Lexmark 16C0365 Support Question
Lexmark 16C0365 Support Question
Find answers below for this question about Lexmark 16C0365 - 5500 MFP.Need a Lexmark 16C0365 manual? We have 3 online manuals for this item!
Question posted by tetran on June 20th, 2015
How Can I Get Service Manual For Office Edge Pro 5500?
how and where can I get SERVICE manual for LEXMARK office edge pro 5500?
Current Answers
Answer #1: Posted by BusterDoogen on June 20th, 2015 8:00 AM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,447
Member since:
October 30th, 2011 Points: 28,565,447
Go here
I hope this is helpful to you!
Please respond to my effort to provide you with the best
possible solution by using the "Acceptable Solution" and/or
the "Helpful" buttons when the answer has proven to be
helpful. Please feel free to submit further info for your question, if a solution
was not provided. I appreciate the opportunity to serve you!
Related Lexmark 16C0365 Manual Pages
Setup Guide - Page 54
... "Attach the cables and power cord" on . • If you are still having problems, contact Lexmark customer support at
http://support.lexmark.com.If you are properly connected.
Make sure the pick pad is latched securely. • Open the... is plugged in and turned on . For more help
Launch the MFP CD, and then click Contact Lexmark for a complete list of
Solve setup problems 50
Setup Guide - Page 63
...sites. If this equipment.
For repair and warranty information, launch the MFP CD, and then click Contact Lexmark for a complete list of the equipment on page 43 in order for...uninterrupted service. If trouble is connected. Telephone companies report that electrical surges, typically lightning transients, are very destructive to customer terminal equipment connected to which this device is...
Service Manual - Page 4
...open sensor 3-28 User interface 3-30 Upper housing 3-32 Flatbed lamp assembly 3-34 Flatbed CCD optical unit 3-36 Multifunction device (MFD) controller card cage 3-38 Hard disk drive, MFD controller card, power distribution card, memory DIMM, and ...6-1 Assembly 1: Upper Scanner 6-2 Assembly 2: Lower scanner 6-4 Assembly 3: Miscellaneous 6-6
Index I-1
Part number index I-5
iv Service Manual
Service Manual - Page 8
... for individual FRUs. Definitions
Note: A note provides additional information. 4036-402
Preface
This manual contains maintenance procedures for service personnel. viii Service Manual
Diagnostic information contains an error indicator table, symptom tables, and service checks
used to isolate failing field replaceable units (FRUs).
3. Preventive maintenance contains the lubrication...
Service Manual - Page 10
... calibration sheet that is included with certain FRUs and must be ordered separately.
1-2 Service Manual
Name Flathead screwdriver Phillips screwdriver (magnetic) Nut driver Digital voltmeter Chip puller
Description Idler..., M4 6 mm With 0.01 V range Puller for the maintenance of this manual thoroughly to drop small parts or screws inside the unit when disassembling and
reassembling....
Service Manual - Page 12
...block diagram.
1-4 Service Manual The MFD controller cage includes a MFD controller card to the entire scanner system. 4036-402
Theory of operation System description
The Lexmark X5500 is a ... all jobs performed on the X5500 and communicates with a touch screen panel and a multifunction device controller cage located within the base of the scanner. The major system components include a...
Service Manual - Page 14
4036-402
Acronyms
ADF CCD CCFL CDB DMM LED MFD PCBA SCSI UI
Auto Document Feeder Charge-Coupled Device Cold Cathode Fluorescent Lamp Command Data Blocks Digital Multimeter Light Emitting Diode Multifunction Device Printed Circuit Board Assembly Small Computer System Interface User Interface
1-6 Service Manual
Service Manual - Page 16
...tables to the user interface touch screen along the rear edge of the scanner. PCI Bus failure
2
Error: 23 - Internal Scanner 2 Card Failure
2-2 Service Manual
Action
Modem on = , off= )
Error: ...Error codes
MFD controller errors
MFD controller errors are errors detected by the MFD (multifunction device) controller card within the MFD cage pertaining to be produced three times. During ...
Service Manual - Page 18
When these errors occur, the user interface touch screen posts 1900 Service Error along with a number of flashes of the flatbed CCD lamp....
Check the ADF cover open . Scanner communication error. If the problem persists, replace the ADF assembly.
2-4 Service Manual Please verify that the flatbed is from under the ADF assembly. Replace the main scanner card. Replace any defective parts...
Service Manual - Page 20
... connection failure
None
Visual check
Connect the connector.
Connect the connector. Connect the connector.
4036-402
Symptoms and service checks
The tables in this section provide detailed troubleshooting information.
The power does not come on
Cause
Relevant unit
Check...
Power supply fails. To do a visual check, observe the part. Replace the power supply.
2-6 Service Manual
Service Manual - Page 22
... the carrier motor. Replace CCD optical unit. Replace the flatbed optical unit. Replace the flatbed optical unit cable. Clean the flatbed glass with isopropyl alcohol.
2-8 Service Manual Clean the mirrors with isopropyl alcohol.
Service Manual - Page 24
Then carefully pull out the jam.
3. Make sure the cover is closed securely.
2-10 Service Manual
Close the document cover. 4. If you cannot remove the jam, open the cover.
2. Close the automatic document feeder. Carefully pull out the jam. Press the ...
Service Manual - Page 26
...the Scanner menu. 4. Select Scan Calibration from the main SE menu. 3. The calibration sheet is oriented with the leading edge band to the left, as shown. Carefully follow the steps to calibrate the grayscale adjustments in the scanner. The process must...document cover.
5. Use this process to perform the calibration. Press Start. Remove the sheet from the glass.
3-2 Service Manual
Service Manual - Page 28
... the refresh procedure is automatically restarted the next time the device is in case the software on the primary partition from ...8226; Using the MFP's Web page • Using FTP • Local attach via USB or Parallel connection
3-4 Service Manual 4036-402
Hard... about the software update. Code update procedure
Occasionally, Lexmark may be obtained from one of the following message ...
Service Manual - Page 30
Disconnect the ADF to flatbed cable from the flatbed.
2. Remove the two thumb screws that secure the hinges.
3-6 Service Manual 4036-402
ADF assembly
1.
Service Manual - Page 32
LIft the upper cover away from the hinge.
3-8 Service Manual 4036-402
ADF upper cover
1. Remove the two screws.
3. Open the ADF. 2.
Service Manual - Page 62
Place the flatbed upside down and remove the eight screws (A) from the bottom housing.
3-38 Service Manual Multifunction device (MFD) controller card cage
CAUTION: Controller cage edges are sharp.
1. Note: After installing a new optical unit, perform the "Scanner calibration" on page 3-6 2. Remove the ADF assembly. 4036-402
Installation note
When you reinstall ...
Service Manual - Page 65
... positioned upside down near the edge of a table, remove the
two screws (A) from the backside and the three screws (B) from the cage. Turn the MFD controller card upright and lift the upper shield from the bottom.
3. Repair information 3-41 Remove the MFD controller card cage. See "Multifunction device (MFD) controller card
cage" on...
Service Manual - Page 66
Remove the MFD controller card cage.
Remove the five cables connected to the main scanner card.
3-42 Service Manual Main scanner card
1. Remove the component you want from within the MFD card cage. "Multifunction device (MFD) controller card cage" on
page 3-38.
2. 4036-402
4.
Service Manual - Page 84
...
location 3-42, 4-2 parts catalog 6-5 removal 3-41 MFD controller card location 3-42, 4-2 parts catalog 6-5 removal 3-41 moving the flatbed 5-3 multifunction device (MFD) controller card cage 3-38
O
operator panel, see user interface overview 1-1
P
packaging 6-6 pad, ADF pick, removal 3-24 paper input... internal ADF CCD subassembly 3-20 main scanner card 3-42 memory DIMM 3-41
I-2 Service Manual
Similar Questions
Lexmark X862 Service Manual
Is the Lexmark W820 service manual compatible with the Lewxmark X862 printer?
Is the Lexmark W820 service manual compatible with the Lewxmark X862 printer?
(Posted by kbat337 10 years ago)
Service Manual
Where can I download a service manual for a Lexmark X4270? Thanks.
Where can I download a service manual for a Lexmark X4270? Thanks.
(Posted by kevinjackson1 11 years ago)