Troy-Bilt TB6042 XP Support Question
Troy-Bilt TB6042 XP Support Question
Find answers below for this question about Troy-Bilt TB6042 XP.Need a Troy-Bilt TB6042 XP manual? We have 1 online manual for this item!
Question posted by jhelms0667 on March 23rd, 2015
Im At A Business That Owns Five Of These Models . None Seem To Work .
i do not think it is a fuel problem because carb is clean. fuel is clean lines are clean and spark plug is getting fuel. but all the weedeaters seem to have losseness in the bellhouseing that holds the pullstart.
Current Answers
Related Troy-Bilt TB6042 XP Manual Pages
Operation Manual - Page 1
.... Operator's Manual
Electric Start Capable 4-Cycle Professional Trimmer
TB6042 XP
TABLE OF CONTENTS Service Information 1 Rules for Safe Operation 2 Know Your Unit 4 Assembly Instructions 4 Oil and Fuel Information 5 Starting and Stopping Instructions 6 Operating Instructions 7 Maintenance and Repair Instructions 8 Cleaning and Storage 10 Optional Accessory 10 Troubleshooting Chart 10...
Operation Manual - Page 2
...SPARK ARRESTOR NOTE
NOTE: For users on forest brush and/or grass-covered areas be equipped with a spark arrestor, maintained in effective working.... Be familiar with anything before use metal-reinforced line, wire or rope. Make sure all debris and... starting . Take the following precautions:
• Store fuel only in a clean, well-ventilated outdoor area where there are marked as ...
Operation Manual - Page 3
... injury and hearing loss. RULES FOR SAFE OPERATION
• Do not overreach.
Keep out of the reach of vegetation and other users. If you are available from operation. These parts get extremely hot from your warranty.
• Keep unit clean of children.
• Never douse or squirt the unit with fuel in serious injury...
Operation Manual - Page 4
...the unit. (Fig. 5)
Fig. 3
Support Clip
Cutting Head
Line Cutting Blade
Adjustment Tab
Fig. 4
Support Fitting
Fig. 5
4
While holding the unit in the
Shield
guard mount bracket. (Fig. 2)
2.... • 3/8" Socket
On/Off Stop Control
Shoulder Strap Clip
Spark Plug
Primer Bulb
Choke Lever Fuel Cap
Muffler
D-Handle Shaft Housing
Throttle Control
Air Filter Cover
Starter...
Operation Manual - Page 5
...sparks and open flames at least 30 ft. (9.1 m) from the fueling source and site before each use and change the oil regularly. Add 0.8 oz. (23 ml) of fuel additive per gallon of oil in a clean...3. Remove the oil fill plug from fuel
spray. NOTE: Never add oil to Checking the Oil Level.
Fuel Tank
2. Ignited vapors
may have spilled and reinstall the oil fill plug. Do not smoke while ...
Operation Manual - Page 6
...
8. Refer to Position 2 (Fig. 11) and continue warm-up for 2-5 minutes. Press and hold the electric starter or drill ON (I ) button for 2-second intervals until the unit starts.
the engine..., place the choke lever in the starting position (Fig. 12). Fill the fuel tank with fresh, clean unleaded gasoline.
IF... Fully press and release the primer bulb 10 times, slowly...
Operation Manual - Page 7
...that came with an electric powered unit. Excessive line length will cut the line to the proper length if excess
line is accomplished by working from :
• Entanglement with more difficult ...
• Normal line fatigue
• Attempting to cut thick, stalky weeds
• Forcing the line into the EZ-Link™ coupler (Fig. 14). While firmly holding the upper shaft housing...
Operation Manual - Page 8
...clearance and adjust p. 9
Check spark plug condition and gap
p. 9
REMOVING THE LINE
1.
Fill
3. Cleaning the Air Filter
Fig. 29... the line around the oil fill plug before removing it . Fig. 19
3.
Stop the engine and allow it to get a ...Hold the spool cover, turn the unit
off by tipping the unit to the unit, always maintain the proper oil level in . (2.41 mm) replacement line...
Operation Manual - Page 9
...head or T-25 Torx® screwdriver (Fig. 33).
2.
Replace the spark plug wire.
12.
Checking the fuel, cleaning the air filter, and adjusting the idle speed should not rotate when ... this step. Install a correctly-gapped spark plug in the
engine could damage the cylinder.
3. NOTE: The cutting attachment should solve most engine problems. If not and all safety instructions...
Operation Manual - Page 10
... at any loose or damaged parts. CUTTING ATTACHMENT WILL NOT ADVANCE LINE
Cutting attachment bound with grass
Stop the engine and clean cutting attachment
Cutting attachment out of line
Refill with fuel in a horizontal position. Start the engine and allow it stalls. Remove the spark plug and put 5 drops of printing. Allow the engine to Changing...
Similar Questions
Troy-bilt Tb225
I have this tiller model it was only used twice. It has new fuel and new spark plugs, getting fuel a...
I have this tiller model it was only used twice. It has new fuel and new spark plugs, getting fuel a...
(Posted by donniebailey1962 3 years ago)
My Hand Warmers Don't Work. How Do I Fix Them?
I've switched the switch on and off a few times and they do not heat up. Any ideas on how to fix the...
I've switched the switch on and off a few times and they do not heat up. Any ideas on how to fix the...
(Posted by ptacekkaren 3 years ago)
Pull String
how do I replace the pull string on my Troybiltiller ?
how do I replace the pull string on my Troybiltiller ?
(Posted by gregschaffer67 3 years ago)
Unit Will Not Start
Unit worked fine until last winter when it would not start, either using the electric starter or the...
Unit worked fine until last winter when it would not start, either using the electric starter or the...
(Posted by rkferguson 7 years ago)
How To Rewind Pull Cord On Troy Built Model Tb675 Ec
(Posted by jake5070 10 years ago)