Maytag MHWE200XW Support Question
Maytag MHWE200XW Support Question
Find answers below for this question about Maytag MHWE200XW.Need a Maytag MHWE200XW manual? We have 2 online manuals for this item!
Question posted by Sergehd1 on June 22nd, 2014
Cold Water Continues To Fill Up Washer, I Have To Turn Water Valve Off
The person who posted this question about this Maytag product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by Odin on June 22nd, 2014 7:41 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MHWE200XW Manual Pages
Owners Manual - Page 3
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. The parts supplied are in the washer drum. Tools needed for connecting the water inlet hoses ■ Pliers (that open to 19/16" [39.5 mm])
■ Flashlight (optional)
Tools needed for connecting the drain hose ■ Locking pliers (that...
Owners Manual - Page 4
...) tall drain tub or utility sink and sump pump (available from whom you will need to the washer.
■ A grounded electrical outlet located within 4 ft. (1.2 m) of the hot and cold water fill valves, and water pressure of the washer. Your washer can cause damage in temperatures below 32°F (0°C). Proper installation is not recommended.
■ A sturdy...
Owners Manual - Page 7
... and inlet hoses, into a laundry tub, drainpipe or bucket, to the hot water faucet and that the cold water hose is seated on coupling by a certified technician. NOTE: Do not overtighten. Attach a hose to work properly. Firmly seat the washers in the rear panel of the washer that the rear of the washer is within approximately 3 ft...
Owners Manual - Page 8
... system can result.
4.
C. Screw on coupling by hand until it is in place, release pliers.
Laundry tub drain or standpipe drain
Connect the drain hose form to the washer's cold (C) water faucet. Bend drain hose over the end of the drain hose form to the drain hose at the point where the corrugation begins...
Owners Manual - Page 9
... are in the laundry tub or standpipe as shown. Slide the washer to its top edges.
7. Plug into the detergent dispenser. If the washer is against the washer cabinet. If the washer is not level....
Drape the power cord over the washer top.
2. Check that both water faucets are recessed, put more than 4½" (114 mm) of the washer. If the washer faucets and the drain standpipe are on...
Owners Manual - Page 10
...if selected. The time of operation may be added to use the minimal amount of water needed to clean and rinse the clothes. Adaptive Variable Speed Motor
The motor adapts to...the enzymes have less moisture than for a conventional washer.
Smart Dispensers
The three compartments in the dispenser allow loading of all laundry products before the washer is dispensed in the rinse cycle or in all...
Owners Manual - Page 11
...Laundry
Before washing clothes for more than one garment bag be used and that more detailed information. Tightly packed items can be caught within the washer resulting in the washer. Close the washer door by turning... front of the tub for the selected cycle will create too much sudsing with less water, will illuminate. It may also result in the "Changing Cycles and Options" section....
Owners Manual - Page 12
...or oxi products to use .
Pausing or Restarting
1. To continue the cycle, press and hold START/PAUSE (for your main ...Illustration) Follow the manufacturer's instructions to determine the amount of water to this
dispenser to add powdered chlorine or any time, ... a cycle, use the proper dispensers when adding laundry products. To pause the washer at the best time during the wash cycle, ...
Owners Manual - Page 13
...continue the cycle. Press RINSE, DRAIN & SPIN. 3. Items can be
removed.
When this feature except Rinse, Drain & Spin and Clean Washer with all buttons are disabled except for 3 seconds until the CONTROLS LOCKED Status light turns..., all Cycles. The washer door unlocks, and items can be
removed from the washer. Press POWER/CANCEL. 2. NOTE: If the water level or the temperature is...
Owners Manual - Page 14
... performance to thoroughly saturate your laundry. Each cycle is unbalanced. ...Cold
Extract™
0:34
Cold/
Low
Cold
0:37
Cold/
Low
Cold
0:26
Cold
Ex High
0:14
NA
Ex High
Cycle
Estimated
Time* (hr:min)
Temp
Spin Speed
Soak
0:30
Warm/
No Spin
Cold
Clean Washer with MaxExtract™ spin speed and additional water...and modifiers you to continue the cycle. The preset...
Owners Manual - Page 15
... the FRESH SPIN™ option indicator light will contain a higher amount of water at anytime to unload your laundry. This option provides an additional rinse with AFFRESH™ cycle once a month...your cycle selections. Use this cycle with warm or cold water followed by selecting the speed you are part of normal washer operation. This option provides periodic tumbling for gentle ...
Owners Manual - Page 16
... tablet
✔
✔
AFFRESH™
or chlorine bleach
16 When Stain Treat is selected, the water temperature of medium and high speed tumbling.
The washer continues automatically from your cold
faucet. Controlled Temperature Warm and cold wash temperatures are sensed and maintained by regulating the amount of organic stains such as your faucet. Cycle Signal...
Owners Manual - Page 17
... detergent to use. Small items can be filled with less water, will likely result in a mesh garment bag. brush away lint and dirt.
■ Turn wool and synthetic knits inside out.
■ Separate dark colors from light colors, colorfast items from washer after the cycle is recommended that more than one garment bag...
Owners Manual - Page 19
...■ Refer to reduce the risk of warm tap water. Always do the following to maintain washer freshness ■ Use only HE High Efficiency detergent....water volumes in the dishwasher.
4. Using the AFFRESH® washer cleaner (Recommended): Add one AFFRESH® washer cleaner tablet to start the cycle again.
8. Use of more than 2/3 cup (160 mL) of washer interior. The cycle will continue...
Owners Manual - Page 20
... attach to the rear panel of HE detergent for an extended period of R.V.-type antifreeze in washer or reconnect power. 5. Turn on vacation or not using your washer. Unplug the power cord. 3. Non-use washer again:
1. Disconnect the water inlet hoses from faucets, then drain the
hoses and clip them to
rear panel clips. 4. Follow...
Owners Manual - Page 21
... unlocked, and during the washing, rinsing, or spinning process. Check household plumbing (laundry tubs, faucets, drainpipe, water pipes) for color-safe bleach.
21 Slowly pour into the liquid chlorine bleach dispenser (on a pedestal, the washer must be secured to the washer basket. Do not use the chlorine bleach dispenser for leaks. Check under the...
Owners Manual - Page 22
...won 't fill
■ Low water pressure at the end of water will unlock. Hold for details.
■ Are the laundry products in the dispenser compartment. Washer won 't power up
■ ... using HE detergent? After the CLEAN WASHER with detergent.
■ Are both the hot and cold water faucets turned on ? Run another cycle. Verify hot and cold valve at the end of the drain....
Owners Manual - Page 23
... or spin, water remains in washer
■ Is the drain hose clogged, or the end of lightly soiled garments. Incorrect water temperature or Wash/Rinse temperature
■ Are the hot and cold water inlet hoses reversed? As your frequency of movement).
■ Is the load balanced? Not enough water/Not enough suds
■ Low water? See "Secure...
Owners Manual - Page 24
... dissolve the detergent. Consider using a low speed wash cycle? Use the Delicate cycle or another cycle with this washer. Check that the hot and cold water hoses are washing. Use enough HE detergent to provide a hot water wash.
■ Are you using liquid detergent.
■ Did you use liquid detergent for the load being...
Owners Manual - Page 25
...original consumer purchase. Service calls to repair or replace appliance light bulbs, air filters or water filters. Replacement parts or repair labor on how to use your sales slip together for... that prevent function of the washer and that vary from the date of original purchase, when this major appliance was purchased. MAYTAG® LAUNDRY LIMITED WARRANTY
This Maytag Limited Warranty...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Display shows LF - Top-load washer with Dispensers in Corners
... continue to gravity. Turn on the washer clogged? Completely open both the hot and cold water faucets turned on water, and check for details. Are the water inlet valve screens on the water. Turn off the water and remove inlet hoses from the floor). Remove any accumulated film or particles from being continuously sucked out of water can siphon back into the drainpipe or laundry... -
Washer will not fill or start - Bravos washer with agitator
...? Select Spin Only to continue. Do not add detergent. Use cold water. Are you using Auto Water Level? Turn on a fuse box, check to start a new cycle. If the lid is not opened between cycles, the washer may appear to the load once the washer started . NOTE: Both hot and cold water must be connected to... -
Wash light remains on - Top-load HE washer with Dispenser Drawer
...? The washer will break the suction. The flow of drain hose in the Installation Instructions), will not fill or start to see if the hot and cold water faucets are turned on ? Remove any accumulated film or particles from being continuously sucked out of the machine (siphoning) as described in the drainpipe or laundry tub...
Similar Questions
Machine Won't Fill With Cold Water. Works Good With Hot. Cold Supply Good.
Money goes in. Machine comes on. Fill with hot water. Goes through cycle perfectly. Put on cold wate...
Money goes in. Machine comes on. Fill with hot water. Goes through cycle perfectly. Put on cold wate...
(Posted by subashramkaran 6 years ago)
Maytag Model Mhwe200xw Cold Water Continues To Fill Up Washer, It Will Not Stop
Filling, We Had To Turn Cold Water Valve Off. It Will Keep Filling And Overflow Out Onto Floor. Than...
Filling, We Had To Turn Cold Water Valve Off. It Will Keep Filling And Overflow Out Onto Floor. Than...
(Posted by Sergehd1 9 years ago)
How Do I Get To The Cold Water Valve On A Maytag Mvwc300vw Washer
(Posted by ossllc 9 years ago)
Why Does Washer Leak Some Water During Soak Mode. Washer Was Bought 3-28-2011
Why does water leak during SOAK MODE washer was bought 3-28-2011 bearly a year old.. There was no cl...
Why does water leak during SOAK MODE washer was bought 3-28-2011 bearly a year old.. There was no cl...
(Posted by smrtlx 11 years ago)