ProForm 830qt Support Question
Find answers below for this question about ProForm 830qt.Need a ProForm 830qt manual? We have 1 online manual for this item!
Question posted by weltonlawrence on September 20th, 2016
My Pro Form 80qt Stops Working When I Step On It
Current Answers
Answer #1: Posted by waelsaidani1 on September 21st, 2016 1:32 AM
* Check the breaker on your treadmill it can be combined with the on/off switch or it can be a separate breaker. Make sure it is not open.
* If that tests ok, check to see if your getting power to the motor controller(electronic board under the hood) this can be done by following the power cord in and testing where they attach, if you are getting 120/240 volts then check the light(s) on the controller If they are not lit then the controller is bad.
* If they are lit you will need to check the dc voltage going to the motor
* Also make sure you have voltage going to the console
if you have 8-12 vdc voltage to the console and the console is dead replace the upper control board.
* If only one or none of these voltages are present then the controller is bad.
* If your treadmill is equipped with a separate power board then you will need to take voltage readings going in and coming out from the board If nothing is present then the power board is bad. If all tests well move on to the controller.
* some motor controllers are equipped with a fuse on it, if this is blown the console will not light as well.
Related ProForm 830qt Manual Pages
Similar Questions
My 830qt treadmill will run fine for about 5 to 15 minutes depending on the speed and then suddenly ...
starts and stops after stepping on, and restarts once stepped off.
I Need A Manual For My Pro Form 965
how to trouble shoot pro-form 4.0 rt model Pfex13813. It slips when resistance is added and the belt...
turn on the machine and everything works but the belt does not move nothing is bent. The machine was...