required 3-wire or 4-wire connection. 1. A
A
B
B
C
A. Line 1 (black) wire
4. Allow enough slack in the wire to the fuse disconnect or circuit breaker box. Line 2...
Installation Instructions - Page 11
...bottom of range. A B
C
2. Loosen (do not remove) the setscrew on the front of the terminal lug and insert exposed wire end through the conduit on cord/conduit plate...10-32 hex nut B. Ground-link screw
E. Allow enough slack to easily attach the wiring to neutral supply wire.
1.
Cord/conduit plate
F
D. Line 2 (red) C. Replace terminal block access cover.
11 Replace terminal block access...
Installation Instructions - Page 12
...1" (2.5 cm). Check that the storage drawer is removed from outside the range. A. Insert a flat-blade screwdriver through the opening in anti-tip bracket. To check that rear...Check that the anti-tip bracket is level.
Pull the storage drawer forward to back.
3. A
Level Range
1. Verify Anti-Tip Bracket Location
1. To Remove: 1. On models with a warming drawer, the rear ...
Installation Instructions - Page 13
... all of the storage drawer and place it inside the
range in the range Use and Care Guide. 7. See the Use and Care Guide for heat. To Replace: 1. Read "Range Use" in its fully forward position. 2. See "Level Range." 5. Plug power cord into an outlet.
■ Electrical supply is plugged into appropriate outlet. Engage drawer glide.
4. Check that the...
Installation Instructions - Page 14
... for cleaning or maintenance:
For power supply cord-connected ranges: 1. Plug in death or electrical shock. 1. Replace all parts and panels before servicing. Failure to do so can result in power supply cord. 5. Failure to follow these instructions can tip the range and be killed. Slide range forward. 2. Complete cleaning or maintenance. 4. Check that range is moved. Reconnect the anti...
Owners Manual - Page 2
... symbol alerts you and others are not followed.
Reconnect the anti-tip bracket, if the range is the safety alert symbol. This is moved. The California Safe Drinking Water and Toxic ...child or adult can kill or hurt you to floor. • Slide range back so rear range foot is installed: • Slide range forward. • Look for details. See the installation instructions for the anti...
Owners Manual - Page 3
... be stored in Manual.
■ Before Self-Cleaning the Oven - The door gasket is properly installed and grounded by a qualified technician.
■ Never Use the Range for a good seal. Absence of these surfaces are the cooktop and surfaces facing the cooktop.
■ Use Proper Pan Size - The...
Owners Manual - Page 4
...: To avoid permanent damage to the oven bottom finish, do so can be set to another closed and wellventilated room. IMPORTANT: The health of the range. To lower the temperature, hold the knob handle firmly and turn skirt counterclockwise to move birds to anywhere between HI and LO. Loosen the locking...
Owners Manual - Page 6
...may affect the finish. Cleaning Method:
Rub in direction of the coil element toward the receptacle. Soil will help them slide.
Remove the coil element by both front corners until ... cleaners, follow label instructions on some models)
Food spills containing acids, such as the entire range is cool.
For additional information, you can be used to soak for cleaning beneath.
These...
Owners Manual - Page 7
...9632; Is the power supply cord unplugged?
Cooktop cooking results not what expected
■ Is the range level? Level the range. Oven temperature too high or too low ■ Does the oven temperature calibration need adjustment? Plug in the pan? Plug into a grounded outlet. ■ Has a household fuse blown, or has a circuit breaker
tripped?
Level the range. Double-check the...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Nothing will operate on my gas range
Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. Nothing will operate on my gas range Nothing will operate on my gas range. Is the power supply cord unplugged? Plug into a grounded 3 prong outlet. Has a household fuse blown, or has a circuit breaker tripped? My gas oven won't operate Blank display My range is not working at all... -
Compactor won't operate
... power supply cord ...range is not working. Is the drawer completely closed , you press On before pressing Start (on some models). If the problem continues, call an electrician. Plug into a grounded 3 prong outlet. Replace the fuse or reset the circuit breaker. Did you may need assistance from a local service provider. Has a household fuse blown, or has a circuit breaker tripped... -
Blank display
... you are unable to check the circuit breaker or fuse, please call an electrician. To turn it off, press Stop/Clear; Does the range work now? If you may be in the Sabbath mode. Does the range work now? If not, see power supply cord section below ). Is the power supply cord unplugged? Plug power supply cord into a grounded 3 prong outlet. Nothing works...
Similar Questions
Power To Clock But Oven Or Stove Not Heating
after a short in plug wore and circuit breaker tripping all repairs are completed circuit breaker tu...
after a short in plug wore and circuit breaker tripping all repairs are completed circuit breaker tu...
(Posted by Holly081995 6 years ago)
Breaker Needed For This Stove Top Please Model Number Rf111pxsq 3
running 8 3 wire for this stove need a breaker amp size for this stove thank
running 8 3 wire for this stove need a breaker amp size for this stove thank
(Posted by rayszone 7 years ago)
Electric Range Model Number Gfe461lvs, Oven And Stove Top Will Not Heat Up
(Posted by ks6804 11 years ago)
Why Does Circuit Breaker Trip When Stove Is Plugged In?
(Posted by wjdev 12 years ago)
Power Cord / Supply Problems For My Whirlpool Oven Rf111pxsq3
I bought a new whirlpool oven from Lowes a few days ago. Got it home, bought a power supply cord fro...
I bought a new whirlpool oven from Lowes a few days ago. Got it home, bought a power supply cord fro...
(Posted by ttak99 12 years ago)