Uniden D1364 Support Question
Uniden D1364 Support Question
Find answers below for this question about Uniden D1364.Need a Uniden D1364 manual? We have 1 online manual for this item!
Question posted by Anonymous-149371 on February 21st, 2015
Password Help
How do I get my password so that I can check my messages? I don't remember what it is
Current Answers
Answer #1: Posted by waelsaidani1 on February 21st, 2015 1:07 PM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,797
Member since:
May 12th, 2013 Points: 19,501,797
reset the device
Steps to reset your Uniden cordless phone Handset without the base unit
- Disconnect the battery.
- Hold down the # and the * keys. While holding them down, re-connect the battery.
- Push the right-most "soft" button. This is the button directly under the screen, on the right hand side. (The one that lets you select commands displayed on the screen.)
Related Uniden D1364 Manual Pages
User Guide - Page 1
... waiting, CID, CIDCW, and Voice Mail are missing or damaged, contact our Customer Care Line immediately. xx Need help?
see our website for details.
Get answers 24/7 at our website: www.uniden.com.
D1364 D1364-2 D1364-3
You should have a question or problem Customer Care Line*
817-858-2929 or 800-297-1023
need a part...
User Guide - Page 2
... Deleting All the Entries 8 Chain Dialing 8 Using Call Waiting 8 Finding the Handset 9 Voice Message Notification ......... 9 Setting Up Voice Mail Access.......9 Editing Your Voice Mail
Number 9
Troubleshooting 10
Important ... a gas leak in a wet basement or near a swimming pool. There may explode. Check with local codes for example, near a bath tub, wash bowl,
kitchen sink or laundry...
User Guide - Page 3
...over the pins on the wires to a standard telephone wall jack.
## If the display says Check TEL Line, check the connection between the base and the phone jack.
2. Replace the battery cover and slide it ... mode.
1. Use the AC adapter to connect the power jack on the rear of noise, check for an automated response system),
* press to temporarily switch to hang up the battery connector with...
User Guide - Page 4
.../pause
xxIn standby: open the phonebook.
( )
xxIn the menu: go back to a waiting call : switch to the previous screen.
Handset
REDIAL/ PAUSE
MUTE
Charging contacts
MESSAGES Microphone
Key (icon)
What it does FinD xxIn standby: page the handset.
User Guide - Page 5
...next space and enter the second letter.
erase the character at the cursor
clear.
xxBlinking: there are new messages. T-coil mode is charging. The ringer is 1) fully charged, 2) half charged, 3) getting low,...xxIn any menu or list: exit and go to enter text into your voice mail service.
MESSAGES ( ) xxIn standby: access your phone (e.g. Reading the Display
The icons appear based on...
User Guide - Page 7
... store up ignore a call (mute the ringer) mute the microphone during a call
Press... xxThe handset remembers the last 5 numbers you are on it.
scroll through the list
Up or Down. English - 7 To....
* To turn off the ringer, turn it back on.)
Changing the Volume
You can get messages by pressing one button (see p. 9). Contact your voice mail access number so you subscribe to...
User Guide - Page 8
... often have to enter a series of CID number add the area code
* before dialing for a toll call , the phone sounds a tone. Chain Dialing
If you checked the CID list.
Press Menu/select and then select Create New.
Caller ID on another call ; Press Talk/flash to send the code number. each...
User Guide - Page 9
...code to set up , the system
prompts you can program that access number into your messages, the message icon turns off.
Finding the Handset
With the phone in standby, open the menu and ...one key to enter
a 4-second pause. The system will set the number. 3. English - 9 Voice Message Notification
If you can enter your phone displays the voice mail icon ( ) when you have voice mail ...
User Guide - Page 10
...few minutes,
then reconnect it .
10 - xxMake sure the ringer is not working.
xxCharge the battery for at least 3 days.
Check the handset for telecoil hearing aids (see p. 6). Finish your phone. There's a lot of the base or handset, wipe it ... .
3.
Liquid Damage
CAUTION: If the base is covered in an electronics store. Check for interference from the interference source.
User Guide - Page 13
... when using this
English - 13 It does not imply that the sum of the Ringer Equivalence Numbers of original retail sale.
Operation is required for help. xx Connect the equipment into an outlet on an interface may not be collocated or operated in materials and craftsmanship with the guidelines.) Third party...
Similar Questions
My Uniden Dect 6.0 D1364 Won't Wake Up
The handset will ring and light up but the answer "Flash TALK", CLR, menu buttons don't work. It has...
The handset will ring and light up but the answer "Flash TALK", CLR, menu buttons don't work. It has...
(Posted by wshir14291 3 years ago)
Have A Dect 6, D1780 Answering System. Won't Record A Message.
Have done all things llisted in manual but answering system won't take messages.
Have done all things llisted in manual but answering system won't take messages.
(Posted by dibarnes 10 years ago)
I Have A Cordless Model D1364.can I Block A Number On This Phone??
Do i have call block?????
Do i have call block?????
(Posted by maineeack49 10 years ago)
Steps To Sucessful Installation Of A Uniden D1364 Caller-id Phone.
I am having difficulty sucessfully installing a Uniden D1364 caller-id phone. I've charged the batte...
I am having difficulty sucessfully installing a Uniden D1364 caller-id phone. I've charged the batte...
(Posted by risaar 10 years ago)
What Does Message Check Base & Out Of Range Mean -handset Is In Range &charged.
Phone Type - D3098 Series/Model.Base with one accessory handset and cahrger. Base is operating fine,...
Phone Type - D3098 Series/Model.Base with one accessory handset and cahrger. Base is operating fine,...
(Posted by deidresaunders 11 years ago)