Kenwood KDC-152 Support Question
Kenwood KDC-152 Support Question
Find answers below for this question about Kenwood KDC-152.Need a Kenwood KDC-152 manual? We have 2 online manuals for this item!
Question posted by rajabig on July 26th, 2014
How To Set The Clock On A Kenwood Kdc-152 Cd Player
The person who posted this question about this Kenwood product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Kenwood KDC-152 Manual Pages
Instruction Manual - Page 1
...Kenwood dealer for information or service on the warranty card, and in the spaces designated on the product. Refer to read through this instruction manual. For your records
Record the serial number, found on the back of the unit, in the space provided below. KDC-152
CD...-RECEIVER
INSTRUCTION MANUAL
AMPLI-TUNER LECTEUR DE CD
MODE D'EMPLOI
REPRODUCTOR DE ...
Instruction Manual - Page 2
... experience problems during installation, consult your Kenwood dealer to make sure that you can only play the CDs with the volume too high may collect...6
Canceling the display demonstration Setting the demonstration mode Adjusting the clock Initial settings before operations
Listening to the radio
7
Adjust [SETTINGS] mode settings
Listening to a disc
8...audio files are used to know...
Instruction Manual - Page 3
...unit returns to your disc writing software, and your disc recorder instruction manual.) 3-inch CD cannot be exposed to operate properly, press the reset button. You cannot play a Recordable/... replaced. To prevent deterioration, do not touch the terminals of used .
Caution: Do not set the remote control in California USA "Perchlorate Material-special handling may apply, See www.dtsc.ca...
Instruction Manual - Page 5
... return to the previous item. Muting upon the reception of a disc.
-
AUD Enters [AUDIO CTRL] settings directly.
- "CALL" disappear and the audio system resumes. Selects the next/previous folder. (Pressing BAND on the main unit can only... accessory. (page 13)
When a call comes in clock display screen.
-
"CD" is selectable only
when a disc is ready, playback also starts.
Instruction Manual - Page 6
...demonstration starts if no external component is connected). Press 4 / ¢ to move between audio file disc and music CD. ; 2: Forces to play as the initial setup.
2 Press the volume knob again to... [SETTINGS], then press to enter.
3 Turn the volume knob to select [CLOCK], then press to enter.
4 Press the volume knob to select [CLOCK ADJ], then press to enter minute adjustment.
Clock hour...
Instruction Manual - Page 7
...- : Selects band.
4 / ¢ (+) : Selects station.
1 - 6
: Selects preset station.
7 Adjust [SETTINGS] mode settings
While listening to the radio... 1 Press the volume knob to enter [FUNCTION] mode. 2 Turn the volume knob to select... [SETTINGS], then press to enter. 3 Turn the volume knob to make a selection, then press...
Instruction Manual - Page 8
... OFF
Selecting Random Play Press number button 3 (ALL RDM) repeatedly to the previous folder, press .
Audio CD : DISC RANDOM, RANDOM OFF MP3/WMA : FOLD (folder) RANDOM,
ALL RANDOM, RANDOM OFF Press and...
To return to fast-forwards/reverses.
Hold to the root folder (or first track for audio CD), press BAND. Selecting a folder/track/file 1 Press to select track/file. "SEARCH" ...
Instruction Manual - Page 9
...8734; : Selects folders/files.
: Returns to enter Direct Music Search Mode. Although the audio files are complied with the standards listed above, the play maybe impossible depending on the ... is selected for the music.
Portable audio device (optional accessory)
9
About Audio file Playable Audio file: MP3 (.mp3), WMA (.wma) Playable disc media: CD-R/RW/ROM Playable disc file format: ...
Instruction Manual - Page 10
...SETTINGS]
Item
Selectable setting (Preset: *)
AUX NAME AUX*/ DVD/ PORTABLE/ GAME/ VIDEO/ TV: Selects the desired name for selection. Function settings
1 Press the volume knob to enter [FUNCTION] mode. 2 Turn the volume knob to select [AUDIO CTRL] or [SETTINGS... is selected as the source.)
CLOCK
CLOCK ADJ: (For details, see page 6.)
DISPLAY DIMMER SET: ON: Dims the display illumination...
Instruction Manual - Page 11
... center.
"NA FILE" appears. "TOC ERROR" appears. Connect the antenna firmly. The CD player is caused by how the tracks are covered with the component which you have intended them ... connections. Reinsert the disc properly.
CD-R/CD-RW cannot be played back and tracks cannot be heard. Check to be done. The unit is playing an unsupported audio file. "PROTECT" appears and no...
Instruction Manual - Page 12
... ground. Always connect those wires to which they correspond. Use only the screws provided. Make sure the faceplate will not hit the lid of your Kenwood dealer.
12 If you connect the ignition wire to a power source with a constant voltage supply, as the heat sink and enclosure become hot. The unit...
Instruction Manual - Page 15
...177;3 dB): 30 Hz - 15 kHz Signal-to-Noise ratio (MONO): 63 dB Stereo separation (1 kHz): 40 dB
Audio section
Maximum output power: 50 W × 4 Full bandwidth power (at less than 1 % THD):
22 W ×...dB): 20 Hz - 20 kHz Input maximum voltage: 1 200 mV Input impedance: 10 kΩ
CD player section
Laser diode: GaAIAs Digital filter (D/A): 8 Times Over Sampling D/A converter: 24 Bit Spindle speed:...
Owners Manual - Page 1
... and operation procedures will help you call upon your Kenwood dealer for information or service on the warranty card, and in the space provided below.
Refer to read through this instruction manual. Model KDC-152 Serial number KDC-152
CD-RECEIVER
INSTRUCTION MANUAL
AMPLI-TUNER LECTEUR DE CD
MODE D'EMPLOI
REPRODUCTOR DE DISCOS COMPACTOS RECEPTOR DE FM...
Owners Manual - Page 2
... and notes about the playable audio files are stated in this case, ...kenwood.com/cs/ce/audiofile/
2 CONTENTS
Safety
Safety
2
Preparation
3
How to attach/detach the faceplate How to reset your unit How to prepare the remote controller
(RC-405)
Basic operations
4
Getting started
6
Canceling the display demonstration Setting the demonstration mode Adjusting the clock Initial settings...
Owners Manual - Page 3
...1
CALIFORNIA, USA ONLY This perchlorate WARNING applies only to your disc writing software, and your disc recorder instruction manual.) 3-inch CD cannot be exposed to prepare the remote controller (RC-405) When you use . If swallowed contact physician immediately.
3 The ... cannot be damaged by shocks or jolts. Attempt to factory settings when the reset button is incorrectly replaced.
Owners Manual - Page 5
... will also exit from setting mode. Enters [FUNCTION] settings. Fast-forwards/reverses tracks if pressed and held while in , "CALL" appears.
Returns to your telephone using a commercial telephone accessory. (page 13)
When a call , press SRC. ATT
Attenuates the sound. • To return to the audio system during a call comes in clock display screen.
- ENGLISH...
Owners Manual - Page 6
...Press the volume knob to enter
[FUNCTION] mode. 3 Turn the volume knob to select
[INITIAL SET], then press to enter. 4 Turn the volume knob to make a
selection, then press to ...to move between audio file disc and music CD. ; 2: Forces to play as a music CD. SP SELECT OFF*/ 5/4/ 6 × 9/6/ OEM: Selects the speaker size for selection. 5 Hold to finish the procedure.
Clock minutes flashes on...
Owners Manual - Page 10
... if [SUB-W SET] is selected as the source.)
CLOCK
CLOCK ADJ: (For details, see page 6.)
DISPLAY DIMMER SET: ON: Dims the display illumination. ; TEXT SCROLL: AUTO*/ ONCE: Selects to the subwoofer. ; 85HZ/ 120HZ/ 160HZ: Frequencies higher than [THROUGH] is selected/activated. DETAIL SET LPF SUB-W: THROUGH*: All signals are lost in MP3/WMA audio compression. ; OFF...
Owners Manual - Page 11
...appears.
If "PROTECT" does not disappear, consult your nearest service center.
The CD player is scratched a lot. If the condition did not improve, turn on rough roads. Change the disc. .... Remedy/Cause Adjust the volume to the radio. Playback order is playing an unsupported audio file. Connect the antenna firmly.
The connectors are recorded. Stop playback while driving on .
Skip...
Owners Manual - Page 15
KENWOOD STEREOS...;3 dB): 30 Hz - 15 kHz Signal-to-Noise ratio (MONO): 63 dB Stereo separation (1 kHz): 40 dB
Audio section
Maximum output power: 50 W × 4 Full bandwidth power (at less than 1 % THD):
22 W ... 20 Hz - 20 kHz Input maximum voltage: 1 200 mV Input impedance: 10 kΩ
CD player section
Laser diode: GaAIAs Digital filter (D/A): 8 Times Over Sampling D/A converter: 24 Bit Spindle ...
Similar Questions
I Have A Kenwood Kdc-248u Cd Player With Error 99
(Posted by rpaxton1994 2 years ago)
Cd Player Resetting Itself
why does my kenwood kdc-152 keep resetting itself when i get to volume level 20? it just started doi...
why does my kenwood kdc-152 keep resetting itself when i get to volume level 20? it just started doi...
(Posted by mikesmith8582 10 years ago)
Kenwood Kdc -152
installed brand new and the face plate doesnt turn on , you can hear the cd player cut on and spin r...
installed brand new and the face plate doesnt turn on , you can hear the cd player cut on and spin r...
(Posted by mycadisondubs 11 years ago)