Home » Rheem » Pool & Spa » Rheem P-M207

Rheem P-M207 Support Question

Find answers below for this question about Rheem P-M207.
Need a Rheem P-M207 manual? We have 4 online manuals for this item!

Rheem Overview Questions Manuals Reviews Videos Research

Question posted by acmarcussen on October 28th, 2021

Heat Build Up Around Unit

Just moved into this house, and pool heater has not been used in a long time. Fired it up yesterday and ran for about 4 hours. It started making a constant high pitch screeching noise, and the unit and surrounding area heated up intensely. Any ideas?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by SonuKumar on October 29th, 2021 10:58 AM

This answer was accepted by the poster of the original question.

SonuKumar

Member since:
May 9th, 2021

Points: 16,598,000

1,110
points

Why is my furnace making a high pitched squeal?

A high-pitched squeal coming from your furnace is usually the result of an issue with the blower. The blower in your furnace is powered by a motor, which has bearings that can wear out because of age or overheating. Overheating is usually caused by dirt buildup or a bad capacitor.

https://thorntonandgrooms.com/help-guides/why-is-my-furnace-making-a-loud-noise-a-michigan-tech-explains

https://www.youtube.com/watch?v=bzCipLS7LUE

https://www.youtube.com/watch?v=CxTzOpbVaHU

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.

Regards,
Sonu
Your search handyman for all e-support needs!!

Related Rheem P-M207 Manual Pages

Brochure - Page 2

... display tells you when the water is being heated and notifies you when your preferred set your pool and spa temperature precisely at all times. The display uses real English, with the first control in the pool industry to worry about. Known for gas pressure fluctuations, meaning the heater will find galvanized metal that is more durable...

Operating Instructions - Page 3

... 2-Wire Remote Control MAINTENANCE & CARE PROCEDURES 37 3-Wire Remote Control 8 Pool & Spa Water Chemistry 38 Time Clock / Fireman's Switch 8 Automatic Chlorinators & Chemical Feeders 38 Water Pressure Switch 9 Cold Weather Operation 38 Flame Roll-Out Safety Switch 9 Winterizing the Pool & Spa Heater 38 High Limits 10 PART TWO 39 Pilot Safety INSTALLATION & SERVICE INSTRUCTIONS 39...

Operating Instructions - Page 11

... fire, and will result in an area where possible water leakage will void the warranty. Lo NOx heaters: Rated inputs are design-certified and tested under the heater. WARNING: This unit...of airborne dust and airborne fiber particles. GENERAL SPECIFICATIONS These heaters are suitable for the use wet sweeping or High Efficiency Particulate Air (HEPA) filtered vacuum to avoid creating airborne...

Operating Instructions - Page 12

...) 2. Strong air intake from combustible construction, the pool heater can disturb the combustion process and cause damage or personal injury. Alcove (Open) Right Side - 12" (Water Side) Vent - 6" Left Side - 6" Floor** - 0" (Opposite Water Side) OUTDOOR INSTALLATION: Top* - However for outdoor use. CLEARANCE FROM COMBUSTIBLE CONSTRUCTION INDOOR INSTALLATIONS: Top* - 30...

Operating Instructions - Page 13

... in Canada, pool heaters shall not be diverted away from where the flue products exit the heater must be installed under the overhang. Heaters must not be...area under an overhang of less than three 3 ft from , or 1 ft above any door, window or gravity inlet into the building. installations, the point from the heaters installed under overhangs with the Florida or Texas Building...

Operating Instructions - Page 16

... the table above 2000 ft elevation. an AFT heater using natural gas is for copper tubing. "C" is "EP"; Suffix "X" is for a Millivolt heater using propane gas is for plastic (polymer) headers. Designation for cupro-nickel tubing; a Millivolt heater using natural gas is "MP"; SPECIFICATIONS AND DIMENSIONS ATMOSPHERIC UNITS B D C INDOOR DRAFTHOOD 38" 13-1/4" GAS CONNECTION Amp...

Operating Instructions - Page 17

.... For Canada, no de-rating is for plastic (polymer) headers. Plastic (polymer) headers cannot be used for appropriate size PLUS six (6) inches. 17 Standard ASME Heater Heater Indoor w/Stackless w/Stackless Draft- Prefix "C" is "EN". "C" is for an AFT heater using natural gas is for elevations up to 4500 ft. Top Top hood 2" 174 193 14...

Operating Instructions - Page 22

... that will allow a standard ASME unit to comply with your heater connections. High temperature 2" plastic pipe (CPVC) may be threaded directly into header flanges. PVC may be used with the heater. WARNING: NEVER install PVC directly into the header flanges. NOTE: The State of Texas requires the addition of time below accelerated scaling temperatures. Kit # 012011...

Operating Instructions - Page 24

... side of the filter is plumbed to the return line to the pool or spa. The outlet of the heater is plumbed directly to the pool or spa must not have any water leaks will not damage the structure of adjacent area. Plumbing from the heater back to the discharge side of the filter pump; 2. Be advised...

Operating Instructions - Page 26

...to wiring. 2. Remove and set aside door for heat. Remove the one (1) screw. 4. Re-route all high-voltage wires and ground wires through the left side...using a time clock/fireman's switch. Mounting hole is provided on the right side of the heater. ADVANCED FLAME TECHNOLOGY (AFT) MODELS WARNING: Heaters are required. DO NOT attempt to ground the heater electrically could affect the heater...

Operating Instructions - Page 27

...WIRING For 120 VAC input power to the unit, connect the black wire to the heater from the GFCI power source. NOTE: ...heater (120 or 240 VAC) can be supplied from the load (pump) side of time clock or directly from the GFCI power source, and that the heater... using a two or three-wire remote. For Lo NOx pool heaters attach a wire nut to each red wire independently. 120V ATMOSPHERIC HEATER ...

Operating Instructions - Page 33

... alternate with "Heating." FLAME STRENGTH INDICATOR Press the DOWN button. When the water temperature is firing, "Water Temp" will also be adjusted using a bar graph and numerical display. The Run Time indicates the total hours of operation for the pool heater, as measured by the amount of the heater, allows the user to select either POOL or SPA operation. The...

Operating Instructions - Page 35

... cycled to display a variety of your pool or spa thermometer. Pilot flame not established within the required time (15 sec or 90 sec). PV Output Fault Pilot gas valve output is not in Pool, Spa and Remote modes. Ignition Lockout (Propane Tab Broken) Alternating with "Main Ign Failure" - The heater reads the water temperature at the...

Operating Instructions - Page 36

... Interface Harness Pool Common (BLK/ORN) Spa Common (ORN/BLK) 24VAC HOT (BLU) ACTIVATING THE REMOTE To activate or deactivate the remote function, follow these steps: Press and hold the UP and DOWN arrow buttons for 5 seconds before proceeding. 36 Select the appropriate instruction listed below ). For operation of the heater using the onboard...

Operating Instructions - Page 37

..." to the heater. 2. Turn on power to the heater. On the "Remote Interface Harness" connect the BLUE wire to one heating function (pool or spa) is 200 feet. • For both heating functions (pool and spa) are required. 1. To activate the remote control, see page 36. 3-Wire Remote Control Using Three-Position Switch (Pool-Off-Spa, or Low-Off-High) This application...

Operating Instructions - Page 38

... in the heat exchanger flue passage. The burners should be used in place of total wiring using 18 AWG stranded copper wire rated for 105ºC (221ºF) minimum. CAUTION: Do not operate the heater without the function of the spa or pool, it is clean before adjusting the switch. 2. Both are equipped with a time clock, connect...

Operating Instructions - Page 41

... heat is proven, the blower will be made of the burner. START-UP PROCEDURES 1. Turn on power to meet all applicable codes. Spark will turn on some areas...by a service technician after any over 110°F) and watch for GasFired Pool Heaters. Drain heat exchanger. 3. The heater should start running . System should be observed through the opening below the plenum. ...

Technical Data - Page 1

...CONNECTION 34" STACKLESS OUTDOOR TOP Amp Draw 120 volt 240 volt 28" 6 3 Shipping Weights (lbs) Heater Model M207A M267A M337A M407A BTUH Input (000) 199.5 266.0 332.5 399.0 (A) Cabinet Width ...17 20 Designation for a Digital heater using natural gas is "EN". Swimming Pool and Spa Heating Products a Digital heater using propane gas is for cupro-nickel tubing; Suffix "X" is "EP";

Technical Data - Page 2

... spa heaters. This offers valuable and useful feedback to outperform others during cold starts and provides longer component life. It's one more efficiently. • Cycle Counter and Run Time Monitor The control captures every cycle of durable service. • Wind-Resistant Design This heater is designed to be installed without notice Swimming Pool and Spa Heating Products MKG-15...

Warranty - Page 2

.... KEEP IT WITH YOUR POOL HEATER OR BUSINESS RECORDS. Catalog Number: 6000.95 Effective 06/01/06 HOW TO MAKE A WARRANTY CLAIM You should...only warranty given by Raypak. Raypak reserves the right at all times to inspect, or require the return of, the defective product... way by ANY persons or agencies other warranties on how long an implied warranty lasts, or for instructions regarding the claim...