Kenmore 7560 Support Question
Kenmore 7560 Support Question
Find answers below for this question about Kenmore 7560 - Elite 40 in. Dual Fuel Range.Need a Kenmore 7560 manual? We have 2 online manuals for this item!
Question posted by ernesttobuedo on November 20th, 2010
Plastic Warped On Upright Panel Melted Wrinkled Above Rear Burners
sears just giving usual run around claims I caused it..............
Current Answers
Related Kenmore 7560 Manual Pages
Installation Instructions - Page 1
...Fuel Type Before Proceeding: Your range is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. PIN 316259314 (0112)
EspaSoI-Paginas9-16 FOR YOUR SAFETY:
= Do not store or use any electrical switch; RANGE...Side of Range
Above 36" Height. * Note: 3"
Clearance
if Equipped
2"
with 11000 or
greater BTU Burners.
30" Minimum
e ALL RANGES CAN TiP...
Installation Instructions - Page 2
...installing the range in serious injuries and can also cause damage to the range.
=...range without shrinking, warping or discoloring. When installed in operation. Prolonged use the oven as they may become hot while the oven is in a manufactured (mobile) home, installation must conform with the National Fuel Gas Code ANSI Z223.1--1atest edition when installed in the cabinets above the burners...
Installation Instructions - Page 3
...range. Before Starting
Tools You Will Need For leveling legs and Anti-Tip Bracket:
Adjustable wrench or channel lock pliers
• 5/16" NutdrJver or Flat Head Screw Driver _J Electric Drill & 1/8" Diameter Drill Bit (5/32" Masonry Drill Bit if installing in concrete)
For gas supply connection: = Pipe wrench
For burner... the rear of the range will be located. A. If rear of range is further...
Installation Instructions - Page 4
...Note: A minim um clearance of range not to check your adjustments. For models with a warmer drawer or broiler compartment, grasp the top rear edge of the range and carefully attempt to the regulator ...LP kit can be no more than 14 inches of the range. Do not allow room for the bracket. Level range by removing lower panel or storage drawer. Examples: If regulator is installed.
2. ...
Installation Instructions - Page 5
... a liquid leak detector at least two (2) other pressure device to the top burner right rear orifice. e) Attach appliance conduit to flare union on to the rangeand
use an... flare union adapter to or less than the branch circuit rating. Checking Manifold Gas Pressure Disconnect the range and its individual manual shut-off the gas supply to minimize the possibility of water column pressure (...
Installation Instructions - Page 6
... gas is equipped with any combination of Surface Burners
6.
Removable Burner
Drip Pan (on all four surface burner locations: 1st - Operation of the sealed burners. Installation of Surface Burner Caps
Your range is available to find your surface burner and surface burner cap configuration. Be sureto place the correct burner cap at all four surface burners.
.... _ii
ii i_...... _ii...
Installation Instructions - Page 7
... valve will open and flame will also have been carefully checked for leaks and range has been connected to cycle once. Turn counterclockwise to decrease flame size. Check ...at rear, disengage front of oven bottom from LITE to bake at rear of Surface Burner Valve (Linear Flow Valves Only):
%
To Surface Burner
Test to operate.
b) Within 60 seconds the oven burner should...
Installation Instructions - Page 8
... tollfree service number and address. To determine if the broil burner flame is complete, make sure all controls are not the result of fuel and the pressure the range was adjusted for proper anchoring instructions.
It may save you the rating of the burners, the type of defective workmanship or materials in illustration above...
Use and Care Guide - Page 3
...range must be done only by a qualified technician in serious injuries and also cause damage to heat or warm the room. Important Safety Instructions
Read all instructions before using this or any other appliance.
-- All safety messages will identify the hazard, tell you how to reach items could
packed with the National Fuel... climbing on or near surface burners or in the manuals. Doing...
Use and Care Guide - Page 4
... and after use aluminum foil to line
oven bottom or any unused range if it does not extend beyond the edge of the utensil. Fat... ignition of sealed gas burners.
The handle of the utensil should be positioned so that has boiled dry may become hot and possibly melt. Check the manufacturer's recommendations for at high heat settings--Boilovers cause smoking and greasy spillovers ...
Use and Care Guide - Page 5
... not place plastic or heat-sensitive items on the serial plate. Do not allow dripping fat to the side of the range when opening... publish a list of substances known to the state to cause cancer, birth defects or other reproductive harm, and requires ...
Serial Plate Location
You will change if left in the fan could melt or ignite.
• Placement of the broiler.
• Do not...
Use and Care Guide - Page 7
...pitting). A poor heat conductor however will cause it to the above ). Cooks evenly ... for
flatness by more than one burner because it may leave metal marks ...8226; Flat bottom and straight sides.
• Curved and warped pan bottoms
u
• Tight fitting lids.
•...scratches. Excellent heat conductor.
Gas)
This natural gas range is located on METAL -
Figure 2
* Specialty...
Use and Care Guide - Page 9
...grate.
The Wok Stand provided with your cooktop
without the Wok Stand. DO NOT use the rear burner next to Wok stand when it is designed to allow only round-bottomed woks up to 14 ... used on either of the grate. Because this ring traps heat, the burner and cooktop surface could be used on your range is equipped with a metal ring that cannot withstand high heat such as ...
Use and Care Guide - Page 10
... it will light. If the burner does not light, contact a Sears Service Center.
Alignment fork Cen_r
Alignment Finger
Gas Orifice
Electrode ...rear burners.
Align the tips under each center of Burner Bases and Caps Place the burner base over each of the burner. This burner is located at the left and right front positions on each Burner has a inner locating ring
which locates the burner...
Use and Care Guide - Page 11
... event of the OFF position (See Figure 1). 3. Use caution when lighting surface burners manually. Push the surface control knob down and turn knob to adjust the flame ...plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use a thermometer and adjust the surface control knob accordingly. Potholders, towels or wood spoons could melt...
Use and Care Guide - Page 37
...allow food spills with other part of the range, wood or painted surfaces. Doing so will destroy heat distribution, produce poor baking results and cause permanent damage to the oven interior (aluminum... '
ing bulb located at the top left rear corner of the oven; it could affect how the oven bakes. A change in its position could cause
a short circuit and result in the oven ...
Use and Care Guide - Page 38
... leaves a protective finish on the cooktop which can cause metal markings on soil: First, clean the surface as described... cooktop surface. Damage to clean the entire cooktop surface. Plastic or foods with rough bottoms can leave soil or lint... cooking. These marks should be removed immediately if spilled or melted onto the ceramic cooktop surface.
Do not slide anything metal ...
Use and Care Guide - Page 39
...burner unit.
Keeping the burner...burner cap assembly and ring in place whenever a surface burner is damaged or broken, the surface burner... burner ...burner pan forms a recessed well area located around the burner...burner yourself.
...burners to clean burner...40 minutes. To Clean the Burner Bases and Gas Openings The ports (or slots) around each burner...burner does not light after cleaning, contact a Sears...
Use and Care Guide - Page 40
... may cause damage to rinse the cleaners as Stainless Steel Magic, or other similar cleaners are turned OFF and the range is...gasket is made especially for 30 to the OFF position; Control Panel
Before cleaning the controlpanet, turn to 60 minutes.
Rinse with...control knobs. then push the knob into place.
40 Glass, Paint and Plastic Control Knobs, Body Parts and Decorative Trim
For ...
Use and Care Guide - Page 41
...use the OVEN LIGHT switch located on the control panel. 1. To Replace Storage Drawer: 1. Pull the ... . Align the drawer glides with a new 40 watt appliance bulb. 5.
Flammable materials should not...the glass shield. 4. This includes paper, plastic and cloth items, such as cookbooks, plasticware ... minimize damage to facilitate cleaning under the range. Make sure the hinge supports are COOL...
Similar Questions
Clock And Oven Controls Do Not Work
after a power surge my oven controls and clock do not work but the burners do, what could be the pro...
after a power surge my oven controls and clock do not work but the burners do, what could be the pro...
(Posted by Jtmjr 7 years ago)
Replece 6 Inch Rear Burner Kenmore Elite 790 4670
(Posted by brackenfr 10 years ago)
My Kenmore Front Burner When On High Will Not Go Down When Turned Down Low
Model C806912190 year 1993 4 burner Kenmore electric range
Model C806912190 year 1993 4 burner Kenmore electric range
(Posted by gnjedwards 11 years ago)
Stove Burner
stove burner will start to hum when the stove is turned off. Only way to stop is to turn the burner ...
stove burner will start to hum when the stove is turned off. Only way to stop is to turn the burner ...
(Posted by wuebwessel 11 years ago)
Which Color Orifice Goes On Which Burner
Whick color (pink, brown etc.) goes on which of the five burners
Whick color (pink, brown etc.) goes on which of the five burners
(Posted by susabatt 11 years ago)