Kenwood KDC-X797 Support Question
Find answers below for this question about Kenwood KDC-X797.Need a Kenwood KDC-X797 manual? We have 1 online manual for this item!
Question posted by kevingunther1996 on August 25th, 2023
Only Two Speakers Work When Hooked Up To Bluetooth
Current Answers
Answer #1: Posted by SonuKumar on August 26th, 2023 10:40 AM
If you are comfortable working with wiring, you can try to fix the problem yourself. Here are the steps involved:
Locate the wiring to the rear speakers. This is usually found behind the head unit or in the trunk.
Disconnect the wiring from the head unit.
Carefully inspect the wiring for any damage.
If there is any damage, repair or replace the wire.
Reconnect the wiring to the head unit.
Test the speakers to make sure that they are working properly.
If you are not comfortable working with wiring, you can take your car to a qualified mechanic or car audio installer. They will be able to fix the problem for you.
Here are some other things to check:
Make sure that the rear speakers are turned on.
Make sure that the volume of the rear speakers is not turned down.
Make sure that the Bluetooth connection is strong.
Try restarting your car and your phone.
If you have tried all of these things and the rear speakers are still not working, then the problem is likely with the wiring. You will need to have the wiring repaired or replaced.
I hope this helps!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Kenwood KDC-X797 Manual Pages
Similar Questions
I installed the Kenwood Excelon KDC X797 in my 1996 Mercedes SL 500 and after shutting down the moto...
Just bought a brand new kenwood excelon x797. Brand new kenwood 4" 4ohm 140w. 3way speakers. When I ...