The Gap Between The Needle And Hook

Step 2 Remove the bobbin case. Lower the needle to the lowest possible position. Using the flashlight (and your reading glasses, if needed) look straight into the bobbin area. This is important! You want your eye to be perfectly level with the eye of the needle. On the new sit or stand tables, the belly bar might be in your line of vision. Tilt it outward and hold it in place with the pin on the right side of the frame. Now, you can look above the belly bar and be at the correct angle. Again, check that the needle is in its lowest position.You should be able to see 95 percent of the eye of the needle. If you see the top edge of the eye, the needle bar is down too far. To see this, look for the flashlight to reflect on the metal at the top of the eye. If you don't see nearly all of eye, the needle bar isn't down far enough.

Step 3 If the needle bar isn't set correctly, you'll need to adjust it. To do this, remove the plug in the front of the machine to expose the hole where you can access the screw holding the needle bar in place. If you have a plus machine, you'll need to remove the front display. On a Vision, remove the module to get to this hole (there may not be a plug in these machines

For more instructions please follow the link below:

https://media.rainpos.com/6654/checking_and_setting_your_needle_bar_height.pdf

Thanks