Question posted by robertzaluski on July 21st, 2022
Stacking Rod
On my weider xrs-50 the rod that goes down the center of the weights that you put pin in for change of weightys used,when you use less than 3 weights at a time it wont go back in the whole of the remaining weights,it hits at and angle to the stack and will not go back in until you push it back in.[ its been like this since new]
Current Answers
Similar Questions
Missing Shipment
HiI have recently ordered your product on the walmart site. I have received only part of the shipmen...
HiI have recently ordered your product on the walmart site. I have received only part of the shipmen...
(Posted by meetdipesh 3 years ago)
How To Slacken Cable So First Weight Is Not Lifted Off The Stack
how do you slacken cable so that the top weight is sitting tight to the other weights on the stack. ...
how do you slacken cable so that the top weight is sitting tight to the other weights on the stack. ...
(Posted by Moran339 4 years ago)
Weider 1200, Weight Stack
how much does the weight stack weigh or how much do each of the plates weigh
how much does the weight stack weigh or how much do each of the plates weigh
(Posted by Anonymous-152188 8 years ago)
How Do I Assemble Cable And Weight Stack?
purchased a second hand weight set and it didn't come with instructions. downloading manual isn't ha...
purchased a second hand weight set and it didn't come with instructions. downloading manual isn't ha...
(Posted by larrabee 10 years ago)