Panasonic PT-50LC14 Support Question
Panasonic PT-50LC14 Support Question
Find answers below for this question about Panasonic PT-50LC14 - 50" Rear Projection TV.Need a Panasonic PT-50LC14 manual? We have 1 online manual for this item!
Question posted by dixiecycle on October 14th, 2012
Panasonic Tv Will Not Turn On
When turned on the green light blinks for a few minutes then blinks red.
Current Answers
Answer #1: Posted by TVDan on October 14th, 2012 2:56 PM
TVDan
Member since:
August 8th, 2011 Points: 4,732,000
Member since:
August 8th, 2011 Points: 4,732,000
when this set fails to properly turn on it shuts off and blinks a code to assist in repairing. without knowing the number of blinks then we cannot assist properly.
TV Dan
Related Panasonic PT-50LC14 Manual Pages
Multi Media Display - Page 1
.... LSQT0834 D This operating instruction book is required under the Consumer Product Safety Act.
3 Improved Product Development... Multimedia Projection Display Operating Instructions
Models No. Help us to design products that this manual show the PT-50LC14.
Registering your product can help us continue to contact you in the unlikely event a safety notification...
Multi Media Display - Page 3
...8226; Equipped with the following TV stand: model TY-43LC14C or TY-43LC14C-B for the PT-43LC14, TY-50LC14C or TY-43LC14C-B for the PT-50LC14, and TY-60LC14C or TY...lightings, etc.
DO NOT ALLOW CHILDREN TO HANDLE THE SD CARD. is a registered trademark, and is required for the PT-60LC14. BBE and BBE symbol are trademarks or registered trademarks of this can result in the projection...
Multi Media Display - Page 4
... the projection display to provide reasonable protection against harmful interference in a particular installation. Dear Panasonic Customer
Welcome to radio communications. To obtain maximum benefit from your set in accordance with the instructions, may not cause harmful interference, and (2) this equipment. Declaration of Conformity
Models Number:
PT-43LC14/PT-50LC14/PT-60LC14...
Multi Media Display - Page 6
.... At least 1.6 m (PT-43LC14) / 1.8 m (PT-50LC14) / 2.2 m (PT-60LC14).
6
For assistance, please call : 1-888-VIEW PTV(843-9788) or, contact us via the web at: http://www.panasonic.com/contactinfo Before Using
Receiver Location
This projection display is essential to be used with shielded video and audio cables. Avoid placing where sunlight or other bright light (including re...
Multi Media Display - Page 10
...panasonic.com/contactinfo Location of Controls
Controls and Terminals on the projection display
Model PT-50LC14 unit shown
< FRONT >
POWER button/ POWER indicator (PP. 22, 82)
Volume up(+) / down(-) buttons (P. 30)
A
LAMP indicator This indicator lights... lights up when there is an abnormal temperature in the unit. (PP. 82-83)
Remote Control Sensor
Channel up / down buttons (P. 30)
TV/VIDEO...
Multi Media Display - Page 11
Getting Started
Model PT-50LC14 unit shown
< REAR >
Location of Controls
< SIDE >
Vent
Vent
VHF/UHF terminal (PP. 12-14)
RGB Input 1 terminal
HDMI Input terminal
(For PT-50LC14/PT-60LC14) (P. 20)
(P. 18)
RGB (PT-43LC14) or RGB2 (PT-50LC14/ PT-60LC14) Input terminal (P. 18)
Input 1, 2 terminals (P. 15)
Component signal input 1-4 terminals (P. 16)
AV out terminals (P. 17)
Input 3 ...
Multi Media Display - Page 14
...
Incoming Cable from Antenna or Cable TV System
CABLE BOX
Note: • When the RF coaxial cable is input from the Output terminal on the back of the Cable Box or antenna/cable system to the projection display VHF/UHF terminal via the web at: http://www.panasonic.com/contactinfo This does not...
Multi Media Display - Page 18
...cannot be connected to RGB IN
COMPUTER
Conversion adapter (If necessary)
Example: PT-50LC14/PT-60LC14
RGB cable (D-SUB 15P) Connect a cable which are above or ...TV/VIDEO button. (P. 35) • Similar connections are available at the RGB IN 1, 2 Terminals (For PT-50LC14/PT-60LC14).
18
For assistance, please call : 1-888-VIEW PTV(843-9788) or, contact us via the web at: http://www.panasonic...
Multi Media Display - Page 22
The Power Indicator blinks Green for a few seconds. ANTENNA -
ON (Preparing to turn the projection display power ON and OFF. • The lamp cooling fan will blink Red.
POWER SAP
LIGHT TV VCR DVD
DTV RCVR DBS/CBL AUX
TV/VIDEO
A -
In this case, the lamp will be insufficiently cooled and
will be sure to follow the procedure...
Multi Media Display - Page 30
...LIGHT TV VCR DVD
DTV RCVR DBS/CBL AUX
TV/VIDEO
A - Press to select the desired channel. (Or use Number keys )
1
2
3
4 7
R-TUNE
SWAP REW
5
8
0
SPLIT PLAY
6 9
PROG
SPLIT CTRL FF
PAUSE
STOP
REC
FREEZE TV.../VCR
SPLIT CH
SEARCH
DVD/VCR CH OPEN/CLOSE
Or
1
2
3
4
5
6
7
8
9
0
Unit
4
Note: • Refer to select the desired channel. Press to turn the projection display...
Multi Media Display - Page 32
... viewing the picture at : http://www.panasonic.com/contactinfo JUST
ZOOM
NORMAL
FULL
)8//
• When a 480p signal is projected in 4:3 mode so you may no ...longer be seen.
32
For assistance, please call : 1-888-VIEW PTV(843-9788) or, contact us via the web at its maximum size, including wide screen cinema format picture. POWER SAP
LIGHT
TV...
Multi Media Display - Page 35
...
PAUSE
STOP
REC
FREEZE TV/VCR
SPLIT CH
SEARCH
DVD/VCR CH OPEN/CLOSE
Turning the power on and switching input modes
1
Turn the projection display on the front of source connected to INPUT 1 is selected. • Pressing SD again exits
Card input mode. COMPONENT 1 *
RGB 1*
(For PT-50LC14/PT-60LC14)
RGB*
(For PT-43LC14)
(P. 52)
COMPONENT 2 *
Card...
Multi Media Display - Page 36
... FF
PAUSE
STOP
REC
FREEZE TV/VCR
SPLIT CH
SEARCH
DVD/VCR...panasonic.com/contactinfo
Sound is also reactivated when power is turned off or volume level is changed.
087(
Note: • The audio output from AV OUT is not muted. ANTENNA - Press again to mute the sound. Mute / Freeze / SAP
POWER SAP
LIGHT TV VCR DVD
DTV RCVR DBS/CBL AUX
TV/VIDEO
A - Freezing pictures
Projection...
Multi Media Display - Page 38
...LIGHT
TV
VCR DVD
DTV RCVR DBS/CBL AUX
TV/VIDEO
A - ANTENNA - Notes: • Sound from the Left screen is output from the rear...projection display is turned...projection
display set. • When the screen is nonexistent, the entire screen will go black and "SIGNAL" will be displayed.
38
For assistance, please call : 1-888-VIEW PTV(843-9788) or, contact us via the web at: http://www.panasonic...
Multi Media Display - Page 46
...TV PROGRAMS ratings.
With
the OSD at : http://www.panasonic.com/contactinfo Or
Or,
Press to display LOCK menu for rating screen and go to enter a new code.
Lock Feature
This projection...
*8 63$&( 0(18(;,7
/2&. &21),50',*,7&2
(17(5
Changing your secret code ...TV usage based on page 49. POWER SAP
LIGHT
TV
VCR DVD
DTV RCVR DBS/CBL AUX
TV/VIDEO
A -
Multi Media Display - Page 60
...
Press to display the OTHER ADJUST screen.
(For PT-50LC14/PT-60LC14)
Press to select desired RGB input.
3,&785...PT-43LC14)
3,&785( $8',2 &+$11(/ 6(783 /2&. 27+(5 /$1*8$*(
*8 6(/(&7 6(7 0(18(;,7
5 3 5/(9 9 9 00$0,' %/$&.(;7 &2/25&2552))
4
Press to the projection display's RGB IN terminal. POWER SAP
LIGHT
TV
VCR DVD
DTV RCVR DBS/CBL AUX
TV...
Multi Media Display - Page 80
... yourself. Panasonic warranties the original Lamp for over 24 hours, the number of times lit, the length of the TV. For... LAMP indicator light will continue to
cool before replacing it. Please wait more urgently] • The projection display has...minute of the projection display, follow these warnings when replacing the lamp unit could cause injury. 2) Because the lamp unit is turned...
Multi Media Display - Page 81
...more than one hour for about 10 minutes. Replacing the lamp unit
Lamp replacement procedure
1 Turn power off, wait until power indicator stops blinking red, then unplug the power cord from...urgently]
• The Projection display has a forced cooling feature. After the POWER button is turned OFF, and during the first minute of old lamp. The LAMP indicator flashes red 5 times every 5...
Multi Media Display - Page 83
... TV Power is • This is because the cooling fan is displayed. An OSD instructing to replace the lamp is displayed. (The LAMP indicator is lit red.)
• Replace lamp with a soft cloth.
-
An OSD advising is operating.
gently rubbing the stained areas with a new one .
LAMP indicator blinks red.
Image shakes. Image is turned...
Multi Media Display - Page 84
...50-inch, 16 : 9 aspect ratio 60-inch, 16 : 9 aspect ratio
Speaker
2 Speakers 30 W [15 W + 15 W ] (10 % THD)
HID Lamp
100 W HID (High Intensity Discharge) Lamp
Channel Capability
VHF-12 : UHF-56 : Cable-125
RGB INPUT
(PT-43LC14)
RGB analog 0.7 Vp-p (75 Ω) (D-SUB15P)
RGB INPUT 1-2 AUDIO 0.5 Vrms (M3 Stereo mini Pin Jack)
(PT-50LC14/PT-50LC14...at : http://www.panasonic.com/contactinfo
Similar Questions
Pt-44lcx65 Tv Wont Power On Lamp Light Blinks Red
(Posted by psChas6 9 years ago)
Panasonic Tv Pt50lc14 Why Green Light Blinking And Wont Turn On
(Posted by JASOagra 10 years ago)
Panaconic Pt50lc14 Rear Projection Tv
A few months ago we replaced the bulb. Just this week while the tv is one it will just shut off blin...
A few months ago we replaced the bulb. Just this week while the tv is one it will just shut off blin...
(Posted by kkramer 12 years ago)
How Do I Hook Up A Dvd Player To My Panasonic Pt-50lcx64 - 50' Rear Projection T
how do i hook up a dvd player to my Panasonic PT-50LCX64 - 50" Rear Projection TV
how do i hook up a dvd player to my Panasonic PT-50LCX64 - 50" Rear Projection TV
(Posted by Anonymous-46807 12 years ago)