Singer 8280 Support Question
Singer 8280 Support Question
Find answers below for this question about Singer 8280.Need a Singer 8280 manual? We have 1 online manual for this item!
Question posted by Shelbrn2002 on March 5th, 2015
I Lost Power To My Singer 420xl.
I lost all power to my singer 420xl. It occurred after I received a message telling me the bobbin was blocked. I turned the machine off to fix the problem. Now it will not turn on!
Current Answers
Answer #1: Posted by TommyKervz on March 6th, 2015 3:09 PM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,793
Member since:
January 10th, 2013 Points: 17,776,793
please contact the nearest SINGER® Service Center listed in the section here. To locate your nearest SINGER® Service Center
Related Singer 8280 Manual Pages
Instruction Manual - Page 2
...bobbin, or changing presser foot, and the like.
10. The sound pressure level under normal operating conditions is intended for household use as a toy. SAVE THESE INSTRUCTIONS
This sewing machine...air openings blocked. Keep fingers...Always unplug sewing machine from all...sewing machine off ("O") position, then remove plug from accumulation of the sewing machine... sewing machine.... sewing machine ...
Instruction Manual - Page 5
List of contents
Principal parts of the Machine...2/3 Accessories ...4 Installing the snap-in sewing table ...5 Connecting machine to power source...6 Changing the bulb ...8 Two-step presser foot lifter/ Adjusting presser foot pressure...9 Attaching the presser foot holder ...10 Winding the bobbin ...11 Inserting the bobbin...12 Inserting and changing needles ...13 Threading the upper thread...14 ...
Instruction Manual - Page 11
..., reverse the plug. Foot control
A
The foot control pedal regulates the sewing speed. (3)
Attention: Consult a qualified electrician if in use . If it does not fit fully in any way. Connecting machine to power source
Connect the machine to a power source as to connect machine to power source. The foot control must be used with the appliance by...
Instruction Manual - Page 13
... the face plate (B). - Volver a colocar la placa frontal y apretar el tornillo.
Should there be any problem, ask your local dealer for advice. Afloje el tornillo (A) según se ilustra. (1) - Replace bulb... e instalar una nueva (C). (2) - Changing the bulb
Disconnect the machine from the power supply by removing the plug from the main socket! Si surge algún problema, consulte ...
Instruction Manual - Page 19
... module by not doing so several sewing problems could result.
- Pull about 6-8 inches of spool holder next to spool.(2)
- Note: For safety, it is strongly suggested you turn off the spool as shown. At...small thread spools, place small side of thread to length with the thread coming off the power before threading.
- Trim thread to the rear beyond the needle eye. Place the spool of...
Instruction Manual - Page 21
... for straight stitch sewing. To adjust, turn the small screw on the bottom side of fabric.
C
16
4
2 B D Thread tension
Upper thread tension Basic thread tension setting: "4" To increase the tension, turn the dial to the next number down.
Lower thread tension To test the bobbin thread tension, remove the bobbin case and bobbin and
hold it...
Instruction Manual - Page 23
... aguja. Note: If it is difficult to raise the bobbin thread, check to bring the bobbin thread up through the needle plate hole (2).
Gently pull on the upper thread to make sure the thread is not trapped by the hinged cover or the Removable Sewing Table.
Nota: Si es dificil subir el hilo...
Instruction Manual - Page 25
... fabrics-cotton, satin, kettle cloth, sailcloth, double knits, lightweight woollens.
NEEDLE, FABRIC SELECTION NEEDLES
EXPLANATION
SINGER 2020
Standard sharp needles. Natural and synthetic woven fabrics, polyester blends. Leather needles. 12 (80) to 18 (110). For best sewing results always use the same thread on natural woven fabrics for these fabrics and needle...
Instruction Manual - Page 32
... the stitch pattern selector dial.
Use seam ripper and cut buttonhole open from one step to sew the buttonhole. It is advisable to set stitch density. Lower the foot, so that marking... on fabric. Use a backing for stretch or knit fabrics. -
The zig-zag should sew over the heavy thread or cord. (5)
10 2
5 1 2 34
43
4
1
3
2
27 Adjust the stitch...
Instruction Manual - Page 36
... sistema de avance interno de la maquina de coser.
Turn work from behind the needle clamp screw (b). For stippling, stitch in any direction without the sewing machine internal feed system. It is recommended for easier sewing and better results. It is necessary to coordinate sewing speed and movement of the fabric is controlled by 1/4 and...
Instruction Manual - Page 39
... as í como el pie para zurcir y bordar.
34
4
32 1
0 The above techniques are sewing without a foot. For better control use un aro, as a Darning and Embroidery foot.
No olvide bajar el... quilting where you hoop the fabric and guide it by hand, allowing you are used to your machine. For template quilting transfer a design from a template (plastic stencil) to hold the layers of ...
Instruction Manual - Page 43
... then continue to the back of the seam, begin by pulling on the bobbin thread. Secure thread ends. Largo de la puntada: La más larga
... la costura, comience a coser costura larga y continúe hasta el final. Stitch Length: Longest
Sewing Instructions: Use this procedure once again at 1/4 of an inch from the edge of the foot.... 6 pulgadas de hilo. Gathering
Machine Preparation: -
Instruction Manual - Page 45
... the hook:
Remove the bobbin case.
Your machine should be serviced at the points (6) (1-2 drops) with sewing machine oil. Maintenance
Attention: Disconnect the machine from the electricity supply by removing the plug from the electricity supply. Replace the hook (5). Lubricate at regular intervals.
7
40
2
6 5
4 3 Remove the needle plate: Turn the handwheel until the hook...
Instruction Manual - Page 47
...quality sewing machine oil 4. The needle is too tight
1. The wrong size needle has been used 4. The needle is not correctly threaded 3. The bobbin ...bobbin case, turn the handwheel backwards and forwards by the machine
1. The needle is wrongly threaded 3. The bobbin case is damaged 2. The thread should pull easily
2. Remove bobbin case and retread and insert correctly 3. The bobbin...
Similar Questions
My 8280 Needle Breaking Due To Misalignment Of Needle And Shuttle. How To Set It
(Posted by sangrampawar9811 2 years ago)
I Get E7 Error Message On My Singer Model 7258 Sewing Machine. There Is No Refe
Error message E7 is up on my Singer Stylist model 7258 sewing machine. It is not working at all. I t...
Error message E7 is up on my Singer Stylist model 7258 sewing machine. It is not working at all. I t...
(Posted by ebellamybellamy9 5 years ago)
Beeping From Singer Sewing Machine Stylist Ii 5625
My sewing machine will beep and stop sewing after three inches of sewing. I have taken it to be repa...
My sewing machine will beep and stop sewing after three inches of sewing. I have taken it to be repa...
(Posted by arusheria 9 years ago)
Prelude 8280 How To Put The Light On
just bought this machine singer prelude 8280 shows you how to change the bulb but can't find the lig...
just bought this machine singer prelude 8280 shows you how to change the bulb but can't find the lig...
(Posted by marlenejeffs 10 years ago)
What Size Bobbin Does The 8280 Prelude Use? I Could Not Find It In The Manual!
What size Bobbin does the Prelude 8280 use? I looked thru the manual twice and could NOT find it. Th...
What size Bobbin does the Prelude 8280 use? I looked thru the manual twice and could NOT find it. Th...
(Posted by sharonmc79 10 years ago)