Panasonic CY-RC50KU Support Question
Panasonic CY-RC50KU Support Question
Find answers below for this question about Panasonic CY-RC50KU - Rear View Camera.Need a Panasonic CY-RC50KU manual? We have 1 online manual for this item!
Question posted by porschecab930 on April 5th, 2013
Mirror Image??
I have the above model cy rc 50 ku, and wanted to reverse the mirror image as I'm usung it for a front end camera.
I want to reverse the image so what I view in front of me will be normal viewing.
Current Answers
Related Panasonic CY-RC50KU Manual Pages
Operating Instructions - Page 1
English
Universal Rear-View Camera
Model
CY-RC50KU
Operating Instructions
108&3
$".&3" */
7*%&0 065
O Please read these instructions (including "Limited Warranty" and "Customer Services Directory") carefully before using this product and keep this manual for future reference.
Operating Instructions - Page 2
...may result in this manual.
It is also limited. Reverse slowly, checking safety by eye, rather than relying on ... consult your dealer or service center.
The meanings of view which can be displayed is important that state could cause...Failure to request fuse replacement or repair. The camera image is a breakdown (no image, no responsibility for safety with people and objects....
Operating Instructions - Page 3
...of dirt, wax etc., then fasten the camera securely in a fire, electric shock or breakdown. Non-vehicular use (such as use the accessories provided and the parts specified.
...ignition, electric shock, injury and breakdown. R Do not damage cords.
R Do not damage the rear view camera cord.
For safety, ask your dealer to wash the vehicle. Wipe the mounting area clean of...
Operating Instructions - Page 4
... checking the unit or your own repair after your checking. Screen display is unclear.
O If the camera is viewing the sun directly, or a strong light (reflection from the camera. Problem
Possible cause ° Possible solution
No image from a fender, a headlight beam etc.) shines into it is recommended to take the unit to...
Operating Instructions - Page 5
locate your nearest Authorized Servicentre at : 1-800-211-PANA (7262), Monday-Friday 9 am-9 pm; purchase Parts and Accessories; For hearing or speech impaired TTY users, TTY : 1-877-833-8855
Accessory Purchases:
Purchase Parts, Accessories and Instruction Books online for all Panasonic Products by visiting our Web Site at: http://www.pasc.panasonic.com or...
Operating Instructions - Page 6
... on the rear)
O Rear view camera control unit 76 mm x 27 mm x 40 mm {3" x 1 1/16" x 1 9/16"} Weight
O Rear view camera Approx. 90 g {3.2 oz.} (including cord) O Rear view camera control unit Approx. 110 g {3.9 oz.}
Note: O Specifications and the design are subject to modification without notice due to
improvements in Japan Panasonic Consumer Electronics Company, Division...
Operating Instructions - Page 7
... protective devices such as rust or water leakage may result in a way so that all vehicle systems function normally. Warning
Observe the following warnings when installing. Use on a DC 12 V grounded vehicle. R This...the vehicle when mounting. If any wiring or installation work normally, fire, electric shock or accident could cause electric shock and injury from other small ...
Operating Instructions - Page 8
...
O A burned image could result. O It uses a wide-angle lens, which mimics the orientation of the sun for checking the view behind you by accident or design, incorrect operation or usage under other abnormal conditions will, as a rule, require payment of repair fees. Do not display a direct view of the rear-view and side mirrors), and is...
Operating Instructions - Page 10
... and DOES NOT COVER normal wear and tear or...One (1) Year
Not Applicable
Accessories (in materials and workmanship and...FOR A PARTICULAR PURPOSE. Panasonic Consumer Electronics Company or Panasonic Sales Company (...been improperly installed, subjected to the original end user purchaser only.
ONE (1) YEAR, PARTS...AUDIO PRODUCT - Customer's Record
Model No. IN NO EVENT WILL...
Operating Instructions - Page 11
... quantities.
Rear view camera Rear view camera (with Rubber water seal) control unit
Camera bracket
Bolts with washer
4 m cord
(1)
Hexagon wrench
Power cord
(1) RCA cord
(1) M3 × 6 mm
(2)
Clip connector
Cord clamp
(1) 5 m Cord rail
(1) 6 m Tie band
(1)
(1)
Velcro tape
(7) 18 cm
(4)
Double-sided tape
(2) 38 × 70 mm
(1)
30 × 70 mm
(1)
Q Accessories
Operating...
Operating Instructions - Page 12
... Hatchback or Van type
Cord clamp
Harness cover Tie band Tie to the appropriate size.
Rear view camera
Rear view camera control unit
Cord rail (peel off backing paper) Cut to the harness cover. Route the...Fasten with cord clamps at key points, then bring the cord into the interior.
to rear view camera.) Place against the rubber gasket and bring the cord in the cord so that it is...
Operating Instructions - Page 13
... area of the cord and penetrate to rear view camera.) Rubber gasket
Attach the rubber water seal so that the camera cord is closed
Rubber water seal (Attached to the interior of the camera, causing breakdowns. Sedan type
Cord clamp
Trunk lid Rear view camera Rubber gasket
Rubber water seal (Attached to rear view camera.)
View with the rubber gasket when the...
Operating Instructions - Page 14
...weather. O Use a dryer etc. Adjust the angle and check that the required field of view is visible. (It is low, use , and the possible angle adjustment, vary according to thoroughly ... water, pull it or subject it does not contact the vehicle body or rear wipers. Mounting procedure
Rear view camera
Before mounting Wipe away all moisture. O When the air temperature is not possible to ...
Operating Instructions - Page 15
... O Close to heater ducts or heat-emitting objects O Places exposed to water O Places which could be stepped on carpet etc.
Rear view camera control unit
Mounting on hard surfaces (floor etc.)
Rear view camera control unit
Velcro tape
Double-sided tape
Note: Do not mount the control unit in the following locations, which could cause...
Operating Instructions - Page 16
...Q Installation procedure Disconnect the battery terminal.
108&3
$".&3" 7*%&0
*/
065
Make wiring connections. Power cord (5 m)
Ground lead (Black)
RCA cord (6 m) Rear view camera (4 m)
(/%
Reverse lead (Violet/white stripe)
1 A
Fuse 1 A
3&7&34&
(Yellow)
To camera image input terminal or video input terminal NTSC Only
To a metal part of the vehicle body Connect to a point that has...
Operating Instructions - Page 17
...) (Black)
Car chassis
Car Navigation System (CN-NVD905U: option)
Rear view camera control unit
Rear view camera -
Reverse lamp
Reverse lead (Violet/white stripe) Cut off the end terminal and connect to the clip connector. RCA conversion cable
RCA cord
(supplied with CN-NVD905U)
(Yellow) (6 m)
(Yellow)
Rear view camera (4 m)
Connection to a Car Monitor (example)
Connect to the...
Operating Instructions - Page 18
...Clip connector
P
R N
ʴʵ
D
L 2
Video input
3&7&34&
1 A
Reverse lead (Violet/white stripe)
Battery
(/%
Ground lead (Black)
Car chassis
Car Monitor NTSC Only
(Yellow) Rear view camera control unit
Reverse lead Cut off the end terminal and connect to the clip connector.
(Yellow)
RCA cord (6 m)
Rear view camera (4 m)
How to attach a clip connector Insert the cord into...
Operating Instructions - Page 19
... the Hexagon wrench to Peel the backing paper and press the camera
fit the form of the monitor.
Camera bracket
O Do not re-attach the adhesive.
Mount the camera body onto the camera bracket.
Logo
Logo
Hexagon wrench
Rear view camera Side with washer
Side view
The screw holes to use, and the possible angle
adjustment, vary according...
Similar Questions
Back-up Knoopcell Leeg......
Wie kan mij helpen de basis instellingen opnieuw in de camera te krijgen? Kan ik die ergens download...
Wie kan mij helpen de basis instellingen opnieuw in de camera te krijgen? Kan ik die ergens download...
(Posted by info53904 1 year ago)
Image Transmission Tool
Hi,To whomit may concern How to get image transmission tool for panasonic Av-HS300
Hi,To whomit may concern How to get image transmission tool for panasonic Av-HS300
(Posted by mansoormoslemi 10 years ago)
How Do I Set Up A Camera Monitoring Position?
One of the cameras will move to a set position after I've been panning with the PTZ. I'm trying to s...
One of the cameras will move to a set position after I've been panning with the PTZ. I'm trying to s...
(Posted by tlboone 11 years ago)
Multi-screen Camera Selection/entry
The manual for our WV-CU650 is very limited on detail with respect to the multi-screen display. It d...
The manual for our WV-CU650 is very limited on detail with respect to the multi-screen display. It d...
(Posted by bchick 12 years ago)
I Have The Sh-fx65t System Rear Wireless Broke Can I Set Up Sh-fx60t To My Syste
(Posted by kevinleblanc 13 years ago)