Troy-Bilt TB2044 Support Question
Troy-Bilt TB2044 Support Question
Find answers below for this question about Troy-Bilt TB2044.Need a Troy-Bilt TB2044 manual? We have 1 online manual for this item!
Question posted by lizardlpr on July 22nd, 2015
Throttle Problem
my trimmer will only run when it is on full choke, what might be the problem
Current Answers
Answer #1: Posted by Odin on July 22nd, 2015 5:27 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,670
Member since:
April 10th, 2010 Points: 41,236,670
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Troy-Bilt TB2044 Manual Pages
Operation Manual - Page 1
When servicing, use only identical replacement parts.
769-08520 / 01
All information, illustrations, and specifications in Canada. Operator's Manual
Electric Start Capable 2-Cycle Trimmer
TB2044 XP
TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 9 Operation 11 Maintenance 12 Cleaning and Storage 15 ...
Operation Manual - Page 2
... storage of such materials.
• Always stop the unit immediately.
• Squeeze the throttle control and check that are approached, stop the engine and allow it requires replacement, ask ... a source of California, Maine, Oregon and Washington. DO NOT smoke. • Never start or run the unit inside a closed room or building.
DO NOT smoke.
• Never operate the unit without...
Operation Manual - Page 3
... to an authorized service dealer for damage. Keep the engine and muffler free from debris. OTHER SAFETY WARNINGS
• All service, other liquid. Do not run the unit at the intended rate.
• Always stop moving parts have stopped. 3.
Vibration is delayed or when walking from all moving parts.
• Do...
Operation Manual - Page 4
...Thrown objects and loud noise can
cause severe eye injury and hearing loss. You may appear on trimmer attachment
shield. When turned off they remain hot for the proper type of oil.
• ...and repair information.
These parts get burned. SYMBOL MEANING
• ON/OFF STOP CONTROL ON / START / RUN
• ON/OFF STOP CONTROL OFF or STOP
• PRIMER BULB Push primer bulb, fully and slowly...
Operation Manual - Page 5
...with cutting head, cutting head shield and handle 11 - 13 lbs. (5.0 - 5.9 kg) Trimmer Mechanism Bump Head Trimming Line Diameter 0.095 inches (2.41 mm) Cutting Path Diameter 18 in. ...
Handle
On/Off Switch
Cutting Head
Shaft Housing
Cutting Head Shield
Coupler
Shaft Grip Throttle Control
Choke Lever
Starter Rope Grip
Air Filter Cover
Fuel Cap
Line Cutting Blade
Primer Bulb
...
Operation Manual - Page 7
...the knob counterclockwise to loosen (Fig. 3). 2. Knob
Fig. 3
Coupler
90˚ Edging Hole (Trimmer Only)
Nut Fig. 4
Upper Shaft Housing
Release Button
Lower Shaft Housing
Primary Hole Fig. 5
7... WARNING: Before using any attachment, read and
understand the manual that came with a string trimmer attachment, lock the release button into
the primary hole only. While firmly holding the upper ...
Operation Manual - Page 8
... • Always agitate the fuel mix before fueling the unit • Drain the tank and run the engine dry before starting the engine. NOTE: Dispose of 2-cycle oil provided with this unit...the unit
WARNING: DO NOT USE E85 FUEL IN THIS UNIT. Avoid creating a source of performance problems. Use only fresh, clean unleaded gasoline. Do not start the engine until fuel vapors dissipate.
1. ...
Operation Manual - Page 9
... up when it clicks (Fig. 8).
5. NOTE: The engine is no need to 10 seconds.
the unit is in the starting the unit. Choke Lever
STOPPING INSTRUCTIONS
1. Release the throttle control and allow the engine to 60 seconds. Carbon monoxide exhaust fumes can be seen in a confined area. The On/Off switch is...
Operation Manual - Page 10
... is hot and fails to start after running the electric start accessory for 3 sets of 2-second intervals: press the throttle lockout, squeeze the throttle control and run the electric start accessory operator's manual.
... Electric Starter
STARTING INSTRUCTIONS
1. If fuel cannot be started with oil. Flip the choke lever clockwise until the unit starts.
8. IF... Allow the engine to warm up...
Operation Manual - Page 11
... occur from the cutting head without the need for bending over. Fig. 13
11 OPERATION
HOLDING THE TRIMMER
WARNING: Always wear eye, hearing, hand, foot and
body protection to reduce the risk of trimming ...8226; Hold the unit at a 30° angle to the proper length if any excess line is
running. This may stall the engine. NOTE: Some line breakage will make the unit overheat. CAUTION: Do ...
Operation Manual - Page 12
... cutting head until the ends are unsure about 5 inches (12.7 cm) protrude from starting accidentally. DO NOT align the arrows when the line winding is running.
NOTE: Maintenance, replacement, or repair of any old trimming line and/or obstructions from the exit eyelet.
Pull the line until a few inches protrude from...
Operation Manual - Page 14
...5. Remove the spark plug from the spark plug.
2.
An authorized service dealer should solve most engine problems. If not, and any of the following conditions are true, take the unit to a qualified service... damage the cylinder.
3. NOTE: Careless adjustments can seriously damage the unit. Release the throttle control and let the engine idle. Grasp the spark plug boot firmly and pull it ...
Operation Manual - Page 15
... 5 drops of the oil from the carburetor.
3. CLEANING AND STORAGE
CLEANING
WARNING: To avoid serious personal injury, always stop
the engine and allow it to run until it stalls.
Operation Manual - Page 16
TROUBLESHOOTING
PROBLEM THE ENGINE WILL NOT START The fuel tank is empty The primer bulb was not pressed enough
The engine is flooded...fouled
SOLUTION
Fill the fuel tank with properly mixed fuel Press the primer bulb 10 times or until fuel is visible Squeeze the throttle control and pull the starter rope until the engine starts Drain the fuel tank and add fresh, properly mixed fuel Replace the ...
Operation Manual - Page 20
... obligation to modify any product previously manufactured. Alteration of the safety features of any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for any Troy-Bilt product that is used in accordance with the Operator's Manual furnished with...
Similar Questions
Is The Throttle Cable Adjustable On The Troy Bilt Tb225 Tiller? Also What Would
is the throttle cable adustable on the tb225 tiller and also what would make the fuel not stay in th...
is the throttle cable adustable on the tb225 tiller and also what would make the fuel not stay in th...
(Posted by tw285j 1 year ago)
Trimmer Bump Head Feeding Problem
Bump head only feeds on one side, what can cause this?
Bump head only feeds on one side, what can cause this?
(Posted by johnnycom 8 years ago)
Attachments For Tb2044 Xp
Where can I purchase the edger attachment for the tb2044xp
Where can I purchase the edger attachment for the tb2044xp
(Posted by williefields357 8 years ago)
Troy Built Xp Tb2044 Xp Vibration Problems
Trimmer has bad vibration what to do?
Trimmer has bad vibration what to do?
(Posted by Caseyalankjb 10 years ago)
My Tb225 Was Running Good And It Just Stopped Have You Had Any Problems With The
engine or tiller locking up. my engine will not turn over its locked up.any sugestons .
engine or tiller locking up. my engine will not turn over its locked up.any sugestons .
(Posted by daviderickson11 10 years ago)