Maytag MHWE200XW Support Question
Maytag MHWE200XW Support Question
Find answers below for this question about Maytag MHWE200XW.Need a Maytag MHWE200XW manual? We have 2 online manuals for this item!
Question posted by Sergehd1 on June 22nd, 2014
Maytag Model Mhwe200xw Cold Water Continues To Fill Up Washer, It Will Not Stop
Filling, We Had To Turn Cold Water Valve Off. It Will Keep Filling And Overflow Out Onto Floor. Thanks For Your Help
Current Answers
Answer #1: Posted by BusterDoogen on June 22nd, 2014 12:09 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,447
Member since:
October 30th, 2011 Points: 28,565,447
Go here for the most likely part failures & repair help for your overflow problem.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Maytag MHWE200XW Manual Pages
Owners Manual - Page 3
Inlet hose washer (4) D. Beaded strap G. Inlet hose (2) C. Hose clamp
3 Tools needed for connecting the water inlet hoses ■ Pliers (that open to 19/16" [39.5 mm...form B. Drain hose
B
C F G
E. Transport bolt hole plug (4) F. The parts supplied are in the washer drum. INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Owners Manual - Page 4
...)
Optional pedestal
Pedestal Height
Approximate Height with a maximum slope of the washer is attached to the washer.
■ A grounded electrical outlet located within 4 ft. (1.2 m) of the hot and cold water fill valves, and water pressure of 20-100 psi (137.9-689.6 kPa).
■ A level floor with Washer
Color Model Number
10" (254 mm) 46" (1168 mm) White WHP1000SQ
15.5" (394...
Owners Manual - Page 6
...breaker is required. The top of the laundry tub must be at least 30" (762 mm) high and no higher than 96" (2.4 m) from the bottom of the washer. If a mating outlet is not ...120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is recommended. Floor drain system (view D) The floor drain system requires a siphon break that the ground path is properly grounded.
■ Do not ...
Owners Manual - Page 7
... a laundry tub, drainpipe or bucket, to get rid of the water to make sure that the hot water hose is connected to the water faucets
Make sure washer drum is seated on the washer.
2.
Washer
Connect the inlet hoses to the hot water faucet and that support the suspension system during transportation. Screw on for the washer to be turned...
Owners Manual - Page 8
... reduce the risk of hose failure.
To keep drain water from washer drum 1. A
B
A. See Floor drain under "Tools and Parts."
8 Slide drain hose onto washer connection.
3. Attach the cold water hose to the washer's hot (H) water inlet valve. Using pliers, tighten the couplings with an additional two-thirds turn. Damage to the valves can be secure, but loose enough to provide...
Owners Manual - Page 9
... check that both water faucets are in firm contact with the floor, use a level). Repeat steps 1-3 until washer is not recommended. 1. Secure the Drain Hose
Drain hose must be secured to adjust back feet.
4. NOTE: Installing washer on the feet must be tightened. Select NORMAL and then press START/ PAUSE. Repeat to stop the hose...
Owners Manual - Page 11
...a guide to using your washer. Please refer to specific sections of this washer. Do not store laundry products on the handle. ...that more detailed information. Turn on the washer by pressing POWER/CANCEL ...helpful when you are made to produce the right amount of suds for small items.
2. Load evenly.
■ Wash small items such as it stops. This wash system, along with less water...
Owners Manual - Page 12
... the manufacturer's instructions to determine the amount of water to the washer during the first rinse after the wash cycle. ... selected. ■ Do not fill beyond the "MAX" level. The washer powers down the washer manually after the cycle is complete...not put laundry products directly into the wash tub. 7. ...detergents. To continue the cycle, press and hold START/PAUSE (for you do ...
Owners Manual - Page 13
...unlock, press START/PAUSE. NOTE: If the water level or the temperature is over, the wash cycle needs to add ...hours or until the CONTROLS LOCKED Status light turns off.
Done
The Done light comes on the stage of the washer and cycle or option changes during a ... can add an additional item to continue the cycle. All cycles have this light is locked. To continue the cycle, close the door and...
Owners Manual - Page 14
... continue ...the desired cycle. Simply select your water pressure, water temperature, detergent, and clothes load... allows you to save your laundry. To use this combination again...Cold
Extract™
0:34
Cold/
Low
Cold
0:37
Cold/
Low
Cold
0:26
Cold
Ex High
0:14
NA
Ex High
Cycle
Estimated
Time* (hr:min)
Temp
Spin Speed
Soak
0:30
Warm/
No Spin
Cold
Clean Washer...
Owners Manual - Page 15
... to 6 hours to help remove set -in the display window.
2nd Rinse
A 2nd rinse can reduce the spin speed by adding options to your laundry. You will be momentary pauses. The FRESH SPIN™ option will automatically stop and the door lock will hear water spraying and splashing during the Clean Washer with a selected cycle...
Owners Manual - Page 16
...washer continues automatically from your cold
faucet. Stain Treat
Use this option for suggested load types and their corresponding cycles.
Silk
Silk or ultra delicate fabrics labeled as it stops. Controlled Temperature Warm and cold...fade Light soils
In wash water temperatures colder than 60°F (15.6°C), detergents do not dissolve well.
Laundry Guide
Refer to the selected...
Owners Manual - Page 19
... unlock, lock again, and then the cycle will continue.
■ The machine will not fill, but the basket will unlock.
IMPORTANT: ■ Wear rubber gloves when cleaning for better
ventilation and drying of liquid chlorine bleach to ensure that uses higher water volumes in the washer.
Unlock the dispenser drawer by pressing the POWER...
Owners Manual - Page 20
.... Non-use washer again:
1. This helps avoid unintended flooding (due to a water pressure surge) while you are away.
■ Slightly open door to clean the washer and remove the...water faucets. Unplug the power cord. 3. If you should: ■ Unplug washer or disconnect power.
■ Turn off the water supply to clean the washer and remove the antifreeze, if used .
20 Unplug washer...
Owners Manual - Page 21
... draining. In U.S.A. www.maytag.com/help In Canada www.maytag.ca
Error codes
An error code may be tightened against the washer cabinet. You may be ...washer basket. Check household plumbing (laundry tubs, faucets, drainpipe, water pipes) for color-safe bleach.
21 Measure detergent and fabric softener. Slowly pour into the liquid chlorine bleach dispenser (on a sturdy and solid floor...
Owners Manual - Page 22
....
■ Are the laundry products in the dispenser compartment.
Press POWER/CANCEL on ? Run another cycle.
See "Level Washer."
■ Has the drawer dispensed detergent? Washer won 't shut off the water and remove inlet hoses from the washer. Washer stops working outlet, and check for 1 second? Verify hot and cold valve at home? After the CLEAN WASHER with detergent.
■...
Owners Manual - Page 23
.... Suds during certain cycles. See "Secure the Drain Hose." Washer continues to the standpipe? If the laundry is used.
■ Is the load balanced?
When an imbalance occurs, an imbalance routine will attempt to continue. Add more items or redistribute the load. Check if the valve is blocked open end drum up and down while...
Owners Manual - Page 24
... and cold water hoses are washing. Wash water colder than 60°F (15.6°C)? Add liquid fabric softener to the right faucets. Unload the washer as soon as Delicate.
■ Did you have hard water? A hot rinse followed by spin will not operate correctly with a low spin speed to remove soil and hold it stops.
■...
Owners Manual - Page 25
... light bulbs, air filters or water filters. Service calls to obtain ...purchase date is reported to better help can find this major appliance is... that prevent function of the washer and that existed when this ...model number and serial number. This warranty gives you specific legal rights, and you need to determine if another warranty applies. MAYTAG® LAUNDRY LIMITED WARRANTY
This Maytag...
Energy Guide - Page 1
...Cost
(when used with an electric water heater)
$17 ▼
$10
$71
Cost Range of Similar Models
161 kWh
Estimated Yearly Electricity Use
...models. • Estimated operating cost based on eight wash loads a week and a 2007
national average electricity cost of 10.65 cents per kWh and natural gas cost of this label before consumer purchase. U.S. Clothes Washer Capacity: Standard
Maytag Model...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washer will not fill - Front-load Epic® washer
...-water-usage washer. If the problem continues, call an electrician. Some models will fill from the top, while other models will fill from the bottom so the water will not fill. Straighten the water inlet hoses. Remove any accumulated film or particles. Allow the unit to unlock. Check the household faucets to see if the hot and cold water faucets are turned... -
Washer is not cleaning laundry - Top-load washer
...? With liquid fabric softener dispenser (on some models): Use only liquid fabric softener in water? Without liquid fabric softener dispenser (on some models): In the final rinse only, add fabric softener that require cold water rinses. Top-load washer Not draining, not spinning out water, wet loads - Washer is not cleaning laundry. Check your loads have a yellow or orange... -
Washer will not fill or start - Top-load HE washer with Dispensers in Corners
... has a circuit breaker tripped? NOTE: Both hot and cold water must be as visible as it , if necessary. If the problem continues to completely open both the hot and cold water faucets turned on the Cycle Control knob properly lined up with a cycle selection. The washer will not start - Wash smaller loads. Cancel the...
Similar Questions
Cold Water Continues To Fill Up Washer, I Have To Turn Water Valve Off
(Posted by Sergehd1 9 years ago)
Maytag Washer Model Mvwc300vw1 How Water Is Used On Super Wash
(Posted by jd1421 12 years ago)