Maytag MEDZ600TW Support Question
Maytag MEDZ600TW Support Question
Find answers below for this question about Maytag MEDZ600TW - 27" Front-Load Electric Dryer.Need a Maytag MEDZ600TW manual? We have 1 online manual for this item!
Current Answers
Answer #1: Posted by Odin on November 1st, 2018 9:15 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,660
Member since:
April 10th, 2010 Points: 41,236,660
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MEDZ600TW Manual Pages
Use and Care Guide - Page 3
... safety and the safety of fire, electric shock, or injury to persons when using the dryer.
■ Do not place items exposed to cooking oils in your ... contribute to a chemical reaction that could cause a load to catch fire.
■ Do not dry articles that could ignite or explode.
■ Do not allow children to play on your dryer. IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk...
Use and Care Guide - Page 4
... pedestal?
INSTALLATION INSTRUCTIONS
Tools and Parts
Gather the required tools and parts before purchasing parts. Optional Pedestal
Are you placing the dryer on a pedestal.
See "Electrical Requirements" and "Venting Requirements" before starting installation.
Pedestal Height
Color
Part Number
10" (25.4 cm)
White
MHP1000SQ
10" (25.4 cm)
Black
MHP1000SB
15.5" (39.4 cm)
White...
Use and Care Guide - Page 5
... in death, explosion, or fire. Failure to place the dryer at least 18 inches (46 cm) above the floor. If using a power supply cord, a grounded electrical outlet located within 2 ft
(61 cm) of either side of the dryer. WARNING
Location Requirements
Dryer Dimensions
50" (128.27 cm)
Explosion Hazard
Keep flammable materials and vapors, such...
Use and Care Guide - Page 6
....7 cm) (72.77 cm) (2.5 cm) (2.5 cm)(68.6 cm) (2.5 cm)
*Required spacing **For side or bottom venting, 0" (0 cm) spacing is allowed. Dryer only
27" (68.6 cm)
1"* (2.5 cm)
14" max.* (35.6 cm)
18" min.* (45.72 cm)
48 in.2* (310 cm2)
3"* (7.6 cm)
24 in the top of the
cabinet are ...
Use and Care Guide - Page 7
...the appliance is manufactured ready to install with a 3-wire electrical supply connection. If the dryer is your dryer, you must be obtained from the external ground connector (... that a qualified electrician determine that the electrical connection is adequate and in .2 * (155 cm2)
3"* (7.6 cm)
1"* (2.5 cm)
6"* (15.2 cm)
72" (182.9 cm)
5 14 cm)
1" (2.5 cm)
27" (68.6 cm)
1" (2.5 cm...
Use and Care Guide - Page 8
...). ■ At least 5 ft (1.52 m) long. GROUNDING INSTRUCTIONS
■ For a grounded, cord-connected dryer: This dryer must be identified by providing a path of NEMA Type 10-30R.
Do not modify the plug on the dryer.
WARNING: Improper connection of electric shock. All current-carrying wires must be run with the circuit conductors and connected...
Use and Care Guide - Page 9
...; Do not use Power Supply Cord Replacement Part Number 9831317. For further information, please reference the service numbers located in conformance with the dryer: if it is recommended that the electrical connection is equipped with a cord having an equipmentgrounding conductor and a grounding plug.
Do not modify the plug provided with the Canadian...
Use and Care Guide - Page 11
... circuit breaker box*
4-wire connection: Direct Wire
A UL listed, 120/240volt minimum, 30-amp, dryer power supply cord*
3-wire connection: Power supply cord
3-wire direct
A fused disconnect or circuit breaker ...
3¹⁄₂" (8.9 cm)
*If local codes do not permit the connection of electrical connection: 4-wire (recommended) 3-wire (if 4-wire is inside the terminal block opening ....
Use and Care Guide - Page 12
...wire connections. Ground prong D. Ring terminals
1. Ground wire (green or bare) of dryer rear panel. B
D
E
A. Insert tab of terminal block cover into slot of...supply cord C 1.9 cm) UL listed strain relief D. Direct wire cable must have completed your electrical connection. Tighten screw. Connect the other wires to external ground conductor screw. B. Neutral wire (white...
Use and Care Guide - Page 22
... following :
■ There may notice an odor when the dryer is first used. Check that both fuses are now installed. When the dryer has been running or "On" position.
■ Start button has been pushed firmly.
■ Dryer is plugged into an outlet and/or electrical supply is on power.
6. Check that all parts are intact...
Use and Care Guide - Page 23
...persons, read the IMPORTANT SAFETY INSTRUCTIONS before each load. WARNING: To reduce the risk of fire, electric shock, or injury to follow these instructions can... result in death or fire. See "Cleaning the Lint Screen." 2. Fire Hazard
No washer can result in death, explosion, or fire. DRYER USE
WARNING
Starting Your Dryer...
Use and Care Guide - Page 24
... time and enhances fabric care. If desired, you may automatically vary from where the cycle was interrupted if you want the load. Press and hold CYCLE SIGNAL button for approximately 1 second until dryer starts.
To restart the dryer Close the door. If the cycle is displayed.
The CONTROLS LOCKED icon lights up or down arrow...
Use and Care Guide - Page 25
...Cycles Preset Settings chart (in an Sensor Dry Cycle when the laundry is determined by pressing TEMPERATURE until the cycle is started or the door is especially important for permanent press, knits, and..., remove the load from the dryer as soon as tumbling stops.
Adjust the temperature of the cycle. NOTE: You cannot use the Timed Dry Cycle Adjust Up or Down arrow buttons and you wish...
Use and Care Guide - Page 26
...the actual time remaining in the dryer too long.
26
A sensor detects the moisture in the cycle by pressing the Timed Dry Cycle Adjust Up or Down arrow buttons. Timed Dry Cycles
Use Timed... or the Timed Dry Cycles Preset Settings chart. You can change the actual time in the load and automatically adjusts the drying time for drying synthetic fabrics, washable knit fabrics and noiron finishes....
Use and Care Guide - Page 27
... ■ Dry item completely.
The dryer starts at the end of selecting the cycle, the dryer automatically shuts off . Promptly removing clothes at the end of Load
Time* (Minutes)
Foam rubber -
This...for 90 minutes.
■ Press WRINKLE PREVENT to get up to turn the signal off .
27 pillows, padded bras, stuffed toys
20 - 30
Plastic -
Changing Cycles, Options and Modifiers
You...
Use and Care Guide - Page 28
... to purchase one for normal tumbling. You may be rack dried and the suggested temperature setting and drying time. Dryer rack front edge B. Press and hold ) START button (about 3 seconds). Put the wet items on front edge of the rack.
4.
NOTE: Do not allow items to continue the cycle. Do not use the...
Use and Care Guide - Page 29
...laundry detergent and very warm water. 2. Make a paste with a clean towel. OR Apply a liquid, nonflammable household cleaner to remove lint. Cleaning should be done by lint can result in the door opening of clean cloths or towels to remove.
2. DRYER CARE
Cleaning the Dryer Location
Keep dryer... the screen with your dryer and will not stain future loads of combustion and ventilation ...
Use and Care Guide - Page 30
... sound during the first few minutes of operation.
■ Is a coin, button, or paper clip caught between the drum and front or rear of time, you may be 2 fuses or circuit breakers for 1 second. If the problem continues, call an electrician.
Electric dryers use ? If the problem continues, call an electrician.
■ Is...
Use and Care Guide - Page 31
... ending early? Select the right temperature for the types of the dryer requires 5" (12.7 cm). Separate the load to do not feel air movement, clean exhaust system of the door...clothing knotted or balled up , the load will bounce, causing the dryer to restart the dryer.
■ "E" Variable (E1, E2, E3) service codes: Call for 5-10 minutes. Press and hold START to vibrate. When balled up ?...
Use and Care Guide - Page 32
... Drum stains are wrinkled
■ Was the load removed from the area, rewash and dry the clothing.
■ Is the dryer being used ? The new electric heating element may save you can write to build...Customer Assistance toll free: 1-800-688-9900.
■ Features and specifications on load or drum
■ Was dryer fabric softener properly used for the first time? To locate the Maytag®...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Dryer does not heat - Electric dryer
... may not have heat. dryer does not dry Dryer does not heat - Did you recently install a power supply cord on the control knob or button with the Air Fluff...to the dryer. Electric dryer My electric dryer does not heat. Has a household fuse blown or has a circuit breaker tripped? Loads are damp; Gas dryer FAQs Knowledgebase search tips My dryer will not start Damp loads or long... -
Loads are damp; dryer does not dry
...cycle times. Dryer does not heat - Electric Dryer Dryer does not heat - To select a new drying setting, press the Dryness button again until the desired drying setting is running. Dryers There are 3...increase all of your loads on all Automatic Dry or Sensor Dry cycles are damp; Dryer For dryers with digital display - NOTE: Changing this mode. Gas dryer Damp loads or long drying ... -
Dryer does not heat - Gas dryer
... the handle is closed. Expect loads dried with the Air Fluff or Air Only temperature to take longer to dry. Air Fluff or Air Only temperature can be found on the control knob or button with the other temperature selections. Dryer does not heat - Electric dryer The drum of a gas...
Similar Questions
Maytag Front Load Electric Dryer Won't Start
(Posted by nuriterry 9 years ago)
My Maytag Medz600tw-27'front-load Electric Doesn't Heat
where can i locate the heating element,fuses and circuit breakers on the dryer?
where can i locate the heating element,fuses and circuit breakers on the dryer?
(Posted by ridgenelson 10 years ago)
If My Dryer Doesn't Heat Up What's Wrong?
(Posted by Wolf2atonga 10 years ago)
I Have A Maytag Front Loading Electric Dryer Model Med9600 Sq0. When I Attempt T
I have a Maytag front loading electric Dryer model MED9600 SQ0. When I attempt to start it by pressi...
I have a Maytag front loading electric Dryer model MED9600 SQ0. When I attempt to start it by pressi...
(Posted by wrzimmerly 10 years ago)
Dryer Will Not Heat
Dryer will not. Heating element doesn't tern red
Dryer will not. Heating element doesn't tern red
(Posted by Demetriusrector 11 years ago)