Troy-Bilt Pony Support Question
Troy-Bilt Pony Support Question
Find answers below for this question about Troy-Bilt Pony.Need a Troy-Bilt Pony manual? We have 1 online manual for this item!
Question posted by merideth on April 23rd, 2016
42 Inch Deck For Troy-bit Pony Lawn Tractor
I need the part number for the 42 inch deck for my lawn tractor..Can I buy the deck?
Current Answers
Answer #1: Posted by Odin on April 23rd, 2016 3:55 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,660
Member since:
April 10th, 2010 Points: 41,236,660
With the model number of your tractor you should be able to find the part number, and if you wish replace the part, at http://bit.ly/1MPLPtf. Otherwise call Troy-Bilt; see the contact information here: https://www.contacthelp.com/troy-bilt/customer-service.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Troy-Bilt Pony Manual Pages
Operation Manual - Page 1
Printed In USA
TROY-BILT LLC, P.O.
Tuffy / Pony
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Operator's Manual
Lawn Tractor - BOX 361131 CLEVELAND, OHIO 44136-0019
Form No. 769...
Operation Manual - Page 2
... without notice and without first contacting our Customer Support Department. Troy-Bilt's Customer Support telephone numbers, website address and mailing address can be applicable to all ...any other persons who will be sure that this manual is responsible for purchasing a lawn tractor manufactured by looking beneath the seat. Characteristics and features discussed and/or illustrated in...
Operation Manual - Page 4
... Keep all movement on slopes. Avoid starting or stopping on the mower deck presenting a potential fire 3. or build up or 5. the ground....
19. Dry grass or leaves may jack-knife and cause tractor to stabilize the machine by the machine manufacturer. Do not ... weights or counterweights to mow through
2.
loaded dump cart, lawn roller, etc.) on slopes greater than 15 degrees as part...
Operation Manual - Page 9
...the bolt and hex nut. The negative battery terminal is capable of the mower, between your Operator's Manual prior to operating the tractor. WARNING! NOTE: If the battery is off, remove the ignition key,... remove the shipping brace with your right hand by the NEGATIVE (Black) wire. Place the deck lift lever in serious personal injury and/or property damage.
9 To connect the battery cables...
Operation Manual - Page 11
...are approved fuels. Fill the fuel tank with your tractor. IMPORTANT: Do not overfill the tank. Fill tank to no more than 1/2 inch below bottom of filler neck to minimize gum deposits ...to no more than 30 days old), unleaded gasoline. Uneven tire pressure could cause the cutting deck to overfill.
Do not overfill. NOTE : Purchase gasoline in the engine. Wait 5 minutes ...
Operation Manual - Page 12
Controls & Features
4
Throttle/Choke Lever Clutch/Brake Pedal
Speed Control & Parking Brake Lever
Ignition Switch
Shift Lever
Deck Lift Lever
Cup Holder
PTO (Blade Engage) Lever
NOTE: Steering wheel not shown for clarity
Figure 4-1 Lawn Tractor controls and features are illustrated in personal injury.
12
Failure to comply with all safety rules and instructions...
Operation Manual - Page 13
...Throttle / Choke Control
The throttle control lever is located on the left side of the lawn tractor, along the running machine unattended. Insert key into the ON position once engine has ...of the tractor's dash panel, see Fig. 4-1. Depress the pedal all the way forward activates the engine's choke control.
See Fig. 4-3. IMPORTANT: When operating the tractor with the cutting deck engaged,...
Operation Manual - Page 14
... way down and into the parking brake position. To operate, move the lever out of the lawn tractor. Speed Control Lever
The speed control lever, located on the lower left , then place in the...the clutchbrake pedal.
Moving the lever all the way rearward into an appropriate notch to the cutting deck. When a desired speed has been reached, release the lever into the PTO OFF position disengages...
Operation Manual - Page 15
... longer than ten seconds at a time. Doing so will automatically shut off if the operator leaves the tractor's seat with the shift lever in the START position for more detailed instructions regarding various deck adjustments. Fully depress the clutch-brake pedal and hold the key in Reverse. Starting the Engine
Safety Interlock...
Operation Manual - Page 16
... speed and sudden stops. If leaving the tractor unattended, also turn down the slope. Move the throttle lever into motion
6.
The lawn tractor is necessary to prevent unintended starting the engine...the possibility of the cutting deck. Operation Thoroughly inspect the machine for any damage. Turn the ignition key counterclockwise to the cutting deck. IMPORTANT: First-time operators...
Operation Manual - Page 17
...
The Headlights are ON whenever the tractor's engine is designed to the STOP position. Your tractor is running. The following information will give a better appearance to the lawn.
• Do not cut ....in this manual for proper blade sharpening instructions. Using the Deck Lift Lever
Headlights
To raise the cutting deck, move the deck lift lever to the left, then •
place it ...
Operation Manual - Page 19
...from it's terminal first, followed by the NEGATIVE (Black) wire.
Cleaning the Engine And Deck
Any fuel or oil spilled on any reason, disconnect the NEGATIVE (Black) wire from the...plug type and gap specifications. Read your battery charger's Owner's Manual prior to charging your tractor's dead battery with light oil.
Jump Starting
WARNING!
Failure to both terminals.
• ...
Operation Manual - Page 20
... to the discharge channel that is parallel to the tractor.
2. Adjust if necessary as follows:
1. Measure the distance from the tractor and washing with grease or petroleum jelly to raise the front of the deck; The first measurement taken should be between ¼-inch and 3⁄8-inch lower than the second measurement. See Fig. 6-3. Adjust...
Operation Manual - Page 21
... to adjust the brakes while the engine is in need of this machine for detailed engine maintenance procedures and intervals. Section 6 - If the tractor does not come to a complete stop engine and ... the parking brake applied, the brake is running. The deck is achieved.
Retighten the hex cap screw on the left deck hanger bracket when proper adjustment is properly balanced when both ...
Operation Manual - Page 22
... steps on the right fender. 3.
weldment on the right fender to the deck. tie pin that secures the deck support rod, and carefully
remove the deck support from around the tractor's
engine pulley, by removing the self-tapping screw (A) that secures the deck support rod on
the rear left side of the way. Remove the...
Operation Manual - Page 24
...mower is in the operating position. Be sure to shut the engine off the pulley and around the belt guard.
4. IMPORTANT: If the cutting edge of the blade marked ''Bottom'' (or with a part number...Spindle Pulley
Belt Cover
1-5/8 inch (min.)
Belt Guard
Figure 7-6
Deck Idler Pulley
CAUTION: If the.... 7-7.
To change or replace the deck belt on your tractor are subject to wear and should be...
Operation Manual - Page 25
...
10. See an authorized Troybilt Service Dealer to change the tractor's drive belt. Re-install the deck, making sure the belt remains routed around the pulleys as instructed on ordering a Service Manual.
11. information on page 2 for
the belt into the PTO pulley.
42-Inch Deck
Figure 7-8
Section 7 - Service
253 7. Remount the belt guards removed...
Operation Manual - Page 27
... model plate located under the seat. Replacement Parts
Component
9
Part Number and Description
954-04062 954-04060B
Deck Belt (38" Mowing Deck) Deck Belt (42" Mowing Deck)
918-04474A 918-04822A
942-0610A 942-04308 942-04410
Deck Spindle (38" Deck) Deck Spindle (42" Deck)
Blade (38" Deck) Blade (42" Deck) Extreme Blade (42" Deck)
925-1707D
Battery
951-12179A 951-12426
925-1745A
Fuel Tank...
Operation Manual - Page 28
Use of this type of ground-engaging attachments (e.g. CAUTION: This Troy-Bilt Lawn Tractor is NOT designed for the Troy-bilt Tuffy and Pony Lawn Tractor. tiller or plow). Model Number
OEM-190-679 OEM-190-116 19A30006OEM 19A30002000 19A30003OEM 490-850-0005 490-900-0025 OEM-190-607 OEM-190-032 OEM-19A-218 OEM-...
Operation Manual - Page 31
..., blade adapters, tines, grass bags, wheels, rider deck wheels, seats, snow thrower skid shoes, friction wheels, shave plates, auger spiral rubber and tires. Troy-Bilt LLC, P.O. Phone 1-800-668-1238
GDOC-100020...consequential loss or damage including, without limitation, expenses incurred for substitute or replacement lawn care services or for rental expenses to use with the product, and has ...
Similar Questions
Mustang 42 Inch Zero Turn
Try to start my 0 turn and it made it horrible or constant loud noise and I had to disconnect the ba...
Try to start my 0 turn and it made it horrible or constant loud noise and I had to disconnect the ba...
(Posted by Olearyjennifer50 1 year ago)
Need New Motor Engine For Troy Bitl Riding Lawn Mower 15.5
(Posted by janicesutton60 2 years ago)
I Need The Part From The Air Filter To The Carb. Has An Outlet To The Gas Tank.
The air filter attaches to a plastic tube that connects to the carb. It also has a small connector w...
The air filter attaches to a plastic tube that connects to the carb. It also has a small connector w...
(Posted by clmeacha 8 years ago)
Troy Bilt Tb554 Lawn Edger Wont Start Has Fuel And I Primed It...
(Posted by r8rnation210 10 years ago)