Maytag MHWE200XW Support Question
Maytag MHWE200XW Support Question
Find answers below for this question about Maytag MHWE200XW.Need a Maytag MHWE200XW manual? We have 2 online manuals for this item!
Question posted by stereobumps on June 24th, 2019
Water Sensing
It seems like there is not enough water being used during the wash cycle. How can I tell if the water sensing function is operating properly?
Current Answers
Answer #1: Posted by Odin on June 25th, 2019 5:34 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
See https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Washing-Machine/43-4-875297-/New/Maytag-Washer-fills-slowly-or-will-not-fill-at-all-mhwe200xw00 and note the video.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MHWE200XW Manual Pages
Owners Manual - Page 5
... can be no less than 17 gal. (64 L) per minute.
5 For cabinet installation, with stacked washer and dryer
The dimensions shown are required.
7"
(178 mm)
7"
(178 mm)
9" (229 mm)...25 mm)
27" (686 mm)
(25 mm)
Drain System
The washer can be installed using the standpipe drain system (floor or wall), the laundry tub drain system, or the floor drain system.
Select the drain hose ...
Owners Manual - Page 7
...
Connect the Inlet Hoses
Insert new flat washers (supplied) into hose couplings. Both hoses must be used for relocation by hand until it to work properly. 1. Once the bolt is loose, move it is to be turned on the washer.
2. Damage to the cold water faucet. Firmly seat the washers in the rear panel of the...
Owners Manual - Page 8
... and insert
over drain hose form and snap into
standpipe. Laundry tub drain or standpipe drain
Connect the drain hose form to the washer's cold (C) water faucet. Snap either end of drain hose.
4. Hose should be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. C. Periodically inspect and replace hoses if bulges, kinks...
Owners Manual - Page 9
...Washer Use."
9. Make sure all four feet are in firm contact with the floor, use a level).
The washer should not move the washer out slightly before tipping back. Be sure that both water... A and B.
6.
Level the Washer
Proper foot to side, or diagonally when pushed...laundry tub or standpipe as shown. If the drain hose moves, water may vibrate. Complete Installation
1. Slide the washer...
Owners Manual - Page 10
... loading of all wash cycles except Rinse, Drain & Spin, and Clean Washer with traditional top load machines.
Adaptive Variable Speed Motor
The motor adapts to the load size and to the cycle selected to clean and rinse the clothes. Electronic Controls
Flexible electronic controls are easy to use the minimal amount of water needed for delicate...
Owners Manual - Page 11
...the selected cycle. See "Using the Dispenser."
4. Using the Proper Detergent
Use only High Efficiency detergents.
Using regular detergent will not be fully loaded, but not tightly packed. It may also result in washer errors, longer cycle times, and reduced rinsing performance.
This initial cycle serves to avoid spills. First Wash Cycle Without Laundry
Before washing clothes...
Owners Manual - Page 12
.... HE detergents are diluted and dispensed automatically at the proper time during the wash cycle, making it unnecessary for proper use only powdered detergents in the main wash compartment since liquid detergents may also result in Dispenser Illustration) Add liquid or powdered HE detergent to use the proper dispensers when adding laundry products.
Add no more than the manufacturer...
Owners Manual - Page 13
.... The status light indicates when the door is operating. The washer door unlocks, and items can be added.
2. NOTE: To add garments after the wash cycle has started, if the Add Clothes status light ... door unlocks. NOTE: If the water level or the temperature is over, the wash cycle needs to the washer after the Add Clothes period is too high, the washer will beep. 3. The light will...
Owners Manual - Page 14
...
Soak
0:30
Warm/
No Spin
Cold
Clean Washer with Whites cycle. Simply select your water pressure, water temperature, detergent, and clothes load. NOTE: This cycle only retains the last settings saved and will be changed anytime before START/ PAUSE is especially designed for the selected cycle. Normal
Use this cycle combined with MaxExtract™ spin speed and additional...
Owners Manual - Page 15
...process.
Wash Temp
Each cycle has a preset water temperature setting. Select a water temperature based on fabrics.
This cycle combines fast-speed tumbling, a shortened wash time, and high-speed spin to keep the inside of your wash by selecting the speed you are part of normal washer operation.
Clean Washer with AFFRESH™ cycle
Use the Clean Washer with an empty wash drum...
Owners Manual - Page 16
..., use AFFRESH® washer cleaner tablet
✔
✔
AFFRESH™
or chlorine bleach
16 This option will be difficult to the selected main cycle. Laundry Guide
Refer to warm and provides additional time of medium and high speed tumbling. Controlled Temperature Warm and cold wash temperatures are removing items from prewash into the main wash cycle. Silk...
Owners Manual - Page 17
... rinsing performance. Separate lint-givers (towels, chenille) from washer after the cycle is completed. Unloading ■ Remove clothes from lint-takers (corduroy, synthetics, permanent press). Metal
objects such as infant socks, in a mesh garment bag.
This wash system, along with less water, will likely result in the washer basket for a long time.
■ When unloading...
Owners Manual - Page 18
... Chlorine or Color-Safe Bleach
✔
Stain Removal Guide
Use suggested Wash Cycle
Stain
Power Wash
Use Liquid Chlorine or Color-Safe Bleach
✔
Use suggested Wash Cycle
Power Wash
Ink Blood
Coffee/ Chocolate
✔
Cold or Warm
Normal
✔
Warm
Whites
Heavy Duty
Grass
Tomato Products
Mud
Cosmetics
Warm Heavy Duty
Deodorants
Dirty Motor ...
Owners Manual - Page 19
... to cancel the flashing LED light.
Remove the drawer. 2. NOTE: Do not wash components in combination with several rinse and drain steps to check for proper use.
Cleaning the dispenser drawer
Washer Maintenance Procedure
This washer has a special cycle that all areas under running water. Pull back the seal/bellow to wipe up any clothing or items...
Owners Manual - Page 20
Non-use washer again:
1.
Disconnect water inlet hoses from the drain system and attach to
rear panel clips. 4. Washer must be on a Rinse, Drain & Spin cycle.
2.
Run the washer through the Normal cycle with 1/2 the
manufacturer's recommended amount of time, you will be transported in the upright position. To use or vacation care: Operate your machine must be moved...
Owners Manual - Page 21
... (on a pedestal, the washer must be secured to cancel the cycle. Dilute fabric softener in the back of a cycle.
■ Is HE detergent being pulled through the pump.
no water or insufficient water
supply) Press POWER/CANCEL to the drainpipe or laundry tub. As with the floor. You may hear air being used?
If the problem remains...
Owners Manual - Page 22
....
■ Is there water in the same wash cycle repeatedly? Add powdered or liquid color-safe bleach to the washer and make sure water supply hoses are fully open the water faucets.
■ Are both the hot and cold water faucets turned on water, and check for details.
■ Are the laundry products in this washer. Washer odor ■ See "Cleaning...
Owners Manual - Page 23
... an imbalance routine will see little or no water splashing in this cycle, wash time will add time to evenly distribute your garments without increasing cycle times. Spin time is added if an unbalanced...sort properly? Add items or try again.
■ Did you wash a large load on the Small Load cycle?
For best results, add detergent to the washer drum.
■ Did you use the right cycle ...
Owners Manual - Page 24
...connected to provide a hot water wash.
■ Are you using liquid detergent.
■ Did you use a fabric softener dispensing ball? Consider using a low speed wash cycle? Use the Delicate cycle or another cycle with this washer. Wash water colder than 60°F (15.6°C)? For best results, use warm or hot wash water.
■ Are the hot and cold water hoses reversed? If safe...
Energy Guide - Page 1
... water heater)
Your cost will depend on your utility rates and use.
• Cost range based only on standard capacity models. • Estimated operating cost based on eight wash loads a week and a 2007
national average electricity cost of 10.65 cents per kWh and natural gas cost of this label before consumer purchase. U.S.
Clothes Washer...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Turnng the Ice Maker On/Off
...) position. NOTE: Your ice maker has an automatic shutoff. Do not use anything on the top right-hand side of the water supplied to your ice will remain in the ON (left ) position. ... will automatically stop ice production, but the control will be avoided, make sure the water softener is operating properly and is located on top of the ice maker and lead to poor quality ice. ... -
Washer will not fill or start - Top-load HE washer with Dispensers in Corners
... how your Bravos washer functions. Check electrical source or call an electrician. Does the water level seem too low, or does the washer appear to drain the load. Turn off throughout the wash. The following illustrates how your Bravos Why is normal and necessary for the load size. The washer will not properly operate with a cycle? The washer lid... -
The cycle time is not correct - Front-load washer
... able to spin out water. wet loads - The cycle time is HE High Efficiency detergent the only type of detergent to use in my washer? Front-load washer Why is revising the Estimated Time Remaining. On some models) cycles, wash small loads to provide your washer may occur several attempts to redistribute the laundry load in...
Similar Questions
Maytag Model Mhwe200xw Cold Water Continues To Fill Up Washer, It Will Not Stop
Filling, We Had To Turn Cold Water Valve Off. It Will Keep Filling And Overflow Out Onto Floor. Than...
Filling, We Had To Turn Cold Water Valve Off. It Will Keep Filling And Overflow Out Onto Floor. Than...
(Posted by Sergehd1 9 years ago)
Cold Water Continues To Fill Up Washer, I Have To Turn Water Valve Off
(Posted by Sergehd1 9 years ago)
Maytag Neptune 1998 Neptune Washer Won't Advance To Wash Cycle
(Posted by dixTamm 10 years ago)
What Is It When My Maytag Washer Stops Working After The Wash Cycle
(Posted by WoKC75 10 years ago)
Why Does Washer Leak Some Water During Soak Mode. Washer Was Bought 3-28-2011
Why does water leak during SOAK MODE washer was bought 3-28-2011 bearly a year old.. There was no cl...
Why does water leak during SOAK MODE washer was bought 3-28-2011 bearly a year old.. There was no cl...
(Posted by smrtlx 11 years ago)